Searched full:atf (Results 1 – 24 of 24) sorted by relevance
57 /* For ATF to send events to kernel, there is no dedicated interrupt59 * SW_INT so that ATF triggers this interrupt after processing of
163 /* scratchx(0) CSR used for ATF->non-secure SW communication.236 /* scratchx(1) CSR used for non-secure SW->ATF communication
98 /* UART should keep working in ATF after suspend and before resume */110 /* SRAMB is used as ATF runtime memory, and should be always on */
22 The ATF smc function id used by the firmware.
53 /* DDR3 ATF default */
35 assigned-clock-rates = <125000000>; /* Clock PLL4 to 750Mhz in ATF/U-Boot */
17 * @set_pll_mode: Whether an IOCTL_SET_PLL_FRAC_MODE request be sent to ATF259 * that has been sent to ATF. in zynqmp_pll_enable()
69 * the value from ATF instead. in imx8mq_soc_revision()
12 ATF | |
87 /* Some bits of BCMA_IOCTL set by HW/ATF and should not change */ in platform_bgmac_clk_enable()
23 /* UUID used to probe ATF service. */
428 /* UUID used to probe ATF service. */
265 * or for example ATF will prevent a suspend from completing. in mtk_gpt_suspend()
153 /* Shared with ATF on this platform */
23 atf-sram@0 {
17 atf-sram@0 {
33 atf-sram@0 {
33 execution environments. e.g. ATF.
712 /* Follow the same order than what the Cortex-M3 does (ATF code) */ in armada_3700_periph_clock_resume()
129 * (no direct communication with ATF).
2956 /* ATF configuration.2957 * 1 - Enable ATF2958 * 0 - Disable ATF
667 * As per comment in ATF source code:
1114 type = "83977ATF"; in decode_winbond()1133 type = "83877ATF"; in decode_winbond()
2356 * (e.g., ATF). Thus, the bus should be initialized and ready and in mlxbf_i2c_probe()
