Searched full:sideband (Results 1 – 25 of 99) sorted by relevance
1234
| /Linux-v6.1/Documentation/devicetree/bindings/pci/ |
| D | pci-msi.txt | 16 MSIs may be distinguished in part through the use of sideband data accompanying
17 writes. In the case of PCI devices, this sideband data may be derived from the
19 controllers it can address, and the sideband data that will be associated with
53 the root complex and MSI controller do not pass sideband data with MSI
79 * The sideband data provided to the MSI controller is
107 * The sideband data provided to the MSI controller is
136 * The sideband data provided to the MSI controller is
166 * The sideband data provided to the MSI controller is
210 * The sideband data provided to MSI controller a is the
212 * The sideband data provided to MSI controller b is the
|
| D | pci-iommu.txt | 16 IOMMUs may distinguish PCI devices through sideband data derived from the
22 and a mechanism is required to map from a PCI device to its IOMMU and sideband
67 * The sideband data provided to the IOMMU is the RID,
94 * The sideband data provided to the IOMMU is the RID with the
122 * The sideband data provided to the IOMMU is the RID,
163 * a, with sideband data being RID[14:0].
165 * IOMMU b, with sideband data being RID[14:0].
|
| /Linux-v6.1/drivers/net/ethernet/intel/ice/ |
| D | ice_sbq_cmd.h | 7 /* This header file defines the Sideband Queue commands, error codes and
11 /* Sideband Queue command structure and opcodes */
13 /* Sideband Queue commands */
18 /* Sideband Queue descriptor. Indirect command
|
| D | ice_controlq.c | 55 * ice_sb_init_regs - Initialize Sideband registers
662 * ice_is_sbq_supported - is the sideband queue supported
665 * Returns true if the sideband control queue interface is
670 /* The device sideband queue is only supported on devices with the in ice_is_sbq_supported()
677 * ice_get_sbq - returns the right control queue to use for sideband
730 /* Shutdown PHY Sideband */ in ice_shutdown_all_ctrlq()
772 /* sideband control queue (SBQ) interface is not supported on some in ice_init_all_ctrlq()
|
| /Linux-v6.1/drivers/net/wireless/broadcom/brcm80211/include/ |
| D | brcmu_d11.h | 14 * bandwidth and control sideband
31 * bit 8~9 sideband
52 * bit 8~10 sideband
128 * @sb: control sideband (location of control channel against the center one)
|
| /Linux-v6.1/Documentation/admin-guide/hw-vuln/ |
| D | processor_mmio_stale_data.rst | 34 Sideband Stale Data Propagator (SSDP)
36 The sideband stale data propagator (SSDP) is limited to the client (including
37 Intel Xeon server E3) uncore implementation. The sideband response buffer is
38 shared by all client cores. For non-coherent reads that go to sideband
41 the sideband response buffer. As a result, stale data from the sideband
47 Intel Xeon server E3) uncore implementation. Similar to the sideband response
51 similar to the sideband stale data propagator.
123 Shared Buffers Data Read (SBDR) vulnerability or the sideband stale
|
| /Linux-v6.1/Documentation/devicetree/bindings/interrupt-controller/ |
| D | msi.txt | 24 - Sideband information accompanying the write.
47 Typically this will encode information related to sideband data, and will
58 generate, the doorbell and payload may be configured, though sideband
89 /* No sideband data, so #msi-cells omitted */
|
| D | msi-controller.yaml | 22 Typically this will encode information related to sideband data,
|
| /Linux-v6.1/drivers/gpu/drm/i915/ |
| D | vlv_sideband.c | 12 * IOSF sideband, see VLV2_SidebandMsg_HAS.docx and
34 * Prevent the cpu from sleeping while we use this sideband, otherwise in __vlv_punit_get()
41 * to the Valleyview P-unit and not all sideband communications. in __vlv_punit_get()
90 drm_dbg(&i915->drm, "IOSF sideband idle wait (%s) timed out\n", in vlv_sideband_rw()
114 drm_dbg(&i915->drm, "IOSF sideband finish wait (%s) timed out\n", in vlv_sideband_rw()
|
| D | intel_sbi.c | 5 * LPT/WPT IOSF sideband.
