Home
last modified time | relevance | path

Searched +full:4 +full:c000000 (Results 1 – 25 of 67) sorted by relevance

123

/Linux-v6.1/Documentation/devicetree/bindings/memory-controllers/ti/
Demif.txt61 emif1: emif@4c000000 {
62 compatible = "ti,emif-4d";
73 emif: emif@4c000000 {
80 emif1: emif@4c000000 {
/Linux-v6.1/arch/arm/boot/dts/
Ddra74x-p.dtsi15 emif1: emif@4c000000 {
Dsunplus-sp7021-achip.dtsi60 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
61 <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
62 <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
63 <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>;
77 soc@9c000000 {
Ds3c2416.dtsi31 clocks: clock-controller@4c000000 {
40 interrupts = <1 18 24 4>, <1 18 25 4>;
48 sdhci_1: mmc@4ac00000 {
59 sdhci_0: mmc@4a800000 {
Dspear320-evb.dts23 st,pinmux-mode = <4>;
83 fsmc: flash@4c000000 {
Dpxa27x.dtsi30 reg = <0x40e00054 0x20 0x40e0000c 0xc 0x40e0010c 4
41 usb0: usb@4c000000 {
98 interrupts = <4>;
Dspear320.dtsi32 fsmc: flash@4c000000 {
Daspeed-bmc-opp-vesnin.dts30 flash_memory: region@5c000000 {
40 gpios = <&gpio ASPEED_GPIO(R, 4) GPIO_ACTIVE_LOW>;
Dspear320-hmi.dts23 st,pinmux-mode = <4>;
99 fsmc: flash@4c000000 {
254 ts,sample-time = <4>;
260 ts,settling = <4>;
Dvexpress-v2p-ca5s.dts75 interrupts = <0 85 4>;
90 interrupts = <0 86 4>,
91 <0 87 4>;
96 scu@2c000000 {
133 interrupts = <0 84 4>;
139 interrupts = <0 68 4>,
140 <0 69 4>;
186 arm,vexpress-sysreg,func = <1 4>;
204 arm,vexpress-sysreg,func = <4 0>;
220 interrupt-map = <0 0 &gic 0 36 4>,
[all …]
Dkeystone-k2e.dtsi89 msm_ram: sram@c000000 {
144 reg = <0x21021000 0x2000>, <0x21020000 0x1000>, <0x02620128 4>;
160 <0 0 0 4 &pcie_intc1 3>; /* INT D */
Dr7s9210-rza2mevb.dts25 * | = = = = = | SW6-4 set to CEU
27 * | 1 2 3 4 5 6 7 8 9 0 | SW6-6 set to VDC6
82 memory@c000000 {
143 <RZA2_PINMUX(PORTE, 4, 7)>, /* RMII0_CRSDV */
158 <RZA2_PINMUX(PORTK, 4, 7)>, /* RMII1_RXD0 */
162 <RZA2_PINMUX(PORT3, 4, 1)>, /* ET1_MDIO */
187 pinmux = <RZA2_PINMUX(PORT5, 4, 3)>, /* SD1_CD */
219 bus-width = <4>;
226 bus-width = <4>;
/Linux-v6.1/Documentation/devicetree/bindings/clock/
Dsamsung,s3c2412-clock.txt32 clocks: clock-controller@4c000000 {
45 interrupts = <1 23 3 4>, <1 23 4 4>;
Dsamsung,s3c2410-clock.txt33 clocks: clock-controller@4c000000 {
46 interrupts = <1 23 3 4>, <1 23 4 4>;
Dsamsung,s3c2443-clock.txt37 clocks: clock-controller@4c000000 {
50 interrupts = <1 23 3 4>, <1 23 4 4>;
/Linux-v6.1/Documentation/devicetree/bindings/hwlock/
Dst,stm32-hwspinlock.yaml41 hwspinlock@4c000000 {
/Linux-v6.1/Documentation/devicetree/bindings/mips/cavium/
Dsata-uctl.txt28 uctl@118006c000000 {
40 interrupts = <2 4>; /* Bit: 2, level */
/Linux-v6.1/Documentation/devicetree/bindings/usb/
Dpxa-usb.txt24 usb0: ohci@4c000000 {
/Linux-v6.1/arch/arm64/boot/dts/qcom/
Dsm6125-sony-xperia-seine-pdx201.dts27 framebuffer0: framebuffer@5c000000 {
29 reg = <0 0x5c000000 0 (2520 * 1080 * 4)>;
32 stride = <(1080 * 4)>;
Dsm8150-sony-xperia-kumano.dtsi33 framebuffer: framebuffer@9c000000 {
38 stride = <(1644 * 4)>;
114 cont_splash_mem: memory@9c000000 {
428 gpio-reserved-ranges = <126 4>;
Dsm8250-sony-xperia-edo.dtsi26 framebuffer: framebuffer@9c000000 {
31 stride = <(1644 * 4)>;
104 cont_splash_mem: memory@9c000000 {
305 /* L2-4 are unused. */
579 bus-width = <4>;
589 gpio-reserved-ranges = <40 4>, <52 4>;
/Linux-v6.1/arch/sh/mm/
DKconfig12 On other systems (such as the SH-3 and 4) where an MMU exists,
41 The page size is not necessarily 4KB. Keep this in mind when
54 boards typically map RAM at 0C000000.
87 32-bits through the SH-4A PMB. If this is not set, legacy
159 bool "4kB"
179 This enables support for 64kB pages, possible on all SH-4
202 bool "4MB"
243 Since there's sill some aliasing issues on SH-4, this option will
/Linux-v6.1/Documentation/devicetree/bindings/media/
Damphion,vpu.yaml114 vpu: vpu@2c000000 {
125 interrupts = <0 472 4>;
133 interrupts = <0 473 4>;
141 interrupts = <0 474 4>;
/Linux-v6.1/Documentation/devicetree/bindings/interrupt-controller/
Dsifive,plic-1.0.0.yaml18 in an 4 core system with 2-way SMT, you have 8 harts and probably at least two
158 plic: interrupt-controller@c000000 {
/Linux-v6.1/arch/mips/boot/dts/mti/
Dsead3.dts69 flash@1c000000 {
74 bank-width = <4>;
221 reg-io-width = <4>;
227 interrupts = <GIC_SHARED 3 IRQ_TYPE_LEVEL_HIGH>; /* GIC 3 or CPU 4 */
236 reg-io-width = <4>;
242 interrupts = <GIC_SHARED 2 IRQ_TYPE_LEVEL_HIGH>; /* GIC 2 or CPU 4 */
250 reg-io-width = <4>;

123