Searched full:peripherals (Results 1 – 25 of 456) sorted by relevance
12345678910>>...19
| /Linux-v6.6/Documentation/devicetree/bindings/display/ |
| D | mipi-dsi-bus.txt | 5 communication between a host and up to four peripherals. This document will
13 peripherals on that bus.
26 bus. DSI peripherals are addressed using a 2-bit virtual channel number, so
42 Peripherals with DSI as control bus, or no control bus
45 Peripherals with the DSI bus as the primary control bus, or peripherals with
48 DSI peripherals, but individual bindings may want to define additional,
55 Some DSI peripherals respond to more than a single virtual channel. In that
64 Peripherals with a different control bus
67 There are peripherals that have I2C/SPI (or some other non-DSI bus) as the
69 path). Connections between such peripherals and a DSI host can be represented
[all …]
|
| /Linux-v6.6/drivers/clk/meson/ |
| D | Kconfig | 64 want peripherals and CPU frequency scaling to work.
80 Say Y if you want peripherals and CPU frequency scaling to work.
95 Say Y if you want peripherals and CPU frequency scaling to work.
121 tristate "Amlogic A1 SoC Peripherals clock controller support"
127 Support for the Peripherals clock controller on Amlogic A113L based
128 device, A1 SoC Family. Say Y if you want A1 Peripherals clock
146 devices, aka g12a. Say Y if you want peripherals to work.
|
| D | a1-peripherals.h | 3 * Amlogic A1 Peripherals Clock Controller internals
15 /* peripherals clock controller register offset */
|
| /Linux-v6.6/drivers/usb/ |
| D | Kconfig | 53 traditional PC serial port. The bus supplies power to peripherals
54 and allows for hot swapping. Up to 127 USB peripherals can be
57 The USB host is the root of the tree, the peripherals are the
59 Most PCs now have USB host ports, used to connect peripherals
74 After choosing your HCD, then select drivers for the USB peripherals
|
| /Linux-v6.6/Documentation/devicetree/bindings/clock/ |
| D | amlogic,a1-peripherals-clkc.yaml | 4 $id: http://devicetree.org/schemas/clock/amlogic,a1-peripherals-clkc.yaml#
7 title: Amlogic A1 Peripherals Clock Control Unit
17 const: amlogic,a1-peripherals-clkc
60 compatible = "amlogic,a1-peripherals-clkc";
|
| D | brcm,bcm2835-aux-clock.txt | 6 The auxiliary peripherals (UART, SPI1, and SPI2) have a small register
7 area controlling clock gating to the peripherals, and providing an IRQ
|
| D | lpc1850-creg-clk.txt | 8 These clocks are used by the RTC and the Event Router peripherals.
9 The 32 kHz can also be routed to other peripherals to enable low
|
| /Linux-v6.6/drivers/pinctrl/starfive/ |
| D | Kconfig | 17 peripherals supporting inputs, outputs, configuring pull-up/pull-down
38 peripherals supporting inputs, outputs, configuring pull-up/pull-down
50 peripherals supporting inputs, outputs, configuring pull-up/pull-down
|
| /Linux-v6.6/drivers/usb/core/ |
| D | Kconfig | 73 bool "Rely on OTG and EH Targeted Peripherals List"
77 product list, so USB peripherals not listed there will be
80 "Targeted Peripherals List". "Embedded Hosts" are likewise
81 allowed to support only a limited number of peripherals.
|
| /Linux-v6.6/Documentation/devicetree/bindings/bus/ |
| D | fsl,spba-bus.yaml | 7 title: Shared Peripherals Bus Interface
13 A simple bus enabling access to shared peripherals.
18 determine which peripherals are available to it and the range over which
|
| D | baikal,bt1-axi.yaml | 18 another: from CPU to SoC peripherals and between some SoC peripherals
20 some peripherals). In case of any protocol error, device not responding
|
| /Linux-v6.6/include/dt-bindings/pinctrl/ |
| D | rzn1-pinctrl.h | 101 /* These are MDIO0 peripherals for the RZN1_FUNC_ETH_MDIO function */
110 /* These are MDIO0 peripherals for the RZN1_FUNC_ETH_MDIO_E1 function */
120 /* These are MDIO1 peripherals for the RZN1_FUNC_ETH_MDIO function */
129 /* These are MDIO1 peripherals for the RZN1_FUNC_ETH_MDIO_E1 function */
|
| /Linux-v6.6/Documentation/devicetree/bindings/pinctrl/ |
| D | starfive,jh7110-sys-pinctrl.yaml | 15 Some peripherals have their I/O go through the 64 "GPIOs". This also
17 All these peripherals are connected to all 64 GPIOs such that
18 any GPIO can be set up to be controlled by any of the peripherals.
|
| /Linux-v6.6/sound/pci/ice1712/ |
| D | amp.h | 8 * Lowlevel functions for Advanced Micro Peripherals Ltd AUDIO2000
17 #define VT1724_SUBDEVICE_AUDIO2000 0x12142417 /* Advanced Micro Peripherals Ltd AUDIO2000 */
|
| /Linux-v6.6/Documentation/devicetree/bindings/dma/ti/ |
| D | k3-bcdma.yaml | 20 optional triggers a block copy channel can service peripherals by accessing
23 Split channels can be used to service PSI-L based peripherals.
24 The peripherals can be PSI-L native or legacy, non PSI-L native peripherals
|
| /Linux-v6.6/include/dt-bindings/clock/ |
| D | marvell,pxa910.h | 26 /* apb peripherals */
46 /* axi peripherals */
|
| D | marvell,pxa1928.h | 9 /* apb peripherals */
41 /* axi peripherals */
|
| D | marvell,pxa168.h | 29 /* apb peripherals */
51 /* axi peripherals */
|
| /Linux-v6.6/Documentation/devicetree/bindings/arm/ |
| D | primecell.yaml | 7 title: ARM Primecell Peripherals
13 ARM, Ltd. Primecell peripherals have a standard id register that can be used to
|
| /Linux-v6.6/arch/arm/include/debug/ |
| D | at91.S | 14 ldr \rp, =CONFIG_DEBUG_UART_PHYS @ System peripherals (phys address)
15 ldr \rv, =CONFIG_DEBUG_UART_VIRT @ System peripherals (virt address)
|
| /Linux-v6.6/Documentation/devicetree/ |
| D | overlay-notes.rst | 33 /* On chip peripherals */
35 /* peripherals that are always instantiated */
67 /* On chip peripherals */
69 /* peripherals that are always instantiated */
|
| /Linux-v6.6/drivers/pnp/ |
| D | Kconfig | 11 Plug and Play (PnP) is a standard for peripherals which allows those
12 peripherals to be configured by software, e.g. assign IRQ's or other
|
| /Linux-v6.6/Documentation/devicetree/bindings/i2c/ |
| D | i2c-atr.yaml | 26 used to access the remote peripherals on the serializer's I2C bus. The
31 needed if there are no I2C addressable remote peripherals.
|
| /Linux-v6.6/Documentation/devicetree/bindings/memory-controllers/ |
| D | mc-peripheral-props.yaml | 14 and there can be multiple peripherals attached to a controller. All
37 - $ref: ingenic,nemc-peripherals.yaml#
|
| /Linux-v6.6/Documentation/devicetree/bindings/gpio/ |
| D | st,stmpe-gpio.yaml | 11 bus controllers for various expanded peripherals such as GPIO, keypad,
13 peripherals connected to SPI or I2C. These bindings pertain to the
|
12345678910>>...19
