Home
last modified time | relevance | path

Searched full:optionally (Results 1 – 25 of 681) sorted by relevance

12345678910>>...28

/Linux-v6.6/Documentation/devicetree/bindings/spi/
Dspi-fsl-dspi.txt7 "fsl,ls1012a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
9 "fsl,ls1043a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
10 "fsl,ls1046a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
11 "fsl,ls1088a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
12 "fsl,ls2080a-dspi" (optionally followed by "fsl,ls2085a-dspi"),
Dspi-orion.txt12 This property can optionally have additional entries to configure
43 Example with SPI direct mode support (optionally):
/Linux-v6.6/include/acpi/
Dacpixf.h123 * Optionally use default values for the ACPI register widths. Set this to
139 * Optionally enable output from the AML Debug Object.
144 * Optionally copy the entire DSDT to local memory (instead of simply
152 * Optionally ignore an XSDT if present and use the RSDT instead.
160 * Optionally use 32-bit FADT addresses if and when there is a conflict
170 * Optionally use 32-bit FACS table addresses.
179 * Optionally truncate I/O addresses to 16 bits. Provides compatibility
193 * Optionally do not install any SSDTs from the RSDT/XSDT during initialization.
199 * Optionally enable runtime namespace override.
224 * Optionally ignore AE_NOT_FOUND errors from named reference package elements
[all …]
/Linux-v6.6/Documentation/networking/devlink/
Ddevlink-region.rst15 Regions may optionally support triggering snapshots on demand.
27 Regions may optionally support capturing a snapshot on demand via the
34 Regions may optionally allow directly reading from their contents without a
/Linux-v6.6/arch/arm/mach-omap2/
Dclkt2xxx_dpll.c26 * REVISIT: DPLL can optionally enter low-power bypass by writing 0x1
27 * instead. Add some mechanism to optionally enter this mode.
/Linux-v6.6/drivers/pinctrl/
Dcore.h36 * @pin_group_tree: optionally each pin group can be stored in this radix tree
37 * @num_groups: optionally number of groups can be kept here
38 * @pin_function_tree: optionally each function can be stored in this radix tree
39 * @num_functions: optionally number of functions can be kept here
/Linux-v6.6/Documentation/w1/slaves/
Dw1_ds28e04.rst21 during memory accesses can optionally be enabled/disabled via the device
22 attribute "crccheck". The strong pull-up can optionally be enabled/disabled
/Linux-v6.6/Documentation/devicetree/bindings/serial/
Dbrcm,bcm7271-uart.yaml32 description: The UART register block and optionally the DMA register blocks.
54 description: The UART interrupt and optionally the DMA interrupt.
/Linux-v6.6/Documentation/firmware-guide/acpi/
Dextcon-intel-int3496.rst10 USB-otg port, as well as how it optionally can enable Vbus output on the
11 otg port and how it can optionally control the muxing of the data pins
/Linux-v6.6/include/sound/sof/
Ddai-intel.h138 uint16_t polarity_mic_a; /**< Optionally invert mic A signal (0 or 1) */
139 uint16_t polarity_mic_b; /**< Optionally invert mic B signal (0 or 1) */
141 uint16_t clk_edge; /**< Optionally swap data clock edge (0 or 1) */
/Linux-v6.6/Documentation/devicetree/bindings/arm/keystone/
Dti,sci.yaml26 This parent node may optionally have additional children nodes which describe
46 Specifies the debug messages memory mapped region that is optionally
/Linux-v6.6/arch/arm/lib/
Dbacktrace.S47 * optionally saved caller registers (r4 - r10)
52 * optionally saved arguments (r0 - r3)
/Linux-v6.6/Documentation/devicetree/bindings/clock/ti/
Ddivider.txt45 unless the divider array is provided, min and max dividers. Optionally
49 This binding can also optionally provide support to the hardware autoidle
/Linux-v6.6/Documentation/scsi/
Dscsi_mid_low_api.rst689 * Optionally defined in: LLD
716 * Optionally defined in: LLD
737 * Optionally defined in: LLD
755 * Optionally defined in: LLD
773 * Optionally defined in: LLD
795 * Optionally defined in: LLD
825 * Optionally defined in: LLD
854 * Optionally defined in: LLD
884 * Optionally defined in: LLD
982 * Optionally defined in: LLD
[all …]
/Linux-v6.6/drivers/firmware/arm_scmi/
DKconfig124 transport to optionally ask for atomic SCMI transactions and operate
165 transport to optionally ask for atomic SCMI transactions and operate
/Linux-v6.6/net/netlabel/
Dnetlabel_mgmt.h48 * however the following attribute may optionally be sent:
102 * however the following attribute may optionally be sent:
/Linux-v6.6/include/linux/usb/
Drndis_host.h158 struct rndis_keepalive { /* OUT (optionally IN) */
165 struct rndis_keepalive_c { /* IN (optionally OUT) */
/Linux-v6.6/Documentation/mm/
Dpage_table_check.rst19 it is disabled by default, but can be optionally enabled on systems where the
53 Optionally, build kernel with PAGE_TABLE_CHECK_ENFORCED in order to have page
/Linux-v6.6/Documentation/devicetree/bindings/mtd/
Datmel-dataflash.txt6 The device tree may optionally contain sub-nodes describing partitions of the
/Linux-v6.6/include/sound/
Drt5660.h19 /* IN1 & IN3 can optionally be differential */
Dwm9090.h12 /* Line inputs 1 & 2 can optionally be differential */
/Linux-v6.6/include/drm/
Ddrm_encoder_slave.h45 * &drm_encoder_helper_funcs and they can optionally be used to
119 * structures and to initialize the @slave_funcs and (optionally)
/Linux-v6.6/Documentation/sound/designs/
Dchannel-mapping-api.rst11 and the current channel map, also optionally to modify the channel map
53 read operation. Optionally, the write operation can be provided to
/Linux-v6.6/drivers/net/usb/
Dcx82310_eth.c50 * - optionally send some data (command parameters)
51 * - optionally wait for the reply
52 * - optionally read some data from the reply
/Linux-v6.6/arch/arm/boot/dts/marvell/
Darmada-385-clearfog-gtr.dtsi10 0. SATA1 on CON18, or optionally mini PCIe CON3 - PCIe0
12 2. SATA0 on CON17, or optionally mini PCIe CON4 - PCIe1
15 5. SFP connector, or optionally SGMII Ethernet 1512 PHY

12345678910>>...28