| /Linux-v5.10/Documentation/devicetree/bindings/iio/afe/ |
| D | voltage-divider.txt | 26 - output-ohms : Resistance Rout over which the output voltage is measured.
27 See full-ohms.
28 - full-ohms : Resistance R + Rout for the full divider. The io-channel
33 voltage divider (R = 200 Ohms, Rout = 22 Ohms) and fed to an ADC.
40 output-ohms = <22>;
41 full-ohms = <222>; /* 200 + 22 */
|
| D | current-sense-shunt.txt | 12 - shunt-resistor-micro-ohms : The shunt resistance in microohms.
16 3.3 ohms shunt resistor.
23 shunt-resistor-micro-ohms = <3300000>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/adc/ |
| D | maxim,max9611.yaml | 25 shunt-resistor-micro-ohms:
28 Value in micro Ohms of the shunt resistor connected between the RS+ and
37 - shunt-resistor-micro-ohms
48 shunt-resistor-micro-ohms = <5000>;
|
| D | qcom,spmi-iadc.txt | 7 qcom,external-resistor-micro-ohms property.
26 - qcom,external-resistor-micro-ohms:
30 If not defined value of 10000 micro Ohms will be used.
38 qcom,external-resistor-micro-ohms = <10000>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/phy/ |
| D | mxs-usb-phy.txt | 17 - fsl,tx-cal-45-dn-ohms: Integer [30-55]. Resistance (in ohms) of switchable
20 - fsl,tx-cal-45-dp-ohms: Integer [30-55]. Resistance (in ohms) of switchable
|
| /Linux-v5.10/Documentation/devicetree/bindings/hwmon/ |
| D | ltc4151.txt | 8 - shunt-resistor-micro-ohms
9 Shunt resistor value in micro-Ohms
17 shunt-resistor-micro-ohms = <1500>;
|
| D | ina3221.txt | 31 - shunt-resistor-micro-ohms: Shunt resistor value in micro-Ohm
47 shunt-resistor-micro-ohms = <5000>;
52 shunt-resistor-micro-ohms = <5000>;
|
| D | adi,adm1177.yaml | 29 shunt-resistor-micro-ohms:
38 based on shunt-resistor-micro-ohms.
63 shunt-resistor-micro-ohms = <50000>; /* 50 mOhm */
|
| D | adm1275.txt | 16 - shunt-resistor-micro-ohms
24 shunt-resistor-micro-ohms = <500>;
|
| /Linux-v5.10/drivers/iio/adc/ |
| D | qcom-spmi-iadc.c | 72 #define IADC_INT_RSENSE_DEVIATION 15625 /* nano Ohms per bit */
74 #define IADC_INT_RSENSE_IDEAL_VALUE 10000 /* micro Ohms */
75 #define IADC_INT_RSENSE_DEFAULT_VALUE 7800 /* micro Ohms */
76 #define IADC_INT_RSENSE_DEFAULT_GF 9000 /* micro Ohms */
77 #define IADC_INT_RSENSE_DEFAULT_SMIC 9700 /* micro Ohms */
99 * @rsense: Values of the internal and external sense resister in micro Ohms.
435 ret = of_property_read_u32(node, "qcom,external-resistor-micro-ohms", in iadc_rsense_read()
441 dev_err(iadc->dev, "external resistor can't be zero Ohms"); in iadc_rsense_read()
450 * Deviation value stored is an offset from 10 mili Ohms, bit 7 is in iadc_rsense_read()
451 * the sign, the remaining bits have an LSB of 15625 nano Ohms. in iadc_rsense_read()
[all …]
|
| /Linux-v5.10/Documentation/devicetree/bindings/input/touchscreen/ |
| D | ads7846.txt | 47 ti,x-plate-ohms Resistance of the X-plate,
48 in Ohms (u16).
49 ti,y-plate-ohms Resistance of the Y-plate,
50 in Ohms (u16).
101 ti,x-plate-ohms = /bits/ 16 <40>;
|
| D | tsc2007.txt | 6 - ti,x-plate-ohms: X-plate resistance in ohms.
35 ti,x-plate-ohms = <180>;
|
| D | tsc2005.txt | 13 - ti,x-plate-ohms : integer, resistance of the touchscreen's X plates
38 ti,x-plate-ohms = <280>;
61 ti,x-plate-ohms = <280>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/devfreq/ |
| D | rk3399_dmc.txt | 79 the DRAM side driver strength in ohms. Default
83 the DRAM side ODT strength in ohms. Default value
106 the DRAM side driver strength in ohms. Default
110 the DRAM side ODT strength in ohms. Default value
134 the DRAM side driver strength in ohms. Default
138 the DRAM side ODT on DQS/DQ line strength in ohms.
