| /Linux-v5.10/drivers/zorro/ |
| D | zorro.ids | 18 0000 Golem RAM Box 2MB [RAM Expansion]
22 1300 Warp Engine [Accelerator, SCSI Host Adapter and RAM Expansion]
24 0200 Megamix 2000 [RAM Expansion]
36 0a00 A590/A2052/A2058/A2091 [RAM Expansion]
37 2000 A560 [RAM Expansion]
40 5000 A2620 68020 [Accelerator and RAM Expansion]
41 5100 A2630 68030 [Accelerator and RAM Expansion]
45 6100 A3000 Test Fixture [Miscellaneous Expansion Card]
51 0200 EXP8000 [RAM Expansion]
64 0100 AX2000 [RAM Expansion]
[all …]
|
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | socfpga_cyclone5_chameleon96.dts | 73 /* On Low speed expansion */
79 /* On Low speed expansion */
89 /* On High speed expansion */
101 /* On High speed expansion */
107 /* On Low speed expansion */
113 /* On Low speed expansion */
119 /* On Low speed expansion */
|
| D | stih410-b2260.dts | 80 /* Low speed expansion connector */
91 /* Low speed expansion connector */
97 /* Low speed expansion connector */
104 /* Low speed expansion connector */
110 /* Low speed expansion connector */
116 /* high speed expansion connector */
123 /* high speed expansion connector */
136 /* high speed expansion connector */
|
| D | am3517-craneboard.dts | 47 /* goes to expansion connector */
53 /* goes to expansion connector */
63 /* goes to expansion connector */
68 /* goes to expansion connector */
|
| D | am335x-base0033.dts | 3 * am335x-base0033.dts - Device Tree file for IGEP AQUILA EXPANSION
11 model = "IGEP COM AM335x on AQUILA Expansion";
|
| /Linux-v5.10/arch/mips/include/uapi/asm/ |
| D | stat.h | 54 unsigned long st_pad0[3]; /* Reserved for st_dev expansion */
65 unsigned long st_pad1[3]; /* Reserved for st_rdev expansion */
74 unsigned long st_atime_nsec; /* Reserved for st_atime expansion */
77 unsigned long st_mtime_nsec; /* Reserved for st_mtime expansion */
80 unsigned long st_ctime_nsec; /* Reserved for st_ctime expansion */
95 unsigned int st_pad0[3]; /* Reserved for st_dev expansion */
106 unsigned int st_pad1[3]; /* Reserved for st_rdev expansion */
|
| /Linux-v5.10/arch/mips/include/asm/mach-loongson2ef/cs5536/ |
| D | cs5536_pci.h | 36 /********** STANDARD PCI-2.2 EXPANSION ****************/
99 /* EXPANSION ROM BAR */
115 /*********** EXPANSION PCI REG ************************/
118 * ISA EXPANSION
125 * IDE EXPANSION
136 * ACC EXPANSION
141 * OHCI EXPANSION : INTTERUPT IS IMPLEMENTED BY THE OHCI
147 * EHCI EXPANSION
|
| /Linux-v5.10/arch/arm64/boot/dts/marvell/ |
| D | armada-8040-db.dts | 104 /* CON6 on CP0 expansion */
111 /* CON5 on CP0 expansion */
142 /* CON4 on CP0 expansion */
156 /* CON9 on CP0 expansion */
