Searched full:pxcmd (Results 1 – 5 of 5) sorted by relevance
115 * value before the PxCMD ST write of 0, then restore PxFBS value.138 * bit #15 PxCMD signal doesn't clear PxFBS, in ahci_mvebu_stop_engine()139 * restore the PxFBS register right after clearing the PxCMD ST, in ahci_mvebu_stop_engine()140 * no need to wait for the PxCMD bit #15. in ahci_mvebu_stop_engine()
112 * The software should read and store PxCMD and PxIS values in ahci_qoriq_hardreset()115 * PxCMD and PxIS with the stored values. in ahci_qoriq_hardreset()130 /* restore the PxCMD and PxIS on ls1021 */ in ahci_qoriq_hardreset()
895 /* then set PxCMD.SUD to 0 */ in ahci_power_down()
118 the PxCMD register in case if the system firmware hasn't done it.
371 /* Chip quirk: wait up to 500ms for PxCMD.CR == 0 */ in mtip_restart_port()382 * PxCMD.CR not clear after 500 ms in mtip_restart_port()386 "PxCMD.CR not clear, escalating reset\n"); in mtip_restart_port()
