Home
last modified time | relevance | path

Searched full:bucks (Results 1 – 25 of 44) sorted by relevance

12

/Linux-v6.1/Documentation/devicetree/bindings/regulator/
Drohm,bd71815-regulator.yaml57 comments below for bucks/LDOs which support this. 0 means
77 comments below for bucks/LDOs which support this. 0 means
86 comments below for bucks/LDOs which support this. 0 means
92 # Bucks 1 and 2 support giving separate voltages for operational states
95 # state changes. Omitting these properties from bucks 1 and 2 leave
99 # Bucks 3-5 and ldos 1-5 support setting the RUN state voltage here.
109 # that setting non zero voltages for bucks 1/2 will also enable voltage
Drohm,bd71828-regulator.yaml54 bucks which support this. 0 means disabled.
62 bucks which support this. 0 means disabled.
70 bucks which support this. 0 means disabled.
78 bucks which support this. 0 means disabled.
Dsamsung,s2mpa01.yaml33 # 10 bucks
51 Note: Some bucks share the ramp rate setting i.e. same ramp value
52 will be set for a particular group of bucks so provide the same
Dmaxim,max77802.yaml31 regulators are:: bucks 2-4 and LDOs 1-35. Also, it only takes effect if the
64 bucks supporting the regulator-mode property (changing mode to Low Power
Drohm,bd71847-regulator.yaml62 bucks which support this. 0 means disabled.
70 bucks which support this. 0 means disabled.
78 bucks which support this. 0 means disabled.
Drohm,bd71837-regulator.yaml63 bucks which support this. 0 means disabled.
71 bucks which support this. 0 means disabled.
79 bucks which support this. 0 means disabled.
Dmaxim,max8997.yaml104 When GPIO-DVS mode is used for multiple bucks, changing the voltage value
105 of one of the bucks may affect that of another buck, which is the side
134 # 7 bucks
Dsamsung,s2mps13.yaml33 # 10 bucks
Dsamsung,s2mps11.yaml33 # 10 bucks
Dsamsung,s2mps14.yaml33 # 5 bucks
Dsamsung,s2mps15.yaml33 # 10 bucks
Dsamsung,s2mpu02.yaml33 # 7 bucks
Dmt6315-regulator.yaml14 that contains 4 BUCKs output which can combine with each other
Dmaxim,max77686.yaml54 # 9 bucks
Dsamsung,s5m8767.yaml46 # 8 bucks
/Linux-v6.1/Documentation/devicetree/bindings/mfd/
Dda9062.txt11 da9062-regulator : : LDOs & BUCKs
22 da9062-regulator : : LDOs & BUCKs
53 - regulators : This node defines the settings for the LDOs and BUCKs.
/Linux-v6.1/drivers/regulator/
Dmax77802-regulator.c256 /* BUCKS 1, 6 */
270 /* BUCKs 2-4 */
285 /* BUCKs 5, 7-10 */
340 /* BUCKs 1, 6 */
365 /* BUCKS 2-4 */
412 /* BUCKs 7-10 */
DKconfig275 Say y here to support the BUCKs and LDOs regulators found on
289 Say y here to support the BUCKs and LDOs regulators found on
299 Say y here to support the BUCKs and LDOs regulators found on
309 Say y here to support the BUCKs and LDOs regulators found on
405 21 general purpose LDOs, 3 dedicated LDOs, and 5 BUCKs. All
1170 via I2C bus. S2MPA01 has 10 Bucks and 26 LDO outputs.
1186 via I2C bus. S5M8767A have 9 Bucks and 28 LDOs output and
1411 TPS65219 series of PMICs have 3 single phase BUCKs & 4 LDOs
Dda9063-regulator.c32 /* BUCKs */
44 /* When two BUCKs are merged, they cannot be reused separately */
107 /* Macros for voltage DC/DC converters (BUCKs) */
229 * Bucks use single mode register field for normal operation
841 "Error while reading BUCKs configuration\n"); in da9063_regulator_probe()
Drohm-regulator.c118 * Other bucks and all LDOs must be disabled when voltage is changed.
Dmax77686-regulator.c42 * Values used for configuring LDOs and bucks.
112 /* Some BUCKs and LDOs supports Normal[ON/OFF] mode during suspend */
Dhi6421v530-regulator.c23 * @mode_mask: ECO mode bitmask of LDOs; for BUCKs, this masks sleep
Dlp87565-regulator.c117 /* Operations permitted on BUCKs */
/Linux-v6.1/include/linux/mfd/
D88pm80x.h54 #define PM800_MAX_REGULATOR PM800_ID_RG_MAX /* 5 Bucks, 19 LDOs */
55 #define PM800_NUM_BUCK (5) /*5 Bucks */
56 #define PM800_NUM_LDO (19) /*19 Bucks */
/Linux-v6.1/Documentation/devicetree/bindings/usb/
Dmediatek,mt6360-tcpc.yaml14 regulators (BUCKs/LDOs), and TypeC Port Switch with Power Delivery controller.

12