| /Linux-v5.10/drivers/staging/iio/cdc/ |
| D | ad7150.c | 179 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_params() local
190 value = chip->threshold[rising][chan]; in ad7150_write_event_params()
195 sens = chip->mag_sensitivity[rising][chan]; in ad7150_write_event_params()
196 timeout = chip->mag_timeout[rising][chan]; in ad7150_write_event_params()
199 sens = chip->thresh_sensitivity[rising][chan]; in ad7150_write_event_params()
200 timeout = chip->thresh_timeout[rising][chan]; in ad7150_write_event_params()
223 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_config() local
243 if (rising) in ad7150_write_event_config()
250 if (rising) in ad7150_write_event_config()
257 if (rising) in ad7150_write_event_config()
[all …]
|
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-timer-stm32 | 37 OC4REF rising or falling edges generate pulses.
39 OC6REF rising or falling edges generate pulses.
41 OC4REF or OC6REF rising edges generate pulses.
43 OC4REF rising or OC6REF falling edges generate
46 OC5REF or OC6REF rising edges generate pulses.
48 OC5REF rising or OC6REF falling edges generate
134 Counting is enabled on rising edge of the connected
151 rising edges.
|
| D | sysfs-bus-iio-lptimer-stm32 | 41 - rising-edge
52 | | signal | Rising | Falling | Rising | Falling |
54 | Rising | High -> | Down | - | Up | - |
|
| D | sysfs-bus-iio-adc-hi8435 | 27 If falling threshold results hysteresis to odd value then rising
36 this value then the threshold rising event is pushed.
47 If rising threshold results hysteresis to odd value then falling
|
| D | sysfs-bus-counter | 117 Rising edges on signal A updates the respective count.
121 If direction is forward, rising edges on quadrature pair
128 If direction is forward, rising edges on quadrature pair
187 rising edge:
|
| /Linux-v5.10/arch/sparc/include/asm/ |
| D | sunbpp.h | 70 #define P_DS_IRQ_EN 0x0200 /* RW Always on rising edge */
71 #define P_ACK_IRQ_EN 0x0100 /* RW Always on rising edge */
72 #define P_BUSY_IRP 0x0080 /* RW 1= rising edge */
74 #define P_PE_IRP 0x0020 /* RW 1= rising edge */
76 #define P_SLCT_IRP 0x0008 /* RW 1= rising edge */
78 #define P_ERR_IRP 0x0002 /* RW1 1= rising edge */
|
| /Linux-v5.10/drivers/staging/comedi/drivers/ |
| D | ni_6527.c | 273 unsigned int rising, in ni6527_set_edge_detection() argument
278 rising &= mask; in ni6527_set_edge_detection()
283 /* preserve rising-edge detection channels */ in ni6527_set_edge_detection()
284 rising |= readb(dev->mmio + in ni6527_set_edge_detection()
292 /* update rising-edge detection channels */ in ni6527_set_edge_detection()
293 writeb(rising & 0xff, in ni6527_set_edge_detection()
299 rising >>= 8; in ni6527_set_edge_detection()
311 unsigned int rising, falling, shift; in ni6527_intr_insn_config() local
318 rising = data[1]; in ni6527_intr_insn_config()
320 ni6527_set_edge_detection(dev, mask, rising, falling); in ni6527_intr_insn_config()
[all …]
|
| /Linux-v5.10/Documentation/driver-api/ |
| D | generic-counter.rst | 71 * Rising Edge:
107 Rising edges on signal A updates the respective count. The input level
115 If direction is forward, rising edges on quadrature pair signal A
121 If direction is forward, rising edges on quadrature pair signal B
145 a counter device which simply accumulates a count of rising edges on a
151 | Data: Count | Rising Edge ________
160 specified by the Synapse -- in this case a rising edge condition on the
163 components: a rising edge condition triggers an increase function on an
184 associated with a single Count: a rising or falling edge on either A or
200 | Data: Position | Rising Edge ___
|
| /Linux-v5.10/Documentation/devicetree/bindings/gpio/ |
| D | gpio-stp-xway.txt | 26 - lantiq,rising : use rising instead of falling edge for the shift register
41 /* lantiq,rising; */
|
| D | cavium-octeon-gpio.txt | 21 1 - edge triggered on the rising edge.
37 * 2) Triggering (1 - edge rising
|
| /Linux-v5.10/Documentation/devicetree/bindings/display/panel/ |
| D | panel-timing.yaml | 173 Data driving on rising or falling edge.
175 sample data on rising edge.
176 Use 1 to drive pixel data on rising edge and
182 Drive sync on rising or sample sync on falling edge.
185 sample sync on rising edge of pixel clock.
186 Use 1 to drive sync on rising edge and
|
| /Linux-v5.10/Documentation/devicetree/bindings/net/nfc/ |
| D | nfcmrvl.txt | 22 - i2c-int-rising: Specifies that the chip read event shall be trigged on
23 rising edge.
