| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | msm8996-xiaomi-natrium.dts | 199 "VOL_UP_N", /* GPIO_2 */
237 "SPKR_PA_EN", /* GPIO_2 */
252 "NC", /* GPIO_2 */
|
| D | msm8996-xiaomi-gemini.dts | 239 "VOL_UP_N", /* GPIO_2 */
284 "SPKR_PA_RST", /* GPIO_2 */
299 "ERR_INT_N", /* GPIO_2 */
|
| D | msm8996-xiaomi-scorpio.dts | 260 "VOL_UP_N", /* GPIO_2 */
307 "SPKR_PA_RST", /* GPIO_2 */
322 "NC", /* GPIO_2 */
|
| D | apq8016-sbc.dts | 600 "[UART0_CTS_N]", /* GPIO_2, LSEC pin 3 */
|
| /Linux-v6.1/include/linux/mfd/da9055/ |
| D | pdata.h | 15 GPIO_2 enumerator
|
| /Linux-v6.1/drivers/media/pci/cx23885/ |
| D | cx23885-cards.c | 1560 cx23885_gpio_enable(dev, GPIO_2, 1); in cx23885_gpio_setup()
1561 cx23885_gpio_set(dev, GPIO_2); in cx23885_gpio_setup()
1563 cx23885_gpio_clear(dev, GPIO_2); in cx23885_gpio_setup()
1565 cx23885_gpio_set(dev, GPIO_2); in cx23885_gpio_setup()
1718 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1 | GPIO_2, 1); in cx23885_gpio_setup()
1719 cx23885_gpio_clear(dev, GPIO_1 | GPIO_2); in cx23885_gpio_setup()
1721 cx23885_gpio_set(dev, GPIO_0 | GPIO_1 | GPIO_2); in cx23885_gpio_setup()
1839 cx23885_gpio_enable(dev, GPIO_2 | GPIO_11, 1); in cx23885_gpio_setup()
1840 cx23885_gpio_clear(dev, GPIO_2 | GPIO_11); in cx23885_gpio_setup()
1842 cx23885_gpio_set(dev, GPIO_2 | GPIO_11); in cx23885_gpio_setup()
[all …]
|
| D | cx23885-f300.c | 22 #define F300_CLK GPIO_2
|
| D | cx23885.h | 108 #define GPIO_2 0x00000004 macro
|
| /Linux-v6.1/arch/mips/boot/dts/mscc/ |
| D | serval.dtsi | 105 pins = "GPIO_0", "GPIO_2", "GPIO_3", "GPIO_1";
|
| /Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
| D | mscc,ocelot.yaml | 119 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | mediatek,mt7622-pinctrl.yaml | 286 PWM_0, GPIO_0, GPIO_1, GPIO_2, GPIO_3, GPIO_4, GPIO_5,
|
| D | mediatek,mt7986-pinctrl.yaml | 259 GPIO_1, GPIO_2, GPIO_3, GPIO_4, GPIO_5, GPIO_6, GPIO_7,
|
| /Linux-v6.1/arch/arm64/boot/dts/actions/ |
| D | s900-bubblegum-96.dts | 96 "GPIO-C", /* GPIO_2, LSEC pin 25 */
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | logicpd-som-lv.dtsi | 262 OMAP3_WKUP_IOPAD(0x2a0a, PIN_INPUT | MUX_MODE4) /* sys_boot0.gpio_2 */
|
| D | logicpd-torpedo-baseboard.dtsi | 318 OMAP3_WKUP_IOPAD(0x2a0a, PIN_INPUT_PULLUP | MUX_MODE4) /* sys_boot0.gpio_2 */
|
| /Linux-v6.1/drivers/media/usb/em28xx/ |
| D | em28xx-cards.c | 350 * GPIO_2 - VUV_LNB (red LED)
432 * GPIO_2: decoder reset, 0=active
439 {EM2874_R80_GPIO_P0_CTRL, 0x14, 0xff, 100}, /* GPIO_2 = 1 */
446 * GPIO_2: decoder reset, 0=active
453 {EM2874_R80_GPIO_P0_CTRL, 0x14, 0xff, 100}, /* GPIO_2 = 1 */
463 * GPIO_2: AV mute button, 0=pressed, 1=unpressed
523 * GPIO_2: Yellow LED tuner 2, 0=on, 1=off
|
| /Linux-v6.1/arch/arm64/boot/dts/microchip/ |
| D | sparx5.dtsi | 238 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
| /Linux-v6.1/drivers/pinctrl/intel/ |
| D | pinctrl-broxton.c | 39 PINCTRL_PIN(2, "GPIO_2"),
538 PINCTRL_PIN(2, "GPIO_2"),
|
| /Linux-v6.1/drivers/pinctrl/mediatek/ |
| D | pinctrl-mt7629.c | 170 MT7629_PIN(55, "GPIO_2", 2),
|
| D | pinctrl-mt7986.c | 433 MT7986_PIN(7, "GPIO_2"),
537 MT7986_PIN(7, "GPIO_2"),
|
| /Linux-v6.1/include/linux/mfd/ |
| D | idt8a340_reg.h | 285 #define GPIO_2 0xc8e6 macro
|
| /Linux-v6.1/drivers/pinctrl/qcom/ |
| D | pinctrl-mdm9615.c | 19 PINCTRL_PIN(2, "GPIO_2"),
|
| D | pinctrl-ipq8064.c | 16 PINCTRL_PIN(2, "GPIO_2"),
|
| D | pinctrl-apq8064.c | 16 PINCTRL_PIN(2, "GPIO_2"),
|
| D | pinctrl-msm8226.c | 16 PINCTRL_PIN(2, "GPIO_2"),
|
