Home
last modified time | relevance | path

Searched full:host1 (Results 1 – 25 of 34) sorted by relevance

12

/Linux-v6.1/tools/testing/selftests/net/
Dvrf-xfrm-tests.sh70 out=$(eval ip netns exec host1 $cmd 2>&1)
180 ip netns del host1
186 create_ns "host1"
189 connect_ns "host1" eth0 ${HOST1_4}/24 ${HOST1_6}/64 \
192 create_vrf "host1" ${VRF} ${TABLE}
193 ip -netns host1 link set dev eth0 master ${VRF}
198 for ns in host1 host2
220 # host1 - IPv4 out
221 ip -netns host1 xfrm policy add \
230 # host1 - IPv4 in
[all …]
/Linux-v6.1/drivers/soc/qcom/
Dsmem.c144 * @host1: second processor/host with access to this partition
153 __le16 host1; member
180 * @host1: second processor/host with access to this partition
191 __le16 host1; member
418 le16_to_cpu(phdr->host0), le16_to_cpu(phdr->host1)); in qcom_smem_alloc_private()
629 le16_to_cpu(phdr->host0), le16_to_cpu(phdr->host1)); in qcom_smem_get_private()
827 struct smem_ptable_entry *entry, u16 host0, u16 host1) in qcom_smem_partition_header() argument
849 if (host1 != le16_to_cpu(header->host1)) { in qcom_smem_partition_header()
850 dev_err(smem->dev, "bad host1 (%hu != %hu)\n", in qcom_smem_partition_header()
851 host1, le16_to_cpu(header->host1)); in qcom_smem_partition_header()
[all …]
/Linux-v6.1/drivers/pci/endpoint/functions/
Dpci-epf-ntb.c14 * HOST1 and HOST2 can communicate with each other using SoC as a bridge.
18 * | HOST1 | | HOST2 |
133 * @ntb: NTB device that facilitates communication between HOST1 and HOST2
136 * Once NTB function in HOST1 and the NTB function in HOST2 invoke
178 * @ntb: NTB device that facilitates communication between HOST1 and HOST2
223 * BAR_MW4 for rest of the BARs of epf_ntb_epc that is connected to HOST1. This
287 * @ntb: NTB device that facilitates communication between HOST1 and HOST2
324 * @ntb: NTB device that facilitates communication between HOST1 and HOST2
371 * HOST1. This is populated in epf_ntb_alloc_peer_mem() in this driver along
427 * @ntb: NTB device that facilitates communication between HOST1 and HOST2
[all …]
Dpci-epf-vntb.c327 * Clear BAR0 of EP CONTROLLER 1 which contains the HOST1's config and
335 * scratchpad is HOST1's self scratchpad.
352 * Map BAR0 of EP CONTROLLER 1 which contains the HOST1's config and
396 * @ntb: NTB device that facilitates communication between HOST1 and HOST2
790 * @ntb: NTB device that facilitates communication between HOST1 and HOST2
/Linux-v6.1/arch/arm/boot/dts/
Drk3288-veyron-chromebook.dtsi61 /* This turns on vbus for host1 (dwc2) */
62 vcc5_host1: vcc5-host1-regulator {
174 host1_pwr_en: host1-pwr-en {
Daspeed-bmc-facebook-yosemitev2.dts51 // Host1 Console
123 //Host1 IPMB bus
Drk3288-phycore-rdk.dts50 vcc_host1_5v: usb-host1-regulator {
211 host1_vbus_drv: host1-vbus-drv {
Drk3288-evb.dtsi131 /* This turns on USB vbus for both host0 (ehci) and host1 (dwc2) */
Drk3288-veyron-fievel.dts39 vcc5_host1: vcc5-host1-regulator {
/Linux-v6.1/Documentation/PCI/endpoint/
Dpci-ntb-function.rst23 configures the SoC with multiple EP instances, HOST1 and HOST2 can
30 | HOST1 | | HOST2 |
291 Above diagram shows Config region + Scratchpad region for HOST1 (connected to
292 EP controller 1) allocated in local memory. The HOST1 can access the config
