Searched full:optionally (Results 1 – 25 of 601) sorted by relevance
12345678910>>...25
| /Linux-v5.10/Documentation/devicetree/bindings/spi/ |
| D | spi-fsl-dspi.txt | 7 "fsl,ls1012a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
9 "fsl,ls1043a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
10 "fsl,ls1046a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
11 "fsl,ls1088a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
12 "fsl,ls2080a-dspi" (optionally followed by "fsl,ls2085a-dspi"),
|
| D | spi-orion.txt | 12 This property can optionally have additional entries to configure
43 Example with SPI direct mode support (optionally):
|
| /Linux-v5.10/include/acpi/ |
| D | acpixf.h | 123 * Optionally use default values for the ACPI register widths. Set this to
139 * Optionally enable output from the AML Debug Object.
144 * Optionally copy the entire DSDT to local memory (instead of simply
152 * Optionally ignore an XSDT if present and use the RSDT instead.
160 * Optionally use 32-bit FADT addresses if and when there is a conflict
170 * Optionally use 32-bit FACS table addresses.
179 * Optionally truncate I/O addresses to 16 bits. Provides compatibility
193 * Optionally do not install any SSDTs from the RSDT/XSDT during initialization.
199 * Optionally enable runtime namespace override.
224 * Optionally ignore AE_NOT_FOUND errors from named reference package elements
[all …]
|
| /Linux-v5.10/Documentation/devicetree/bindings/remoteproc/ |
| D | qcom,wcnss-pil.txt | 34 Definition: should be "wdog", "fatal", optionally followed by "ready",
77 Definition: should specify the xo clock and optionally the rf clock
82 Definition: should be "xo", optionally followed by "rf"
|
| D | qcom,adsp.txt | 70 Definition: reference to the xo clock and optionally aggre2 clock to be
76 Definition: must be "xo" and optionally include "aggre2"
|
| /Linux-v5.10/Documentation/devicetree/bindings/mtd/ |
| D | mtd-physmap.txt | 10 It's possible to (optionally) define multiple "reg" tuples so that
46 The device tree may optionally contain endianness property.
53 The device tree may optionally contain sub-nodes describing partitions of the
|
| D | atmel-dataflash.txt | 6 The device tree may optionally contain sub-nodes describing partitions of the
|
| /Linux-v5.10/arch/arm/mach-omap2/ |
| D | clkt2xxx_dpll.c | 26 * REVISIT: DPLL can optionally enter low-power bypass by writing 0x1
27 * instead. Add some mechanism to optionally enter this mode.
|
| /Linux-v5.10/Documentation/devicetree/bindings/timer/ |
| D | qcom,msm-timer.txt | 12 timer, and optionally a second general purpose timer, and
13 optionally as well, 2 watchdog interrupts, in that order.
|
| D | snps,arc-timer.txt | 3 - Can be optionally programmed to interrupt on Limit
|
| /Linux-v5.10/drivers/pinctrl/ |
| D | core.h | 26 * @pin_group_tree: optionally each pin group can be stored in this radix tree
27 * @num_groups: optionally number of groups can be kept here
28 * @pin_function_tree: optionally each function can be stored in this radix tree
29 * @num_functions: optionally number of functions can be kept here
|
| /Linux-v5.10/Documentation/w1/slaves/ |
| D | w1_ds28e04.rst | 21 during memory accesses can optionally be enabled/disabled via the device
22 attribute "crccheck". The strong pull-up can optionally be enabled/disabled
|
| /Linux-v5.10/Documentation/firmware-guide/acpi/ |
| D | extcon-intel-int3496.rst | 10 USB-otg port, as well as how it optionally can enable Vbus output on the
11 otg port and how it can optionally control the muxing of the data pins
|
| /Linux-v5.10/Documentation/networking/devlink/ |
| D | devlink-region.rst | 15 Regions may optionally support triggering snapshots on demand.
27 Regions may optionally support capturing a snapshot on demand via the
|
| /Linux-v5.10/include/sound/sof/ |
| D | dai-intel.h | 132 uint16_t polarity_mic_a; /**< Optionally invert mic A signal (0 or 1) */
133 uint16_t polarity_mic_b; /**< Optionally invert mic B signal (0 or 1) */
135 uint16_t clk_edge; /**< Optionally swap data clock edge (0 or 1) */
|
| /Linux-v5.10/Documentation/devicetree/bindings/net/ |
| D | xilinx_axienet.txt | 25 and optionally Ethernet core. If axistream-connected is
27 instead, and only the Ethernet core interrupt is optionally
|
| /Linux-v5.10/arch/arm/lib/ |
| D | backtrace.S | 47 * optionally saved caller registers (r4 - r10)
52 * optionally saved arguments (r0 - r3)
|
| /Linux-v5.10/Documentation/devicetree/bindings/clock/ti/ |
| D | divider.txt | 45 unless the divider array is provided, min and max dividers. Optionally
49 This binding can also optionally provide support to the hardware autoidle
|
| /Linux-v5.10/Documentation/scsi/ |
| D | scsi_mid_low_api.rst | 689 * Optionally defined in: LLD
716 * Optionally defined in: LLD
737 * Optionally defined in: LLD
755 * Optionally defined in: LLD
773 * Optionally defined in: LLD
795 * Optionally defined in: LLD
825 * Optionally defined in: LLD
854 * Optionally defined in: LLD
884 * Optionally defined in: LLD
982 * Optionally defined in: LLD
[all …]
|
| /Linux-v5.10/net/netlabel/ |
| D | netlabel_mgmt.h | 48 * however the following attribute may optionally be sent:
102 * however the following attribute may optionally be sent:
|
| /Linux-v5.10/include/sound/ |
| D | rt5660.h | 19 /* IN1 & IN3 can optionally be differential */
|
| D | wm9090.h | 12 /* Line inputs 1 & 2 can optionally be differential */
|
| D | rt5645.h | 12 /* IN2 can optionally be differential */
|
| /Linux-v5.10/include/drm/ |
| D | drm_encoder_slave.h | 43 * &drm_encoder_helper_funcs and they can optionally be used to
117 * structures and to initialize the @slave_funcs and (optionally)
|
| /Linux-v5.10/Documentation/sound/designs/ |
| D | channel-mapping-api.rst | 11 and the current channel map, also optionally to modify the channel map
53 read operation. Optionally, the write operation can be provided to
|
12345678910>>...25
