Searched full:celsius (Results 1 – 25 of 277) sorted by relevance
12345678910>>...12
| /Linux-v6.1/Documentation/devicetree/bindings/power/supply/ |
| D | battery.yaml | 91 - description: the temperature in degree Celsius
94 A table providing the temperature in degree Celsius
99 ocv-capacity-celsius:
101 An array containing the temperature in degree Celsius,
104 operating-range-celsius:
110 ambient-celsius:
116 alert-celsius:
162 ocv-capacity-celsius = <(-10) 0 10>;
163 /* table for -10 degree Celsius */
165 /* table for 0 degree Celsius */
[all …]
|
| D | maxim,max77693.yaml | 42 maxim,thermal-regulation-celsius:
44 Temperature in Celsius for entering high temperature charging mode.
46 reduced by 105 mA/Celsius.
|
| D | summit,smb347-charger.yaml | 64 summit,chip-temperature-threshold-celsius:
158 summit,chip-temperature-threshold-celsius = <110>;
180 operating-range-celsius = <0 45>;
181 alert-celsius = <3 42>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/afe/ |
| D | temperature-sense-rtd.yaml | 15 (usually 0 to 100 degrees Celsius).
62 alpha-ppm-per-celsius:
64 alpha can also be expressed in micro-ohms per ohm Celsius. It's a linear
66 between 0 and 100 degrees Celsius.
70 Where, R_100 is the resistance of the sensor at 100 degrees Celsius, and
72 Celsius.
79 Resistance of the sensor at 0 degrees Celsius.
87 - alpha-ppm-per-celsius
98 alpha-ppm-per-celsius = <3908>;
|
| D | temperature-transducer.yaml | 67 This offset is commonly used to convert from Kelvins to degrees Celsius.
78 alpha-ppm-per-celsius:
83 degrees Celsius or micro-volts per degrees Celsius. The is the main
92 - alpha-ppm-per-celsius
101 sense-offset-millicelsius = <(-273150)>; /* Kelvin to degrees Celsius */
103 alpha-ppm-per-celsius = <1>; /* 1 uA/K */
111 sense-offset-millicelsius = <(-273150)>; /* Kelvin to degrees Celsius */
112 alpha-ppm-per-celsius = <4000>; /* 4 mV/K */
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | ds1621.rst | 67 degree Celsius to +125 in 0.5 increments. You may convert this into a
83 1.0 degree Celsius to avoid Tout "bouncing", though!
125 - DS1621: +/- 0.5 degree Celsius (from 0 to +70 degrees)
126 - DS1625: +/- 0.5 degree Celsius (from 0 to +70 degrees)
127 - DS1631: +/- 0.5 degree Celsius (from 0 to +70 degrees)
128 - DS1721: +/- 1.0 degree Celsius (from -10 to +85 degrees)
129 - DS1731: +/- 1.0 degree Celsius (from -10 to +85 degrees)
146 0 0 9 bits, 0.5 degrees Celsius
147 1 0 10 bits, 0.25 degrees Celsius
148 0 1 11 bits, 0.125 degrees Celsius
[all …]
|
| D | w83773g.rst | 26 Temperature is measured in degrees Celsius.
28 range of -40 to +125 degrees Celsius (for local sensor) and -40 to +127
29 degrees Celsius (for remote sensors).
|
| D | sht21.rst | 40 0.2 degree Celsius) compared with the SHT21 (2.0% relative humidity,
41 0.3 degree Celsius).
64 Celsius, the device should not be active for more than 10% of the time,
|
| D | lm70.rst | 56 13-bit temperature data (0.0625 degrees celsius resolution).
61 with 0.25 degrees Celsius resolution.
64 data (0.03125 degrees celsius resolution).
|
| D | ltc2990.rst | 45 temp1_input Internal chip temperature in millidegrees Celsius
53 temp2_input External temperature sensor TR1 in millidegrees Celsius
54 temp3_input External temperature sensor TR2 in millidegrees Celsius
|
| D | nct6775.rst | 107 Temperatures are measured in degrees Celsius and measurement resolution is
194 Target temperature, unit millidegree Celsius
198 Target temperature tolerance, unit millidegree Celsius
258 Temperature tolerance, unit millidegree Celsius
262 unit millidegree Celsius
|
| D | bt1-pvt.rst | 47 Celsius. The driver performs all the scaling by itself therefore reports true
91 Celsius.
101 Celsius which is added to the
105 degrees Celsius.