142 the DRAM side ODT on CA line strength in ohms.
|
| /Linux-v5.10/Documentation/devicetree/bindings/power/supply/ |
| D | qcom,coincell-charger.txt | 17 - qcom,rset-ohms:
20 Definition: resistance (in ohms) for current-limiting resistor
45 qcom,rset-ohms = <2100>;
|
| D | sc27xx-fg.txt | 16 - sprd,calib-resistance-micro-ohms: Specify the real resistance of coulomb counter
17 chip in micro Ohms.
57 sprd,calib-resistance-micro-ohms = <21500>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/light/ |
| D | cm3605.txt | 25 - capella,aset-resistance-ohms: the sensitivity calibration resistance,
26 in Ohms. Valid values are: 50000, 100000, 300000 and 600000,
37 capella,aset-resistance-ohms = <100000>;
|
| /Linux-v5.10/arch/arm64/boot/dts/nvidia/ |
| D | tegra186-p2771-0000.dts | 23 shunt-resistor-micro-ohms = <20000>;
29 shunt-resistor-micro-ohms = <5000>;
35 shunt-resistor-micro-ohms = <10000>;
48 shunt-resistor-micro-ohms = <10000>;
54 shunt-resistor-micro-ohms = <10000>;
60 shunt-resistor-micro-ohms = <10000>;
|
| D | tegra186-p3310.dtsi | 79 shunt-resistor-micro-ohms = <10000>;
85 shunt-resistor-micro-ohms = <10000>;
91 shunt-resistor-micro-ohms = <10000>;
104 shunt-resistor-micro-ohms = <5000>;
110 shunt-resistor-micro-ohms = <10000>;
116 shunt-resistor-micro-ohms = <10000>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/leds/ |
| D | leds-lm3532.txt | 36 - ti,als1-imp-sel - ALS1 impedance resistor selection in Ohms
37 - ti,als2-imp-sel - ALS2 impedance resistor selection in Ohms
38 Range for impedance select: 37000 Ohms - 1190 Ohms
|
| /Linux-v5.10/drivers/iio/afe/ |
| D | iio-rescale.c | 157 ret = device_property_read_u32(dev, "sense-resistor-micro-ohms", in rescale_current_sense_amplifier_props()
194 ret = device_property_read_u32(dev, "shunt-resistor-micro-ohms", in rescale_current_sense_shunt_props()
214 ret = device_property_read_u32(dev, "output-ohms", in rescale_voltage_divider_props()
217 dev_err(dev, "failed to read output-ohms: %d\n", ret); in rescale_voltage_divider_props()
221 ret = device_property_read_u32(dev, "full-ohms", in rescale_voltage_divider_props()
224 dev_err(dev, "failed to read full-ohms: %d\n", ret); in rescale_voltage_divider_props()
|
| /Linux-v5.10/drivers/rtc/ |
| D | rtc-ds1390.c | 90 u32 ohms = 0; in ds1390_trickle_of_init() local
93 if (of_property_read_u32(spi->dev.of_node, "trickle-resistor-ohms", in ds1390_trickle_of_init()
94 &ohms)) in ds1390_trickle_of_init()
105 switch (ohms) { in ds1390_trickle_of_init()
117 "Unsupported ohm value %02ux in dt\n", ohms); in ds1390_trickle_of_init()
|
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | imx6qdl-gw5913.dtsi | 169 gw,voltage-divider-ohms = <22100 1000>;
177 gw,voltage-divider-ohms = <22100 10000>;
184 gw,voltage-divider-ohms = <10000 10000>;
191 gw,voltage-divider-ohms = <10000 10000>;
228 gw,voltage-divider-ohms = <10000 10000>;
235 gw,voltage-divider-ohms = <10000 10000>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/rtc/ |
| D | dallas,ds1390.txt | 8 - trickle-resistor-ohms : Selected resistor for trickle charger
16 trickle-resistor-ohms = <250>;
|
| D | ti,bq32k.txt | 8 - trickle-resistor-ohms : Selected resistor for trickle charger
16 trickle-resistor-ohms = <1120>;
|
