Searched full:pet (Results 1 – 14 of 14) sorted by relevance
115 * disconnected and we need to detach the pet to check if EUD is in safe in pet_eud()120 /* Detach & Attach pet for EUD */ in pet_eud()122 /* Delay to make sure detach pet is done before attach pet */ in pet_eud()126 dev_err(chip->dev, "Detach pet failed\n"); in pet_eud()130 /* Attach pet for EUD */ in pet_eud()
12 PET/PMMA: 0.2mm--2.0mm18 PET/PMMA: 0.2mm--4.0mm
50 /* OTG PET device is always targeted (see OTG 2.0 ECN 6.4.2) */ in is_targeted()
147 * pet nonstandard Ethernet-over-USB protocols, ignore it unless in usb_choose_configuration()
13 * [ADLink] ACL-7122 (acl7122), ACL-7124 (acl7124), PET-48DIO (pet48dio),
102 /* Pet the stall detector at half of its expiration timeout in start_stall_detector_cpu()
491 periodically "pet" an MMIO stall detector device from each vCPU
39 #define EPXC3_WATCHDOG_PET_REG 0x1ef /* write anything to pet once enabled */
221 * Adjust frequency down in this case so that we don't pet in rti_wdt_probe()
128 * "pet" the watchdog, as Access says. in wdtpci_start()
111 tristate "Advantech PCL-722/724/731 and ADlink ACL-7122/7124/PET-48DIO"124 ADlink PET-48DIO 48 channels
175 i got it and looked at the code, it really set off a lot of pet peeves -
161 * If the device or a previous one is unsynced, don't pet the in siox_poll()
65 { /* custom 3.7" flexible on PET or steel */
