| /Linux-v6.1/Documentation/devicetree/bindings/gpio/ |
| D | gpio-xgene-sb.txt | 8 | GPIO controller +------ GPIO_0
|
| /Linux-v6.1/arch/mips/boot/dts/mscc/ |
| D | serval.dtsi | 105 pins = "GPIO_0", "GPIO_2", "GPIO_3", "GPIO_1";
|
| /Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
| D | mscc,ocelot.yaml | 119 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
| /Linux-v6.1/drivers/media/pci/cx23885/ |
| D | cx23885-f300.c | 20 #define F300_DATA GPIO_0
|
| D | cx23885-cards.c | 1718 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1 | GPIO_2, 1); in cx23885_gpio_setup()
1721 cx23885_gpio_set(dev, GPIO_0 | GPIO_1 | GPIO_2); in cx23885_gpio_setup()
1727 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1, 1); in cx23885_gpio_setup()
1728 cx23885_gpio_clear(dev, GPIO_0 | GPIO_1); in cx23885_gpio_setup()
1730 cx23885_gpio_set(dev, GPIO_0 | GPIO_1); in cx23885_gpio_setup()
|
| D | cx23885-dvb.c | 614 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1, 1); in dvbsky_t9580_set_voltage()
619 cx23885_gpio_clear(dev, GPIO_0); in dvbsky_t9580_set_voltage()
623 cx23885_gpio_set(dev, GPIO_0); in dvbsky_t9580_set_voltage()
627 cx23885_gpio_clear(dev, GPIO_0); in dvbsky_t9580_set_voltage()
757 cx23885_gpio_set(dev, GPIO_0); in cx23885_dvb_set_frontend()
|
| D | cx23885.h | 106 #define GPIO_0 0x00000001 macro
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | omap4-panda-common.dtsi | 148 powerdown-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; /* gpio_0 */
293 OMAP4_IOPAD(0x184, PIN_OUTPUT | MUX_MODE3) /* gpio_0 */
|
| /Linux-v6.1/arch/arm64/boot/dts/marvell/ |
| D | armada-7040-db.dts | 136 * IO0_4: GPIO_0 IO1_4: SD_Status
|
| /Linux-v6.1/drivers/media/tuners/ |
| D | tda8290.c | 372 set_gpio_cf[1] &= 0xf0; /* clear GPIO_0 bits 3-0 */ in tda8295_agc2_out()
375 set_gpio_cf[1] |= 0x01; /* config GPIO_0 as Open Drain Out */ in tda8295_agc2_out()
376 set_gpio_val[1] &= 0xfe; /* set GPIO_0 pin low */ in tda8295_agc2_out()
|
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | mediatek,mt7622-pinctrl.yaml | 286 PWM_0, GPIO_0, GPIO_1, GPIO_2, GPIO_3, GPIO_4, GPIO_5,
|
| D | mediatek,mt7986-pinctrl.yaml | 258 enum: [SYS_WATCHDOG, WF2G_LED, WF5G_LED, I2C_SCL, I2C_SDA, GPIO_0,
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | imx8mn-bsh-smm-s2-common.dtsi | 420 MX8MN_IOMUXC_GPIO1_IO00_GPIO1_IO0 0x0d6 /* GPIO_0 - WIFI_GPIO_0 */
|
| /Linux-v6.1/arch/arm64/boot/dts/actions/ |
| D | s900-bubblegum-96.dts | 94 "GPIO-A", /* GPIO_0, LSEC pin 23 */
|
| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | msm8996-xiaomi-natrium.dts | 250 "ESE_SPI_MOSI", /* GPIO_0 */
|
| D | msm8996-xiaomi-gemini.dts | 297 "ESE_SPI_MOSI", /* GPIO_0 */
|
| D | msm8996-xiaomi-scorpio.dts | 320 "ESE_SPI_MOSI", /* GPIO_0 */
|
| D | apq8016-sbc.dts | 598 "[UART0_TX]", /* GPIO_0, LSEC pin 5 */
|
| /Linux-v6.1/arch/arm64/boot/dts/microchip/ |
| D | sparx5.dtsi | 238 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
| /Linux-v6.1/drivers/pinctrl/intel/ |
| D | pinctrl-broxton.c | 37 PINCTRL_PIN(0, "GPIO_0"),
536 PINCTRL_PIN(0, "GPIO_0"),
|
| /Linux-v6.1/drivers/pinctrl/mediatek/ |
| D | pinctrl-mt7629.c | 168 MT7629_PIN(53, "GPIO_0", 0),
|
| D | pinctrl-mt7986.c | 431 MT7986_PIN(5, "GPIO_0"),
535 MT7986_PIN(5, "GPIO_0"),
|
| /Linux-v6.1/include/linux/mfd/ |
| D | idt8a340_reg.h | 265 #define GPIO_0 0xc8c2 macro
|
| /Linux-v6.1/drivers/pinctrl/qcom/ |
| D | pinctrl-mdm9615.c | 17 PINCTRL_PIN(0, "GPIO_0"),
|
| D | pinctrl-ipq8064.c | 14 PINCTRL_PIN(0, "GPIO_0"),
|
