Searched full:pc3 (Results 1 – 25 of 33) sorted by relevance
12
/Linux-v5.10/tools/power/cpupower/utils/idle_monitor/ |
D | nhm_idle.c | 27 enum intel_nhm_id { C3 = 0, C6, PC3, PC6, TSC = 0xFFFF }; enumerator 49 .name = "PC3", 51 .id = PC3, 83 case PC3: in nhm_get_count()
|
/Linux-v5.10/Documentation/devicetree/bindings/leds/ |
D | leds-sgm3140.yaml | 53 enable-gpios = <&pio 2 3 GPIO_ACTIVE_HIGH>; /* PC3 */
|
/Linux-v5.10/arch/arm/boot/dts/ |
D | sama5d3_emac.dtsi | 22 AT91_PIOC 3 AT91_PERIPH_A AT91_PINCTRL_NONE /* PC3 periph A ERX1, conflicts with TIOA4 */
|
D | sun8i-v3s.dtsi | 383 pins = "PC0", "PC1", "PC2", "PC3";
|
D | at91sam9263.dtsi | 443 AT91_PIOC 3 AT91_PERIPH_A AT91_PINCTRL_NONE /* PC3 periph A */
|
D | sun8i-a23-a33.dtsi | 412 pins = "PC3";
|
D | sunxi-h3-h5.dtsi | 469 pins = "PC0", "PC1", "PC2", "PC3";
|
D | tegra30-apalis-v1.1.dtsi | 535 uart2-rxd-pc3 {
|
D | tegra30-apalis.dtsi | 534 uart2-rxd-pc3 {
|
D | tegra124-apalis.dtsi | 631 uart2-rxd-pc3 {
|
/Linux-v5.10/Documentation/admin-guide/pm/ |
D | intel_idle.rst | 241 low-power state referred to as "package ``C3``" (or ``PC3``), which happens if 243 conditions are satisfied (for instance, if the GPU is covered by ``PC3``, it may 244 be required to be in a certain GPU-specific low-power state for ``PC3`` to be
|
/Linux-v5.10/tools/power/x86/turbostat/ |
D | turbostat.c | 200 unsigned long long pc3; member 534 { 0x0, "Pkg%pc3" }, 853 outp += sprintf(outp, "%sPkg%%pc3", (printed++ ? delim : "")); in print_header() 965 outp += sprintf(outp, "pc3: %016llX\n", p->pc3); in dump_counters() 1225 outp += sprintf(outp, "%s%.2f", (printed++ ? delim : ""), 100.0 * p->pc3/tsc); in format_counters() 1344 old->pc3 = new->pc3 - old->pc3; in delta_package() 1559 p->pc3 = 0; in clear_counters() 1657 average.packages.pc3 += p->pc3; in sum_counters() 1731 average.packages.pc3 /= topo.num_packages; in compute_average() 2045 if (get_msr(cpu, MSR_PKG_C3_RESIDENCY, &p->pc3)) in get_counters() [all …]
|
D | turbostat.8 | 112 \fBPkg%pc2, Pkg%pc3, Pkg%pc6, Pkg%pc7\fP percentage residency in hardware package idle states. The…
|
/Linux-v5.10/drivers/pinctrl/renesas/ |
D | pfc-shx3.c | 311 PINMUX_GPIO(PC3),
|
D | pfc-sh7786.c | 433 PINMUX_GPIO(PC3),
|
D | pfc-sh7785.c | 697 PINMUX_GPIO(PC3),
|
D | pfc-sh7203.c | 740 PINMUX_GPIO(PC3),
|
/Linux-v5.10/arch/arm64/boot/dts/allwinner/ |
D | sun50i-h6.dtsi | 364 pins = "PC0", "PC2", "PC3";
|
D | sun50i-a64.dtsi | 752 pins = "PC0", "PC1", "PC2", "PC3";
|
/Linux-v5.10/drivers/pinctrl/stm32/ |
D | pinctrl-stm32f429.c | 406 PINCTRL_PIN(35, "PC3"),
|
D | pinctrl-stm32f746.c | 428 PINCTRL_PIN(35, "PC3"),
|
D | pinctrl-stm32f469.c | 423 PINCTRL_PIN(35, "PC3"),
|
D | pinctrl-stm32f769.c | 501 PINCTRL_PIN(35, "PC3"),
|
D | pinctrl-stm32h743.c | 547 PINCTRL_PIN(35, "PC3"),
|
/Linux-v5.10/drivers/pinctrl/tegra/ |
D | pinctrl-tegra114.c | 225 PINCTRL_PIN(TEGRA_PIN_UART2_RXD_PC3, "UART2_RXD PC3"),
|
12