169 /* CON10 on CP0 expansion */
204 /* CON6 on CP1 expansion */
211 /* CON7 on CP1 expansion */
218 /* CON5 on CP1 expansion */
295 /* CON4 on CP1 expansion */
309 /* CON9 on CP1 expansion */
[all …]
|
| /Linux-v5.10/drivers/mtd/maps/ |
| D | intel_vr_nor.c | 4 * An MTD map driver for a NOR flash bank on the Expansion Bus of the Intel
7 * The Vermilion Range Expansion Bus supports four chip selects, each of which
8 * has 64MiB of address space. The 2nd BAR of the Expansion Bus PCI Device
13 * (either 8 bits or 16 bits) is determined by reading the Expansion Bus Timing
49 /* Expansion Bus Configuration and Status Registers are in BAR 0 */
51 /* Expansion Bus Memory Window is BAR 1 */
142 dev_warn(&p->dev->dev, "Expansion Bus Chip Select 0 " in vr_nor_init_maps()
148 dev_warn(&p->dev->dev, "Expansion Bus Chip Select 0 " in vr_nor_init_maps()
|
| /Linux-v5.10/arch/arm/mach-sa1100/include/mach/ |
| D | badge4.h | 20 #define BADGE4_GPIO_INT_VID GPIO_GPIO1 /* Video expansion */
29 #define BADGE4_GPIO_GPA_VID GPIO_GPIO10 /* Video expansion */
30 #define BADGE4_GPIO_GPB_VID GPIO_GPIO11 /* Video expansion */
31 #define BADGE4_GPIO_GPC_VID GPIO_GPIO12 /* Video expansion */
|
| /Linux-v5.10/include/media/davinci/ |
| D | vpbe_osd.h | 81 * @H_EXP_OFF: no expansion (1/1)
82 * @H_EXP_9_OVER_8: 9/8 expansion ratio
83 * @H_EXP_3_OVER_2: 3/2 expansion ratio
86 * An enumeration of the available horizontal expansion ratios.
96 * @V_EXP_OFF: no expansion (1/1)
97 * @V_EXP_6_OVER_5: 6/5 expansion ratio
100 * An enumeration of the available vertical expansion ratios.
|
| /Linux-v5.10/arch/m68k/ |
| D | Kconfig.bus | 11 Say Y here to enable support for the "DIO" expansion bus used in
25 expansion cards in your Amiga that conform to the Amiga
27 expansion cards that do not fit in the Zorro slots but fit in e.g.
|
| /Linux-v5.10/arch/arm/mach-rpc/ |
| D | ecard.c | 7 * Find all installed expansion cards, and handle interrupts from them.
11 * 08-Dec-1996 RMK Added code for the 9'th expansion card - the ether
17 * 29-Sep-1997 RMK Expansion card interrupt hardware not being re-enabled
107 /* ===================== Expansion card daemon ======================== */
109 * Since the loader programs on the expansion cards need to be run
196 * expansion card loader programs. in ecard_task_readbytes()
212 * Set up the expansion card daemon's page tables.
287 * Wake the expansion card daemon to action our request.
423 * Enable and disable interrupts from expansion cards.
497 printk("Expansion card IRQ state:\n"); in ecard_dump_irq_state()
[all …]
|
| D | ecard-loader.S | 16 @ Purpose: call an expansion card loader to read bytes.
