| /Linux-v5.10/Documentation/hwmon/ |
| D | lochnagar.rst | 31 power1_average_interval Power averaging time input valid from 1 to 1708mS
38 power2_average_interval Power averaging time input valid from 1 to 1708mS
45 power3_average_interval Power averaging time input valid from 1 to 1708mS
52 power4_average_interval Power averaging time input valid from 1 to 1708mS
59 power5_average_interval Power averaging time input valid from 1 to 1708mS
64 power6_average_interval Power averaging time input valid from 1 to 1708mS
71 power7_average_interval Power averaging time input valid from 1 to 1708mS
78 power8_average_interval Power averaging time input valid from 1 to 1708mS
|
| D | ina3221.rst | 23 and supply voltage, with programmable conversion times and averaging, current
56 samples Number of samples using in the averaging mode.
|
| D | acpi_power_meter.rst | 53 `power[1-*]_interval` will be notified if the firmware changes the averaging
|
| D | adt7411.rst | 44 no_average Turn off averaging over 16 samples
|
| D | sysfs-interface.rst | 723 Power use averaging interval. A poll
725 hardware changes the averaging interval.
732 Maximum power use averaging interval
739 Minimum power use averaging interval
|
| D | ina2xx.rst | 82 bus and shunt voltage conversion times multiplied by the averaging rate. We
|
| D | lm90.rst | 307 * Conversion averaging.
|
| /Linux-v5.10/Documentation/admin-guide/media/ |
| D | rcar-fdp1.rst | 26 - The current field is scaled vertically by averaging adjacent lines to
28 Averaging (LAV).
31 the current field. This method is also known as Field Averaging (FAV).
|
| /Linux-v5.10/Documentation/devicetree/bindings/input/touchscreen/ |
| D | ad7879.txt | 29 - adi,averaging : 0: 2 middle values (1 if median disabled)
51 adi,averaging = /bits/ 8 <1>;
69 adi,averaging = /bits/ 8 <1>;
|
| /Linux-v5.10/Documentation/devicetree/bindings/mfd/ |
| D | allwinner,sun4i-a10-ts.yaml | 48 Select median and averaging filter. Sample used for median /
49 averaging filter:
|
| /Linux-v5.10/drivers/input/touchscreen/ |
| D | ad7877.c | 174 u8 averaging; member
330 * The preprocessing function consists of an averaging filter. in ad7877_process_data()
331 * The combination of 'first conversion delay' and averaging provides a robust solution, in ad7877_process_data()
333 * The size of the averaging filter is programmable. (dev.platform_data, see linux/spi/ad7877.h) in ad7877_process_data()
625 AD7877_AVG(ts->averaging) | AD7877_PM(1) | in ad7877_setup_ts_def_msg()
726 ts->averaging = pdata->averaging; in ad7877_probe()
|
| D | ad7879.c | 123 u8 averaging; member
181 * The preprocessing function consists of a median and an averaging in ad7879_report()
508 device_property_read_u8(dev, "adi,averaging", &ts->averaging); in ad7879_parse_dt()
597 AD7879_AVG(ts->averaging) | in ad7879_probe()
|
| D | sun4i-ts.c | 261 * parameters are based on the averaging of the calibration in sun4i_ts_probe()
330 * Enable median and averaging filter, optional property for in sun4i_ts_probe()
|
| /Linux-v5.10/drivers/iio/temperature/ |
| D | max31856.c | 78 int averaging; member
129 reg_cr1_val |= data->averaging << MAX31856_AVERAGING_SHIFT; in max31856_init()
240 *val = 1 << data->averaging; in max31856_read_raw()
281 data->averaging = msb; in max31856_write_raw()
|
| /Linux-v5.10/include/linux/ |
| D | led-lm3530.h | 24 #define LM3530_ALS_AVRG_TIME_32ms (0) /* ALS Averaging Time */
86 * @als_avrg_time: ALS input averaging time
|
| /Linux-v5.10/include/linux/spi/ |
| D | ad7877.h | 22 u8 averaging; /* 0 = 1, 1 = 4, 2 = 8, 3 = 16 */ member
|
| /Linux-v5.10/drivers/iio/adc/ |
| D | max1027.c | 52 /* averaging register */
506 /* Disable averaging */ in max1027_probe()
510 dev_err(&indio_dev->dev, "Failed to configure averaging register\n"); in max1027_probe()
|
| D | ad7298.c | 33 #define AD7298_TAVG BIT(1) /* temperature sensor averaging enable */
|
| /Linux-v5.10/drivers/misc/echo/ |
| D | echo.h | 135 /* Average levels and averaging filter states */
|
| /Linux-v5.10/include/linux/mfd/ |
| D | ti_am335x_tscadc.h | 152 * max num cycles = open delay + (sample delay + conv time) * averaging
|
| /Linux-v5.10/drivers/hwmon/ |
| D | ina2xx.c | 71 /* bit mask for reading the averaging setting in the configuration register */
148 * Available averaging rates for ina226. The indices correspond with
|
| /Linux-v5.10/drivers/net/wireless/intel/iwlwifi/dvm/ |
| D | dev.h | 51 * Also, -127 works better than 0 when averaging frames with/without
52 * noise info (e.g. averaging might be done in app); measured dBm values are
|
| /Linux-v5.10/drivers/net/wireless/intel/iwlegacy/ |
| D | 3945.h | 43 * Also, -127 works better than 0 when averaging frames with/without
44 * noise info (e.g. averaging might be done in app); measured dBm values are
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/adc/ |
| D | qcom,spmi-vadc.yaml | 137 Averaging provides the option to obtain a single measurement
|
| /Linux-v5.10/drivers/iio/imu/inv_icm42600/ |
| D | inv_icm42600.h | 89 /* Low-Power mode sensor data filter (averaging) */
|