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-class-hwmon | 371 Unit: millidegree Celsius (or millivolt, see below)
379 Unit: millidegree Celsius
387 Unit: millidegree Celsius
397 Unit: millidegree Celsius
408 Unit: millidegree Celsius
417 Unit: millidegree Celsius
439 Unit: millidegree Celsius
452 Unit: millidegree Celsius
460 Unit: millidegree Celsius
472 Unit: millidegree Celsius
[all …]
|
| D | sysfs-class-thermal | 16 Unit: millidegree Celsius
53 Unit: millidegree Celsius
71 Unit: Celsius
110 Unit: millidegree Celsius
167 Unit: millidegree Celsius
|
| /Linux-v6.1/drivers/gpu/drm/amd/pm/swsmu/inc/pmfw_if/ |
| D | smu11_driver_if_vangogh.h | 186 uint16_t CoreTemperature[8]; //[centi-Celsius]
188 uint16_t L3Temperature[2]; //[centi-Celsius]
190 uint16_t GfxTemperature; //[centi-Celsius]
191 uint16_t SocTemperature; //[centi-Celsius]
216 uint16_t CoreTemperature[4]; //[centi-Celsius]
218 uint16_t L3Temperature[1]; //[centi-Celsius]
220 uint16_t GfxTemperature; //[centi-Celsius]
221 uint16_t SocTemperature; //[centi-Celsius]
|
| D | smu11_driver_if_cyan_skillfish.h | 43 uint16_t CoreTemperature[6]; //[centi-Celsius]
45 uint16_t L3Temperature[2]; //[centi-Celsius]
50 uint16_t GfxTemperature; //[centi-Celsius]
64 uint16_t SocTemperature; //[centi-Celsius]
|
| D | smu12_driver_if.h | 191 uint16_t CoreTemperature[8]; //[centi-Celsius]
193 uint16_t L3Temperature[2]; //[centi-Celsius]
195 uint16_t GfxTemperature; //[centi-Celsius]
196 uint16_t SocTemperature; //[centi-Celsius]
|
| D | smu13_driver_if_yellow_carp.h | 176 uint16_t CoreTemperature[8]; //[centi-Celsius]
178 uint16_t L3Temperature; //[centi-Celsius]
180 uint16_t GfxTemperature; //[centi-Celsius]
181 uint16_t SocTemperature; //[centi-Celsius]
|
| D | smu13_driver_if_v13_0_4.h | 176 uint16_t CoreTemperature[8]; //[centi-Celsius]
178 uint16_t L3Temperature; //[centi-Celsius]
180 uint16_t GfxTemperature; //[centi-Celsius]
181 uint16_t SocTemperature; //[centi-Celsius]
200 uint16_t CurTemp; //[centi-Celsius]
|
| /Linux-v6.1/Documentation/driver-api/thermal/ |
| D | exynos_thermal.rst | 40 Trimming info for 25 degree Celsius (stored at TRIMINFO register)
41 Temperature code measured at 25 degree Celsius which is unchanged
43 Trimming info for 85 degree Celsius (stored at TRIMINFO register)
44 Temperature code measured at 85 degree Celsius which is unchanged
|
| /Linux-v6.1/drivers/hwmon/ |
| D | lm70.c | 79 * Further, each bit represents 0.25 degrees Celsius; so, multiply in temp1_input_show()
81 * Celsius. in temp1_input_show()
86 * resolution 0.0625 degrees celsius. in temp1_input_show()
90 * resolution 0.0312 degrees celsius. in temp1_input_show()
95 * data format with a resolution of 0.25 degrees celsius per unit. in temp1_input_show()
118 status = sprintf(buf, "%d\n", val); /* millidegrees Celsius */ in temp1_input_show()
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/temperature/ |
| D | melexis,mlx90632.yaml | 18 Celsius with relative error of measurement below 1 degree Celsius in
21 Celsius it is suitable also for outdoor use.
|
| /Linux-v6.1/include/linux/ |
| D | units.h | 76 * deci_kelvin_to_millicelsius_with_offset - convert Kelvin to Celsius
78 * @offset: difference between Kelvin and Celsius in millidegrees
80 * Return: temperature value in millidegrees Celsius
|
| /Linux-v6.1/drivers/iio/pressure/ |
| D | st_pressure_core.c | 49 * temp[Celsius] = offset[Celsius] + (raw / sensitivity)
52 * offset a constant specified by the datasheet in degree Celsius
54 * sensitivity a scaling factor specified by the datasheet in LSB/Celsius
56 * IIO ABI expects temperature to be expressed as milli degree Celsius such as
58 * temp[mCelsius] = temp[Celsius] * 10^3
59 * = (offset[Celsius] + (raw / sensitivity)) * 10^3
60 * = ((offset[Celsius] * sensitivity) + raw) *
71 * OFFSET = offset[Celsius] * sensitivity (3)
84 * numerator = offset[Celsius] * 10^3 * sensitivity
|
| /Linux-v6.1/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn31/ |
| D | dcn31_smu.h | 185 uint16_t CoreTemperature[8]; //[centi-Celsius]
187 uint16_t L3Temperature; //[centi-Celsius]
189 uint16_t GfxTemperature; //[centi-Celsius]
190 uint16_t SocTemperature; //[centi-Celsius]
|
12345678910>>...12
