Searched full:btl (Results 1 – 18 of 18) sorted by relevance
| /Linux-v6.1/arch/x86/realmode/rm/ |
| D | wakeup_asm.S | 98 btl $WAKEUP_BEHAVIOR_RESTORE_MISC_ENABLE, %edi
114 btl $WAKEUP_BEHAVIOR_RESTORE_CR4, %edi
119 btl $WAKEUP_BEHAVIOR_RESTORE_EFER, %edi
|
| D | trampoline_64.S | 124 btl $TH_FLAGS_SME_ACTIVE_BIT, pa_tr_flags
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | richtek,rt9120.yaml | 14 delivering 2*20W into 8 Ohm BTL speaker loads. It supports the wide input
|
| /Linux-v6.1/sound/soc/codecs/ |
| D | jz4760.c | 449 SND_SOC_DAPM_SWITCH("BTL Out", JZ4760_CODEC_REG_PMR2,
553 { "BTL Out", "Switch", "Line Out" },
555 { "BTLP", NULL, "BTL Out"},
556 { "BTLN", NULL, "BTL Out"},
|
| /Linux-v6.1/arch/x86/boot/ |
| D | bitops.h | 30 asm("btl %2,%1" CC_SET(c) : CC_OUT(c) (v) : "m" (*p), "Ir" (nr)); in variable_test_bit()
|
| /Linux-v6.1/arch/x86/include/asm/ |
| D | signal.h | 91 asm("btl %2,%1" CC_SET(c) in __gen_sigismember()
|
| D | percpu.h | 376 asm volatile("btl "__percpu_arg(2)",%1" in x86_this_cpu_variable_test_bit()
|
| /Linux-v6.1/arch/x86/boot/compressed/ |
| D | mem_encrypt.S | 158 btl $1, 12(%esp)
|
| /Linux-v6.1/drivers/net/ethernet/freescale/enetc/ |
| D | enetc_qos.c | 98 gcl_data->btl = cpu_to_le32(lower_32_bits(admin_conf->base_time)); in enetc_setup_taprio()
785 sgcl_data->btl = lower_32_bits(start); in enetc_streamgate_hw_set()
793 sgcl_data->btl = lo; in enetc_streamgate_hw_set()
|
| D | enetc_hw.h | 748 __le32 btl; member
883 u32 btl; member
|
| /Linux-v6.1/arch/x86/kernel/ |
| D | head_32.S | 238 btl $(X86_FEATURE_NX & 31), %edx
|
| D | head_64.S | 303 btl $20,%edi /* No Execute supported? */
|
| /Linux-v6.1/include/sound/ |
| D | hda_verbs.h | 408 /* EAPD/BTL enable - 32bit */
|
| /Linux-v6.1/drivers/misc/habanalabs/include/common/ |
| D | hl_boot_if.h | 359 CPU_BOOT_STATUS_IN_BTL = 4, /* BTL is H/W FSM */
|
| /Linux-v6.1/drivers/gpu/drm/panel/ |
| D | panel-novatek-nt35510.c | 252 * bits 4..5 in the upper nibble controls BTL, the boosting
|
| /Linux-v6.1/drivers/misc/habanalabs/common/ |
| D | firmware_if.c | 1287 "Device boot progress - BTL/ROM did NOT run\n"); in detect_cpu_boot_status()
1295 "Device boot progress - Stuck in BTL\n"); in detect_cpu_boot_status()
|
| /Linux-v6.1/arch/powerpc/xmon/ |
| D | ppc-opc.c | 4110 {"btl-", BBO(16,BOT,0,1), BBOAT_MASK, PPCCOM, PPCVLE, {BI, BDM}},
4111 {"btl+", BBO(16,BOT,0,1), BBOAT_MASK, PPCCOM, PPCVLE, {BI, BDP}},
4112 {"btl", BBO(16,BOT,0,1), BBOAT_MASK, PPCCOM, PPCVLE, {BI, BD}},
|
| /Linux-v6.1/drivers/misc/habanalabs/gaudi/ |
| D | gaudi.c | 4177 /* Restart BTL/BLR upon hard-reset */ in gaudi_hw_fini()
|
