| /Linux-v6.6/drivers/mtd/nand/raw/ |
| D | cafe_nand.c | 65 uint32_t ctl1; member
166 uint32_t ctl1; in cafe_nand_cmdfunc() local
175 ctl1 = cafe->ctl1; in cafe_nand_cmdfunc()
177 cafe_dev_dbg(&cafe->pdev->dev, "Continue command, ctl1 %08x, #data %d\n", in cafe_nand_cmdfunc()
178 cafe->ctl1, cafe->nr_data); in cafe_nand_cmdfunc()
212 ctl1 = 0x80000000 | command | (cafe->ctl1 & CTRL1_CHIPSELECT); in cafe_nand_cmdfunc()
216 ctl1 |= (1<<26); /* rd */ in cafe_nand_cmdfunc()
223 ctl1 |= 1<<26; /* rd */ in cafe_nand_cmdfunc()
227 ctl1 |= 1<<25; /* wr */ in cafe_nand_cmdfunc()
231 ctl1 |= ((adrbytes-1)|8) << 27; in cafe_nand_cmdfunc()
[all …]
|
| /Linux-v6.6/drivers/gpu/drm/i915/display/ |
| D | dvo_tfp410.c | 240 u8 ctl1; in tfp410_dpms() local
242 if (!tfp410_readb(dvo, TFP410_CTL_1, &ctl1)) in tfp410_dpms()
246 ctl1 |= TFP410_CTL_1_PD; in tfp410_dpms()
248 ctl1 &= ~TFP410_CTL_1_PD; in tfp410_dpms()
250 tfp410_writeb(dvo, TFP410_CTL_1, ctl1); in tfp410_dpms()
255 u8 ctl1; in tfp410_get_hw_state() local
257 if (!tfp410_readb(dvo, TFP410_CTL_1, &ctl1)) in tfp410_get_hw_state()
260 if (ctl1 & TFP410_CTL_1_PD) in tfp410_get_hw_state()
|
| D | intel_backlight_regs.h | 79 /* PCH CTL1 is totally different, all but the below bits are reserved. CTL2 is
|
| /Linux-v6.6/drivers/rtc/ |
| D | rtc-rzn1.c | 171 u32 ctl1 = readl(rtc->base + RZN1_RTC_CTL1); in rzn1_rtc_alarm_irq_enable() local
174 ctl1 |= RZN1_RTC_CTL1_ALME; in rzn1_rtc_alarm_irq_enable()
176 ctl1 &= ~RZN1_RTC_CTL1_ALME; in rzn1_rtc_alarm_irq_enable()
178 writel(ctl1, rtc->base + RZN1_RTC_CTL1); in rzn1_rtc_alarm_irq_enable()
189 u32 ctl1; in rzn1_rtc_read_alarm() local
211 ctl1 = readl(rtc->base + RZN1_RTC_CTL1); in rzn1_rtc_read_alarm()
212 alrm->enabled = !!(ctl1 & RZN1_RTC_CTL1_ALME); in rzn1_rtc_read_alarm()
|
| D | rtc-hym8563.c | 142 * CTL1 only contains TEST-mode bits apart from stop, in hym8563_rtc_set_time()
|
| /Linux-v6.6/arch/arm/mach-sa1100/ |
| D | neponset.c | 89 GPIO_LOOKUP("neponset-mdm-ctl1", 3, "cts", GPIO_ACTIVE_LOW),
90 GPIO_LOOKUP("neponset-mdm-ctl1", 4, "dsr", GPIO_ACTIVE_LOW),
91 GPIO_LOOKUP("neponset-mdm-ctl1", 5, "dcd", GPIO_ACTIVE_LOW),
101 GPIO_LOOKUP("neponset-mdm-ctl1", 0, "cts", GPIO_ACTIVE_LOW),
102 GPIO_LOOKUP("neponset-mdm-ctl1", 1, "dsr", GPIO_ACTIVE_LOW),
103 GPIO_LOOKUP("neponset-mdm-ctl1", 2, "dcd", GPIO_ACTIVE_LOW),
329 neponset_init_gpio(&d->gpio[2], &dev->dev, "neponset-mdm-ctl1", in neponset_probe()
|
| /Linux-v6.6/drivers/net/wireless/ath/ath9k/ |
| D | ar9002_mac.c | 215 u32 ctl1, ctl6; in ar9002_set_txdesc() local
226 ctl1 = i->buf_len[0] | (i->is_last ? 0 : AR_TxMore); in ar9002_set_txdesc()
256 WRITE_ONCE(ads->ds_ctl1, ctl1); in ar9002_set_txdesc()
261 ctl1 |= (i->keyix != ATH9K_TXKEYIX_INVALID ? SM(i->keyix, AR_DestIdx) : 0) in ar9002_set_txdesc()
272 ctl1 |= AR_IsAggr | AR_MoreAggr; in ar9002_set_txdesc()
276 ctl1 |= AR_IsAggr; in ar9002_set_txdesc()
292 WRITE_ONCE(ads->ds_ctl1, ctl1); in ar9002_set_txdesc()
|
| D | eeprom_4k.c | 123 PR_EEP("Ant. Diversity ctl1", modal_hdr->antdiv_ctl1); in ath9k_dump_4k_modal_eeprom()
|
| /Linux-v6.6/drivers/net/ethernet/broadcom/ |
| D | bgmac.c | 116 u32 ctl1; in bgmac_dma_tx_add_buf() local
121 ctl1 = len & BGMAC_DESC_CTL1_LEN; in bgmac_dma_tx_add_buf()
128 dma_desc->ctl1 = cpu_to_le32(ctl1); in bgmac_dma_tx_add_buf()
217 u32 ctl1 = le32_to_cpu(ring->cpu_base[index].ctl1); in bgmac_dma_tx_add() local
218 int len = ctl1 & BGMAC_DESC_CTL1_LEN; in bgmac_dma_tx_add()
251 u32 ctl0, ctl1; in bgmac_dma_tx_free() local