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/frequency/ |
| D | adi,adrf6780.yaml | 91 adi,lo-sideband:
93 Switch to the Lower LO Sideband. By default the Upper LO
94 sideband is enabled.
|
| /Linux-v6.1/sound/soc/sof/intel/ |
| D | hda-ipc.h | 16 * - DIPCTDR (HIPCIDR) in sideband IPC (cAVS 1.8+)
20 * - DIPCTDD (HIPCIDD) in sideband IPC (cAVS 1.8+)
|
| /Linux-v6.1/drivers/platform/x86/ |
| D | p2sb.c | 3 * Primary to Sideband (P2SB) bridge access support
79 * p2sb_bar - Get Primary to Sideband (P2SB) bridge device BAR
|
| /Linux-v6.1/drivers/net/ethernet/apm/xgene/ |
| D | xgene_enet_cle.c | 653 /* Sideband: IPV4/TCP packets */ in xgene_cle_set_rss_sband()
658 /* Sideband: IPv4/UDP packets */ in xgene_cle_set_rss_sband()
667 /* Sideband: IPv4/RAW packets */ in xgene_cle_set_rss_sband()
673 /* Sideband: Ethernet II/RAW packets */ in xgene_cle_set_rss_sband()
748 /* setup sideband data */ in xgene_cle_setup_rss()
|
| /Linux-v6.1/net/ncsi/ |
| D | Kconfig | 10 This module provides NCSI (Network Controller Sideband Interface)
|
| /Linux-v6.1/include/linux/platform_data/x86/ |
| D | p2sb.h | 3 * Primary to Sideband (P2SB) bridge access support
|
| /Linux-v6.1/drivers/usb/typec/mux/ |
| D | Kconfig | 11 provides support for muxing analog audio and sideband signals on a
|
| /Linux-v6.1/Documentation/devicetree/bindings/misc/ |
| D | fsl,qoriq-mc.txt | 31 The MSI writes are accompanied by sideband data which is derived from the ICID.
33 controller and the sideband data which accompanies the writes.
|
| /Linux-v6.1/Documentation/networking/device_drivers/ethernet/intel/ |
| D | i40e.rst | 172 Director rule is added from ethtool (Sideband filter), ATR is turned off by the
173 driver. To re-enable ATR, the sideband can be disabled with the ethtool -K
178 If sideband is re-enabled after ATR is re-enabled, ATR remains enabled until a
179 TCP-IP flow is added. When all TCP-IP sideband rules are deleted, ATR is
185 Sideband Perfect Filters
187 Sideband Perfect Filters are used to direct traffic that matches specified
709 Center Bridging (DCB), Multiple Functions per Port (MFP), or Sideband
|
| /Linux-v6.1/Documentation/devicetree/bindings/hwmon/ |
| D | amd,sbrmi.yaml | 8 Sideband Remote Management Interface (SB-RMI) compliant
|
| D | amd,sbtsi.yaml | 8 Sideband interface Temperature Sensor Interface (SB-TSI) compliant
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | sbtsi_temp.rst | 8 * Sideband interface (SBI) Temperature Sensor Interface (SB-TSI)
|
| /Linux-v6.1/drivers/thunderbolt/ |
| D | sb_regs.h | 3 * USB4 port sideband registers found on routers and retimers
|
| /Linux-v6.1/tools/perf/Documentation/ |
| D | perf-intel-pt.txt | 1417 It is possible to use perf record to record sideband events within a virtual machine, so that an In…
1418 Sideband events from the guest perf.data file can be injected into the host perf.data file using pe…
1436 Start perf record to collect sideband events:
1438 …$ sudo perf record -o guest-sideband-testing-guest-perf.data --sample-identifier --buildid-all --s…
1446 $ sudo perf record -o guest-sideband-testing-host-perf.data -m,64M --kcore -a -e intel_pt/cyc/
1461 [ perf record: Captured and wrote 76.122 MB guest-sideband-testing-host-perf.data ]
1469 [ perf record: Captured and wrote 1.247 MB guest-sideband-testing-guest-perf.data ]
1471 And then copy guest-sideband-testing-guest-perf.data to the host (not shown here).
1479 $ perf inject -i guest-sideband-testing-host-perf.data --vm-time-correlation=dry-run
1487 …$ perf inject -i guest-sideband-testing-host-perf.data --vm-time-correlation=0xfffffa6ae070cb20 --…
[all …]
|
| /Linux-v6.1/arch/powerpc/platforms/ |
| D | fsl_uli1575.c | 264 /* Enable sideband interrupt */ in hpcd_quirk_uli1575()
292 * IRQ14 is a sideband interrupt from IDE device to CPU and we use this
|
1234