29 @ Purpose: call an expansion card loader to reset the card
|
| /Linux-v5.10/include/linux/ |
| D | brcmphy.h | 91 #define MII_BCM54XX_EXP_DATA 0x15 /* Expansion register data */
92 #define MII_BCM54XX_EXP_SEL 0x17 /* Expansion register select */
94 #define MII_BCM54XX_EXP_SEL_ER 0x0f00 /* Expansion register select */
95 #define MII_BCM54XX_EXP_SEL_ETC 0x0d00 /* Expansion register spare + 2k mem */
124 /* legacy access control via rdb/expansion register */
166 * Broadcom Multicolor LED configurations (expansion register 4)
228 * EXPANSION SHADOW ACCESS REGISTERS. (PHY REG 0x15, 0x16, and 0x17)
|
| /Linux-v5.10/arch/arm/mach-ixp4xx/include/mach/ |
| D | platform.h | 29 * Expansion bus memory regions
34 * The expansion bus on the IXP4xx can be configured for either 16 or
37 * each offset. ixp4xx_sys_init() looks at the expansion bus configuration
|
| /Linux-v5.10/drivers/scsi/qla2xxx/ |
| D | qla_devtbl.h | 61 "QMC2462", "IBM eServer BC 4Gb FC Expansion Card", /* 0x135 */
62 "QMC2462S", "IBM eServer BC 4Gb FC Expansion Card SFF", /* 0x136 */
84 "QMC2432M", "IBM eServer BC 4Gb FC Expansion Card CFFE", /* 0x14c */
85 "QMC2422M", "IBM eServer BC 4Gb FC Expansion Card CFFX", /* 0x14d */
|
| /Linux-v5.10/arch/arm/include/asm/ |
| D | ecard.h | 5 * definitions for expansion cards
137 * This contains all the info needed on an expansion card
180 * Read a chunk from an expansion card
182 * ec : expansion card info struct
|
| /Linux-v5.10/Documentation/virt/kvm/ |
| D | nested-vmx.rst | 91 u32 padding[7]; /* room for future expansion */
114 u64 padding64[8]; /* room for future expansion */
154 natural_width paddingl[8]; /* room for future expansion */
201 u32 padding32[8]; /* room for future expansion */
|
| /Linux-v5.10/drivers/parisc/ |
| D | README.dino | 6 ** equipped with third-party or customer-installed PCI I/O expansion
9 ** when data is transmitted through PCI I/O expansion cards on the
|
| /Linux-v5.10/arch/arm64/boot/dts/hisilicon/ |
| D | hi3660-hikey960.dts | 213 * from Huawei. The 40 pin low speed expansion connector is named
218 * Appendix "Expansion Connector Signal Description".
522 /* On Low speed expansion */
591 /* On Low speed expansion */
597 /* On Low speed expansion */
613 /* On Low speed expansion */
619 /* On Low speed expansion */
625 /* On High speed expansion */
|
| /Linux-v5.10/scripts/kconfig/ |
| D | preprocess.c | 265 pperror("Too deep recursive expansion"); in variable_expand()
448 * and returns a new string containing the expansion (note that the string is
499 char *expansion, *out; in __expand_string() local
512 expansion = expand_dollar_with_args(&p, argc, argv); in __expand_string()
513 out_len += in_len + strlen(expansion); in __expand_string()
516 strcat(out, expansion); in __expand_string()
517 free(expansion); in __expand_string()
|
| /Linux-v5.10/drivers/staging/comedi/drivers/ |
| D | plx9080.h | 135 /* Direct Slave Expansion ROM Big Endian Mode */
149 * Note: The Expansion ROM stuff is only relevant to the PC environment.
150 * This expansion ROM code is executed by the host CPU at boot time.
154 /* Expansion ROM Range Register */
156 /* Expansion ROM Local Base Address (Remap) Register */
159 /* Local Address Space 0/Expansion ROM Bus Region Descriptor Register */
182 /* Expansion ROM Space Prefetch Disable (LBRD0 only) */
192 /* Expansion ROM Space Local Bus Width (LBRD0 only) */
198 /* Expansion ROM Space Internal Wait States (LBRD0 only) */
202 /* Expansion ROM Space Ready Input Enable (LBDR0 only) */
[all …]
|
| /Linux-v5.10/Documentation/devicetree/bindings/sound/ |
| D | ti,j721e-cpb-ivi-audio.yaml | 17 The audio support on the Infotainment Expansion Board consists of McASP0
64 description: phandle to the pcm3168a-A codec on the expansion board
68 description: phandle to the pcm3168a-B codec on the expansion board
|
| /Linux-v5.10/drivers/usb/serial/ |
| D | io_ionsp.h | 146 // 08 available for expansion
148 // 0A available for expansion
149 // 0B available for expansion
164 // 0x08 // Available for expansion.
352 // 0B available for expansion
385 // 0x02 // Available for future expansion
422 // 0x0B // Available for future expansion
|
