Searched full:pin9 (Results 1 – 7 of 7) sorted by relevance
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | everest,es8326.yaml | 66 Bit(3) 1 means PIN9 is the irq source for jack detection. When set to 0,
67 bias change on PIN9 do not triggers irq.
69 Bit(5) 1 means PIN9 is the irq source after MIC detect.
|
| /Linux-v6.1/drivers/net/wireless/microchip/wilc1000/ |
| D | Kconfig | 22 To use this interface, pin9 (SDIO_SPI_CFG) must be grounded. Select
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | nuvoton-npcm750-pincfg-evb.dtsi | 11 pin9_output_high: pin9-output-high {
|
| D | am43x-epos-evm.dts | 71 col-gpios = <&gpio3 9 GPIO_ACTIVE_HIGH /* Bank3, pin9 */
|
| /Linux-v6.1/drivers/staging/media/deprecated/saa7146/av7110/ |
| D | av7110_v4l.c | 256 saa7146_setgpio(dev, 1, SAA7146_GPIO_OUTHI); // TDA9819 pin9(STD) in av7110_dvb_c_switch()
292 saa7146_setgpio(dev, 1, SAA7146_GPIO_OUTLO); // TDA9819 pin9(STD) in av7110_dvb_c_switch()
745 saa7146_setgpio(av7110->dev, 1, SAA7146_GPIO_OUTLO); // TDA9819 pin9(STD) in av7110_init_analog_module()
|
| D | av7110.c | 2228 saa7146_setgpio(av7110->dev, 1, SAA7146_GPIO_OUTLO); // TDA9819 pin9(STD) in frontend_init()
|
| /Linux-v6.1/drivers/hwmon/ |
| D | adt7475.c | 1531 prop2 = "adi,pin9-function"; in load_config()
|
