Home
last modified time | relevance | path

Searched full:mx8 (Results 1 – 25 of 25) sorted by relevance

/Linux-v5.10/drivers/firmware/imx/
DKconfig8 DSP exists on some i.MX8 processors (e.g i.MX8QM, i.MX8QXP).
19 resource management. It exists on some i.MX8 processors. e.g. i.MX8QM
/Linux-v5.10/Documentation/devicetree/bindings/phy/
Dmixel,mipi-dsi-phy.txt1 Mixel DSI PHY for i.MX8
3 The Mixel MIPI-DSI PHY IP block is e.g. found on i.MX8 platforms (along the
/Linux-v5.10/sound/soc/sof/imx/
DKconfig29 bool "SOF support for i.MX8"
33 This adds support for Sound Open Firmware for NXP i.MX8 platforms
Dimx8.c7 // Hardware interface for audio DSP on i.MX8
364 /* on i.MX8 there is 1 to 1 match between type and BAR idx */
409 /* i.MX8 ops */
Dimx8m.c228 /* on i.MX8 there is 1 to 1 match between type and BAR idx */
262 /* i.MX8 ops */
Dimx-common.c5 // Common helpers for the audio DSP on i.MX8
/Linux-v5.10/Documentation/devicetree/bindings/dsp/
Dfsl,dsp.yaml7 title: NXP i.MX8 DSP core
13 Some boards from i.MX8 family contain a DSP core used for
/Linux-v5.10/drivers/perf/
DKconfig82 tristate "Freescale i.MX8 DDR perf monitor"
85 Provides support for the DDR performance monitor in i.MX8, which
Dfsl_imx8_ddr_perf.c688 dev_warn(&pdev->dev, "i.MX8 DDR Perf PMU failed (%d), disabled\n", ret); in ddr_perf_probe()
/Linux-v5.10/drivers/phy/freescale/
DKconfig16 on NXP's i.MX8 family of SOCs.
/Linux-v5.10/drivers/net/ethernet/stmicro/stmmac/
DKconfig206 Support for ethernet controller on NXP i.MX8 SOCs.
209 device driver. This driver is used for i.MX8 series like
/Linux-v5.10/drivers/nvmem/
Dimx-ocotp-scu.c3 * i.MX8 OCOTP fusebox driver
273 MODULE_DESCRIPTION("i.MX8 SCU OCOTP fuse box driver");
DKconfig48 tristate "i.MX8 SCU On-Chip OTP Controller support"
53 available on i.MX8 SoCs.
/Linux-v5.10/Documentation/devicetree/bindings/mailbox/
Dfsl,mu.yaml39 - description: To communicate with i.MX8 SCU with fast IPC
/Linux-v5.10/Documentation/admin-guide/perf/
Dimx-ddr.rst2 Freescale i.MX8 DDR Performance Monitoring Unit (PMU)
/Linux-v5.10/drivers/gpu/drm/bridge/
DKconfig98 for example found on NXP's i.MX8 Processors.
Dnwl-dsi.c3 * i.MX8 NWL MIPI DSI host driver
36 /* i.MX8 NWL quirks */
/Linux-v5.10/Documentation/devicetree/bindings/display/bridge/
Dnwl-dsi.yaml14 NWL MIPI-DSI host controller found on i.MX8 platforms. This is a dsi bridge for
/Linux-v5.10/sound/soc/sof/
DKconfig41 required to enable i.MX8 devices.
/Linux-v5.10/Documentation/devicetree/bindings/mfd/
Drohm,bd71847-pmic.yaml48 # refer to NXP i.MX8 documentation for further information regarding SNVS
Drohm,bd71837-pmic.yaml42 # i.MX8 documentation for further information regarding SNVS state. When a
/Linux-v5.10/drivers/clk/imx/
Dclk-scu.c372 * Note on MX8, the clocks are tightly coupled with power domain in __imx_clk_scu()
/Linux-v5.10/Documentation/devicetree/bindings/arm/freescale/
Dfsl,scu.txt6 resource management. It exists on some i.MX8 processors. e.g. i.MX8QM
/Linux-v5.10/Documentation/devicetree/bindings/arm/
Dfsl.yaml472 - description: Toradex Colibri i.MX8 Evaluation Board
/Linux-v5.10/drivers/mfd/
DKconfig1978 NXP i.MX8. It contains 8 BUCK outputs and 7 LDOs, voltage monitoring