55 i2c-int-rising;
|
| /Linux-v5.10/drivers/gpio/ |
| D | gpio-mt7621.c | 37 u32 rising; member
122 mtk_gpio_w32(rg, GPIO_REG_REDGE, rise | (BIT(pin) & rg->rising)); in mediatek_gpio_irq_unmask()
159 if ((rg->rising | rg->falling | in mediatek_gpio_irq_type()
166 rg->rising &= ~mask; in mediatek_gpio_irq_type()
173 rg->rising |= mask; in mediatek_gpio_irq_type()
177 rg->rising |= mask; in mediatek_gpio_irq_type()
|
| /Linux-v5.10/drivers/iio/proximity/ |
| D | ping.c | 58 struct completion rising; member
83 complete(&data->rising); in ping_handle_irq()
107 reinit_completion(&data->rising); in ping_read()
136 /* it should not take more than 20 ms until echo is rising */ in ping_read()
137 ret = wait_for_completion_killable_timeout(&data->rising, HZ/50); in ping_read()
294 init_completion(&data->rising); in ping_probe()
|
| D | srf04.c | 65 struct completion rising; member
87 complete(&data->rising); in srf04_handle_irq()
112 reinit_completion(&data->rising); in srf04_read()
124 /* it should not take more than 20 ms until echo is rising */ in srf04_read()
125 ret = wait_for_completion_killable_timeout(&data->rising, HZ/50); in srf04_read()
265 init_completion(&data->rising); in srf04_probe()
|
| /Linux-v5.10/include/linux/mfd/pcf50633/ |
| D | core.h | 170 PCF50633_INT2_ONKEYR = 0x01, /* ONKEY rising edge */
172 PCF50633_INT2_EXTON1R = 0x04, /* EXTON1 rising edge */
174 PCF50633_INT2_EXTON2R = 0x10, /* EXTON2 rising edge */
176 PCF50633_INT2_EXTON3R = 0x40, /* EXTON3 rising edge */
|
| /Linux-v5.10/drivers/irqchip/ |
| D | qcom-pdc.c | 127 * falling edge into a rising edge and active low into an active high.
131 * Rising edge sensitive NOT USED
136 * Rising edge sensitive HIGH
153 * If @type is edge triggered, forward that as Rising edge as PDC
154 * takes care of converting falling edge to rising edge signal
156 * takes care of converting falling edge to rising edge signal
|
| /Linux-v5.10/Documentation/devicetree/bindings/mmc/ |
| D | mtk-sd.txt | 46 - mediatek,hs400-cmd-resp-sel-rising: HS400 command response sample selection
47 If present,HS400 command responses are sampled on rising edges.
74 mediatek,hs400-cmd-resp-sel-rising;
|
| /Linux-v5.10/include/linux/platform_data/ |
| D | adp5588.h | 61 #define CMP1_LVL2_TRIP 0x33 /* L2 Light Sensor Hysteresis (Active when Output Rising) for Sensor 1 …
63 #define CMP1_LVL3_TRIP 0x35 /* L3 Light Sensor Hysteresis (Active when Output Rising) For Sensor 1 …
66 #define CMP2_LVL2_HYS 0x38 /* L2 Light Sensor Hysteresis (Active when Output Rising) for Sensor 2 */
68 #define CMP2_LVL3_HYS 0x3A /* L3 Light Sensor Hysteresis (Active when Output Rising) For Sensor 2 */
|
| /Linux-v5.10/Documentation/input/devices/ |
| D | rotary-encoder.rst | 12 and by triggering on falling and rising edges, the turn direction can
56 a) Rising edge on channel A, channel B in low state
59 b) Rising edge on channel B, channel A in high state
|
| /Linux-v5.10/drivers/iio/common/st_sensors/ |
| D | st_sensors_trigger.c | 150 …"falling/low specified for IRQ but hardware supports only rising/high: will request rising/high\n"… in st_sensors_allocate_trigger()
168 "interrupts on the rising edge\n"); in st_sensors_allocate_trigger()
177 "unsupported IRQ trigger specified (%lx), enforce rising edge\n", irq_trig); in st_sensors_allocate_trigger()
|
| /Linux-v5.10/drivers/net/dsa/mv88e6xxx/ |
| D | ptp.c | 115 * @rising: zero for falling-edge trigger, else rising-edge trigger
120 int rising) in mv88e6352_config_eventcap() argument
128 if (!rising) in mv88e6352_config_eventcap()
271 int rising = (rq->extts.flags & PTP_RISING_EDGE); in mv88e6352_ptp_enable_extts() local
306 err = mv88e6352_config_eventcap(chip, PTP_CLOCK_EXTTS, rising); in mv88e6352_ptp_enable_extts()
|
| /Linux-v5.10/drivers/media/pci/cobalt/ |
| D | m00233_video_measure_memmap_package.h | 16 /* The vertical counter starts on rising edge of vsync */
21 /* The horizontal counter starts on rising edge of hsync. */
29 /* falling and rising edge of hsync. Must be non-zero. */
|
| /Linux-v5.10/sound/soc/ti/ |
| D | davinci-i2s.c | 307 * 1 - sampled on rising edge of CLKR in davinci_i2s_set_dai_fmt()
308 * valid on rising edge in davinci_i2s_set_dai_fmt()
311 * valid on rising edge in davinci_i2s_set_dai_fmt()
322 * 0 - clocked on rising edge of CLKX in davinci_i2s_set_dai_fmt()
331 * 1 - sampled on rising edge of CLKR in davinci_i2s_set_dai_fmt()
332 * valid on rising edge in davinci_i2s_set_dai_fmt()
335 * valid on rising edge in davinci_i2s_set_dai_fmt()
347 * 0 - clocked on rising edge of CLKX in davinci_i2s_set_dai_fmt()
|
| /Linux-v5.10/drivers/gpu/drm/sti/ |
| D | sti_vtg.c | 110 *@hsync: sample number falling and rising edge
111 *@vsync_line_top: vertical top field line number falling and rising edge
112 *@vsync_line_bot: vertical bottom field line number falling and rising edge
113 *@vsync_off_top: vertical top field sample number rising and falling edge
114 *@vsync_off_bot: vertical bottom field sample number rising and falling edge
|