258 ctl1 = le32_to_cpu(ring->cpu_base[slot_idx].ctl1); in bgmac_dma_tx_free()
259 len = ctl1 & BGMAC_DESC_CTL1_LEN; in bgmac_dma_tx_free()
381 u32 ctl0 = 0, ctl1 = 0; in bgmac_dma_rx_setup_desc() local
385 ctl1 |= BGMAC_RX_BUF_SIZE & BGMAC_DESC_CTL1_LEN; in bgmac_dma_rx_setup_desc()
[all …]
|
| D | bgmac.h | 402 __le32 ctl1; member
|
| /Linux-v6.6/drivers/net/can/mscan/ |
| D | mscan.c | 627 u8 ctl1; in register_mscandev() local
629 ctl1 = in_8(®s->canctl1); in register_mscandev()
631 ctl1 |= MSCAN_CLKSRC; in register_mscandev()
633 ctl1 &= ~MSCAN_CLKSRC; in register_mscandev()
637 ctl1 |= MSCAN_BORM; /* bus-off recovery upon request */ in register_mscandev()
640 ctl1 |= MSCAN_CANE; in register_mscandev()
641 out_8(®s->canctl1, ctl1); in register_mscandev()
|
| /Linux-v6.6/drivers/pci/pcie/ |
| D | aspm.c | 444 u32 ctl1 = 0, ctl2 = 0; in aspm_calc_l12_info() local
480 ctl1 |= t_common_mode << 8 | scale << 29 | value << 16; in aspm_calc_l12_info()
488 if (ctl1 == pctl1 && ctl1 == cctl1 && in aspm_calc_l12_info()
509 PCI_L1SS_CTL1_CM_RESTORE_TIME, ctl1); in aspm_calc_l12_info()
514 PCI_L1SS_CTL1_LTR_L12_TH_SCALE, ctl1); in aspm_calc_l12_info()
517 PCI_L1SS_CTL1_LTR_L12_TH_SCALE, ctl1); in aspm_calc_l12_info()
|
| /Linux-v6.6/Documentation/devicetree/bindings/display/ |
| D | lvds.yaml | 78 CTL1: VSync
|
| /Linux-v6.6/drivers/phy/amlogic/ |
| D | phy-meson8-hdmi-tx.c | 21 * HHI_HDMI_PHY_CNTL0 register. CTL0 and CTL1 is all we know about.
|
| /Linux-v6.6/sound/soc/codecs/ |
| D | cs35l33.h | 24 #define CS35L33_BST_CTL1 0x0B /* Boost Converter CTL1 */
|
| D | cs35l35.h | 27 #define CS35L35_SP_FMT_CTL1 0x0D /* Serial Port Format CTL1 */
|
| /Linux-v6.6/drivers/gpu/drm/msm/disp/mdp5/ |
| D | mdp5_ctl.c | 740 * In bonded DSI case, CTL0 and CTL1 are always assigned to two DSI in mdp5_ctlm_init()
741 * interfaces to support single FLUSH feature (Flush CTL0 and CTL1 when in mdp5_ctlm_init()
|
| /Linux-v6.6/sound/mips/ |
| D | hal2.h | 132 /* Bits in CTL1 register */
|
| /Linux-v6.6/drivers/net/wireless/broadcom/b43/ |
| D | dma.c | 184 u32 ctl0 = 0, ctl1 = 0; in op64_fill_descriptor() local
203 ctl1 |= bufsize & B43_DMA64_DCTL1_BYTECNT; in op64_fill_descriptor()
204 ctl1 |= (addrext << B43_DMA64_DCTL1_ADDREXT_SHIFT) in op64_fill_descriptor()
208 desc->dma64.control1 = cpu_to_le32(ctl1); in op64_fill_descriptor()
|
| /Linux-v6.6/drivers/iio/adc/ |
| D | twl4030-madc.c | 800 dev_err(&pdev->dev, "unable to read reg BCI CTL1 0x%X\n", in twl4030_madc_probe()
808 dev_err(&pdev->dev, "unable to write reg BCI Ctl1 0x%X\n", in twl4030_madc_probe()
|
| /Linux-v6.6/drivers/dma/ |
| D | pch_dma.c | 745 pd->regs.dma_ctl1 = dma_readl(pd, CTL1); in pch_dma_save_regs()
768 dma_writel(pd, CTL1, pd->regs.dma_ctl1); in pch_dma_restore_regs()
|
| /Linux-v6.6/drivers/gpu/drm/loongson/ |
| D | lsdc_regs.h | 323 * data island. The values of CTL0, CTL1, CTL2, and CTL3 indicate the type of
|
| /Linux-v6.6/drivers/spi/ |
| D | spi-sprd.c | 77 /* Bits & mask definition for register CTL1 */
|
| /Linux-v6.6/drivers/net/ethernet/allwinner/ |
| D | sun4i-emac.c | 379 /* set MAC CTL1 */ in emac_setup()
|
| /Linux-v6.6/drivers/net/dsa/mv88e6xxx/ |
| D | chip.c | 164 u16 ctl1; in mv88e6xxx_g1_irq_thread_work() local
185 err = mv88e6xxx_g1_read(chip, MV88E6XXX_G1_CTL1, &ctl1); in mv88e6xxx_g1_irq_thread_work()
193 ctl1 &= GENMASK(chip->g1_irq.nirqs, 0); in mv88e6xxx_g1_irq_thread_work()
194 } while (reg & ctl1); in mv88e6xxx_g1_irq_thread_work()
|
