Searched full:listed (Results 1 – 25 of 1046) sorted by relevance
12345678910>>...42
| /Linux-v6.1/Documentation/devicetree/bindings/display/ |
| D | st,stih4xx.txt | 18 - clock-names: names of the clocks listed in clocks property in the same
36 - clock-names: names of the clocks listed in clocks property in the same
40 - reset-names: names of the resets listed in resets property in the same
49 - reg-names: names of the mapped memory regions listed in regs property in
53 - reset-names: names of the resets listed in resets property in the same
61 - reg-names: names of the mapped memory regions listed in regs property in
64 - interrupt-names: names of the interrupts listed in interrupts property in
68 - clock-names: names of the clocks listed in clocks property in the same
77 - reg-names: names of the mapped memory regions listed in regs property in
82 - clock-names: names of the clocks listed in clocks property in the same
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | pmc.txt | 6 "fsl,mpc8349-pmc" should be listed for any chip whose PMC is
7 compatible. "fsl,mpc8313-pmc" should also be listed for any chip
10 "fsl,mpc8548-pmc" should be listed for any chip whose PMC is
11 compatible. "fsl,mpc8536-pmc" should also be listed for any chip
14 "fsl,mpc8641d-pmc" should be listed for any chip whose PMC is
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | st,sti-asoc-card.txt | 20 - clock-names: name of the clocks listed in clocks property in the same order
22 - reg: CPU DAI IP Base address and size entries, listed in same
25 - reg-names: names of the mapped memory regions listed in regs property in
28 - interrupts: CPU_DAI interrupt line, listed in the same order than the
31 - dma: CPU_DAI DMA controller phandle and DMA request line, listed in the same
39 - clocks: CPU_DAI IP clock source, listed in the same order than the
|
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | lantiq,pinctrl-falcon.txt | 21 Each subnode only affects those parameters that are explicitly listed. In
33 Valid values for these names are listed below.
35 group. Valid values for function names are listed below.
51 Valid values for these names are listed below.
|
| D | samsung,pinctrl-pins-cfg.yaml | 39 The pin function selection that should be applied on the pins listed in the
41 of this property that should be applied to each of the pins listed in the
44 no specific function selection is desired for the pins listed in the child
|
| D | fsl,mxs-pinctrl.txt | 18 a group of pins, and only affects those parameters that are explicitly listed.
54 Valid values for these integers are listed below.
122 to be listed in the config nodes.
|
| D | lantiq,pinctrl-xway.txt | 30 Each subnode only affects those parameters that are explicitly listed. In
42 Valid values for these names are listed below.
44 group. Valid values for function names are listed below.
135 Valid values for these names are listed below.
|
| D | nvidia,tegra20-pinmux.txt | 21 Each subnode only affects those parameters that are explicitly listed. In
32 group. Valid values for these names are listed below.
36 pin or group. Valid values for function names are listed below. See the Tegra
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-bus-event_source-devices-hv_gpci | 9 perf_event_attr.config. All supported attributes are listed
46 0 or 1. Indicates whether we have access to "GA" events (listed
53 0 or 1. Indicates whether we have access to "EXPANDED" events (listed
60 0 or 1. Indicates whether we have access to "LAB" events (listed
|
| D | sysfs-driver-typec-displayport | 9 All supported configurations are listed as space separated list
32 listed as space separated list with the active one wrapped in
|
| D | sysfs-driver-hid-logitech-lg4ff | 14 mode is listed as follows:
22 of the wheel not all listed modes might always be selectable.
|
| /Linux-v6.1/Documentation/devicetree/bindings/media/ |
| D | st,st-hva.txt | 7 - reg-names: names of the registers listed in registers property in the same
13 - clock-names: names of the clocks listed in clocks property in the same order.
|
| /Linux-v6.1/crypto/ |
| D | crypto_engine.c | 255 * @req: the request need to be listed into the engine queue
285 * @req: the request need to be listed into the engine queue
297 * @req: the request need to be listed into the engine queue
310 * @req: the request need to be listed into the engine queue
323 * @req: the request need to be listed into the engine queue
336 * @req: the request need to be listed into the engine queue
349 * @req: the request need to be listed into the engine queue
|
| /Linux-v6.1/include/linux/ |
| D | coda.h | 12 Additional copyrights listed below
17 technical and financial contributors to Coda are listed in the file
|
| /Linux-v6.1/Documentation/userspace-api/media/rc/ |
| D | rc-sysfs-nodes.rst | 97 Note that protocol variants are listed, so ``nec``, ``sony``, ``rc-5``, ``rc-6``
98 have their different bit length encodings listed if available.
100 Note that all protocol variants are listed.
|
| /Linux-v6.1/Documentation/devicetree/bindings/rtc/ |
| D | renesas,sh-rtc.yaml | 32 # The functional clock source for the RTC controller must be listed
34 # are to be listed.
|
| /Linux-v6.1/tools/usb/usbip/doc/ |
| D | usbip.8 | 9 On a USB/IP server, devices can be listed, bound, and unbound using
11 can be listed, attached and detached.
|
| /Linux-v6.1/Documentation/devicetree/bindings/pci/ |
| D | hisilicon-histb-pcie.txt | 21 - clocks: List of phandle and clock specifier pairs as listed in clock-names
28 - resets: List of phandle and reset specifier pairs as listed in reset-names
|
| /Linux-v6.1/Documentation/devicetree/bindings/mux/ |
| D | mux-consumer.yaml | 25 strings to label each of the mux controllers listed in the "mux-controls"
31 each of the multiplixer states listed in the "mux-states" property.
|
| /Linux-v6.1/Documentation/kbuild/ |
| D | makefiles.rst | 226 compile the objects listed in $(isdn-y) and then run
254 Objects listed with obj-* are used for modules, or
258 All objects listed with lib-y are combined in a single
260 Objects that are listed in obj-y and additionally listed in
263 For consistency, objects listed in lib-m will be included in lib.a.
276 shall be listed in libs-y.
411 The two flags listed above are similar to ccflags-y and asflags-y.
568 Any target that utilizes if_changed must be listed in $(targets),
572 If the target is already listed in the recognized syntax such as
694 one of the listed prefixes. The first prefix where there exist a
[all …]
|
| /Linux-v6.1/Documentation/driver-api/early-userspace/ |
| D | early_userspace_support.rst | 66 special files can be listed in a 'root-files' file. Both 'root-image'
67 and 'root-files' can be listed in CONFIG_INITRAMFS_SOURCE and a complete
135 some other init binary than listed at the end of init/main.c:init().
|
| /Linux-v6.1/Documentation/process/ |
| D | code-of-conduct-interpretation.rst | 29 subsystem, driver, or file, and is listed in the MAINTAINERS file in the
124 The address listed in the Code of Conduct goes to the Code of Conduct
126 are listed at https://kernel.org/code-of-conduct.html. Members can not
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/accel/ |
| D | bosch,bma255.yaml | 49 Without interrupt-names, the first interrupt listed must be the one
50 connected to the INT1 pin, the second (optional) interrupt listed must be
|
| /Linux-v6.1/Documentation/devicetree/bindings/usb/ |
| D | dwc3-xilinx.yaml | 36 listed in clock-names.
49 A list of phandles for resets listed in reset-names.
|
| /Linux-v6.1/Documentation/devicetree/bindings/arm/ |
| D | pmu.yaml | 76 the SPIs listed in the interrupts property.
80 a PMU of this type signalling the PPI listed in the
|
12345678910>>...42