297 for HOST1, however the same is applicable for HOST2.
336 HOST1 can raise doorbell interrupt on HOST2 and also how HOST1 can access
Dpci-vntb-function.rst11 PCI NTB function need at two endpoint instances and connect HOST1
/Linux-v6.1/Documentation/admin-guide/nfs/
Dnfs-rdma.rst187 assumes you have two IB hosts named host1 and host2):
191 host1$ ip link set dev ib0 up
192 host1$ ip address add dev ib0 a.b.c.x
195 host1$ ping a.b.c.y
/Linux-v6.1/drivers/gpu/drm/msm/dsi/
Ddsi_manager.c161 * during PLL0 clock's set_rate. The PHY1 reset called by host1 here in dsi_mgr_phy_enable()
289 pr_err("%s: power on host1 failed, %d\n", in dsi_mgr_bridge_power_on()
342 pr_err("%s: enable host1 failed, %d\n", __func__, ret); in dsi_mgr_bridge_pre_enable()
398 pr_err("%s: host1 disable failed, %d\n", __func__, ret); in dsi_mgr_bridge_post_disable()
415 pr_err("%s: host1 power off failed, %d\n", in dsi_mgr_bridge_post_disable()
/Linux-v6.1/Documentation/devicetree/bindings/pinctrl/
Dralink,rt3883-pinctrl.yaml40 lna a, lna g, mdio, pci-dev, pci-fnc, pci-host1, pci-host2,
/Linux-v6.1/Documentation/devicetree/bindings/phy/
Dmarvell,armada-cp110-utmi-phy.yaml24 1.H----- USB HOST1
/Linux-v6.1/drivers/pinctrl/ralink/
Dpinctrl-rt3883.c61 FUNC("pci-host1", 2, 40, 32),
/Linux-v6.1/drivers/gpu/drm/nouveau/nvkm/engine/fifo/
Dgp100.c38 { 0x07, "HOST1", NULL, NVKM_ENGINE_FIFO },
Dgm107.c57 { 0x08, "HOST1", NULL, NVKM_ENGINE_FIFO },
/Linux-v6.1/Documentation/devicetree/bindings/gpio/
Dgpio-pca95xx.yaml196 "en-host1", "en-host2", "chg-int", "p14", "p15",
/Linux-v6.1/drivers/net/ethernet/sfc/falcon/
Dfarch.c1984 __be32 rhost, host1, host2; in ef4_farch_filter_from_gen_spec() local
2014 host1 = rhost; in ef4_farch_filter_from_gen_spec()
2023 spec->data[0] = ntohl(host1) << 16 | ntohs(port1); in ef4_farch_filter_from_gen_spec()
2024 spec->data[1] = ntohs(port2) << 16 | ntohl(host1) >> 16; in ef4_farch_filter_from_gen_spec()
2082 __be32 host1, host2; in ef4_farch_filter_to_gen_spec() local
2098 host1 = htonl(spec->data[0] >> 16 | spec->data[1] << 16); in ef4_farch_filter_to_gen_spec()
2103 gen_spec->loc_host[0] = host1; in ef4_farch_filter_to_gen_spec()
2107 gen_spec->rem_host[0] = host1; in ef4_farch_filter_to_gen_spec()
/Linux-v6.1/drivers/net/ethernet/sfc/siena/
Dfarch.c2053 __be32 rhost, host1, host2; in efx_farch_filter_from_gen_spec() local
2083 host1 = rhost; in efx_farch_filter_from_gen_spec()
2092 spec->data[0] = ntohl(host1) << 16 | ntohs(port1); in efx_farch_filter_from_gen_spec()
2093 spec->data[1] = ntohs(port2) << 16 | ntohl(host1) >> 16; in efx_farch_filter_from_gen_spec()
2151 __be32 host1, host2; in efx_farch_filter_to_gen_spec() local
2167 host1 = htonl(spec->data[0] >> 16 | spec->data[1] << 16); in efx_farch_filter_to_gen_spec()
2172 gen_spec->loc_host[0] = host1; in efx_farch_filter_to_gen_spec()
2176 gen_spec->rem_host[0] = host1; in efx_farch_filter_to_gen_spec()
/Linux-v6.1/Documentation/networking/
Dipvlan.rst142 | Host: host1 |
/Linux-v6.1/arch/arm64/boot/dts/rockchip/
Drk3328-roc-cc.dts63 vcc_host1_5v: vcc_otg_5v: vcc-host1-5v-regulator {
Drk3399-eaidk-610.dts202 vcc5v0_host1: vcc5v0-host1-regulator {
735 vcc5v0_host1_en: vcc5v0-host1-en {
Drk3328-rock64.dts51 vcc_host1_5v: vcc_otg_5v: vcc-host1-5v-regulator {

12