| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | msm8996-xiaomi-natrium.dts | 198 "NC", /* GPIO_1 */
236 "NC", /* GPIO_1 */
251 "ESE_SPI_MISO", /* GPIO_1 */
|
| D | msm8996-xiaomi-gemini.dts | 238 "NC", /* GPIO_1 */
283 "NC", /* GPIO_1 */
298 "ESE_SPI_MISO", /* GPIO_1 */
|
| D | msm8996-xiaomi-scorpio.dts | 259 "NC", /* GPIO_1 */
306 "NC", /* GPIO_1 */
321 "ESE_SPI_MISO", /* GPIO_1 */
|
| D | apq8016-sbc.dts | 599 "[UART0_RX]", /* GPIO_1, LSEC pin 7 */
|
| /Linux-v6.1/include/linux/mfd/da9055/ |
| D | pdata.h | 14 GPIO_1, enumerator
|
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-sx150x.txt | 59 interrupt-parent = <&gpio_1>;
|
| D | mediatek,mt7622-pinctrl.yaml | 286 PWM_0, GPIO_0, GPIO_1, GPIO_2, GPIO_3, GPIO_4, GPIO_5,
|
| D | mediatek,mt7986-pinctrl.yaml | 259 GPIO_1, GPIO_2, GPIO_3, GPIO_4, GPIO_5, GPIO_6, GPIO_7,
|
| /Linux-v6.1/arch/mips/boot/dts/mscc/ |
| D | serval.dtsi | 105 pins = "GPIO_0", "GPIO_2", "GPIO_3", "GPIO_1";
|
| /Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
| D | mscc,ocelot.yaml | 119 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
| /Linux-v6.1/drivers/media/pci/cx23885/ |
| D | cx23885-f300.c | 21 #define F300_RESET GPIO_1
|
| D | cx23885-cards.c | 1718 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1 | GPIO_2, 1); in cx23885_gpio_setup()
1719 cx23885_gpio_clear(dev, GPIO_1 | GPIO_2); in cx23885_gpio_setup()
1721 cx23885_gpio_set(dev, GPIO_0 | GPIO_1 | GPIO_2); in cx23885_gpio_setup()
1727 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1, 1); in cx23885_gpio_setup()
1728 cx23885_gpio_clear(dev, GPIO_0 | GPIO_1); in cx23885_gpio_setup()
1730 cx23885_gpio_set(dev, GPIO_0 | GPIO_1); in cx23885_gpio_setup()
|
| D | cx23885-dvb.c | 614 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1, 1); in dvbsky_t9580_set_voltage()
618 cx23885_gpio_set(dev, GPIO_1); in dvbsky_t9580_set_voltage()
622 cx23885_gpio_set(dev, GPIO_1); in dvbsky_t9580_set_voltage()
626 cx23885_gpio_clear(dev, GPIO_1); in dvbsky_t9580_set_voltage()
|
| D | cx23885.h | 107 #define GPIO_1 0x00000002 macro
|
| /Linux-v6.1/arch/arm64/boot/dts/marvell/ |
| D | armada-7040-db.dts | 137 * IO0_5: GPIO_1 IO1_5: LDO_5V_Enable
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | imx8mn-bsh-smm-s2-common.dtsi | 421 MX8MN_IOMUXC_GPIO1_IO08_GPIO1_IO8 0x0d6 /* GPIO_1 - WIFI_GPIO_1 */
|
| /Linux-v6.1/arch/arm64/boot/dts/actions/ |
| D | s900-bubblegum-96.dts | 95 "GPIO-B", /* GPIO_1, LSEC pin 24 */
|
| /Linux-v6.1/drivers/extcon/ |
| D | extcon-palmas.c | 324 /* remux GPIO_1 as VBUSDET */ in palmas_usb_probe()
|
| /Linux-v6.1/arch/arm64/boot/dts/microchip/ |
| D | sparx5.dtsi | 238 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
| /Linux-v6.1/drivers/pinctrl/intel/ |
| D | pinctrl-broxton.c | 38 PINCTRL_PIN(1, "GPIO_1"),
537 PINCTRL_PIN(1, "GPIO_1"),
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | omap4-panda-common.dtsi | 110 gpio = <&gpio1 1 GPIO_ACTIVE_HIGH>; /* gpio_1 */
|
| /Linux-v6.1/drivers/pinctrl/mediatek/ |
| D | pinctrl-mt7629.c | 169 MT7629_PIN(54, "GPIO_1", 1),
|
| D | pinctrl-mt7986.c | 432 MT7986_PIN(6, "GPIO_1"),
536 MT7986_PIN(6, "GPIO_1"),
|
| /Linux-v6.1/include/linux/mfd/ |
| D | idt8a340_reg.h | 284 #define GPIO_1 0xc8d4 macro
|
| /Linux-v6.1/drivers/pinctrl/qcom/ |
| D | pinctrl-mdm9615.c | 18 PINCTRL_PIN(1, "GPIO_1"),
|
