Searched +full:4 +full:c00000 (Results 1 – 25 of 127) sorted by relevance
123456
/Linux-v6.6/Documentation/devicetree/bindings/mtd/ |
D | ingenic,nand.yaml | 72 <4 0 0x18000000 0x1000000>, 127 partition@c00000 { 132 partition@4c00000 {
|
/Linux-v6.6/arch/arm/boot/dts/aspeed/ |
D | openbmc-flash-layout.dtsi | 23 rofs@4c0000 { 28 rwfs@1c00000 {
|
/Linux-v6.6/Documentation/devicetree/bindings/gpio/ |
D | xylon,logicvc-gpio.yaml | 20 - GPIO[4:0] (display control) mapped to index 0-4 56 logicvc: logicvc@43c00000 {
|
/Linux-v6.6/arch/arm/boot/dts/nxp/imx/ |
D | imx1-apf9328.dts | 57 eth: eth@4,c00000 { 61 reg = <4 0x00c00000 0x2>, 62 <4 0x00c00002 0x2>;
|
/Linux-v6.6/arch/arm64/boot/dts/nvidia/ |
D | tegra186-p3310.dtsi | 38 phy-reset-gpios = <&gpio TEGRA186_MAIN_GPIO(M, 4) 59 memory-controller@2c00000 { 140 wp-gpios = <&gpio TEGRA186_MAIN_GPIO(P, 4) GPIO_ACTIVE_HIGH>; 161 hsp@3c00000 { 382 cpu@4 {
|
D | tegra194-p3668.dtsi | 43 interrupts = <TEGRA194_MAIN_GPIO(G, 4) IRQ_TYPE_LEVEL_LOW>; 49 memory-controller@2c00000 {
|
/Linux-v6.6/Documentation/devicetree/bindings/display/ |
D | arm,komeda.yaml | 15 to a 4K resolution each. Each pipeline can be composed of up to four 94 display@c00000 { 104 <&smmu 4>, <&smmu 5>, <&smmu 6>, <&smmu 7>,
|
D | xylon,logicvc-display.yaml | 26 starting from the video memory base address for its framebuffer. In version 4, 40 maxItems: 4 73 # 4-bit LVDS interface (C_DISPLAY_INTERFACE == 2) 74 - lvds-4bits 75 # 3-bit LVDS interface (C_DISPLAY_INTERFACE == 4) 85 # YUV 4:2:2 colorspace (C_DISPLAY_COLOR_SPACE == 1) 87 # YUV 4:4:4 colorspace (C_DISPLAY_COLOR_SPACE == 2) 214 logicvc: logicvc@43c00000 { 233 xylon,display-interface = "lvds-4bits"; 281 layer@4 { [all …]
|
/Linux-v6.6/Documentation/devicetree/bindings/mfd/ |
D | syscon.yaml | 87 enum: [1, 2, 4, 8] 117 syscon: syscon@1c00000 {
|
/Linux-v6.6/Documentation/devicetree/bindings/media/ |
D | qcom,msm8996-venus.yaml | 27 maxItems: 4 110 video-codec@c00000 {
|
/Linux-v6.6/Documentation/devicetree/bindings/bus/ |
D | socionext,uniphier-system-bus.yaml | 82 system-bus@58c00000 { 93 interrupts = <0 48 4>; 100 interrupts = <0 49 4>;
|
/Linux-v6.6/arch/microblaze/boot/dts/ |
D | system.dts | 203 Hard_Ethernet_MAC: xps-ll-temac@81c00000 { 208 ethernet@81c00000 { 264 gpios = <&LEDs_8Bit 4 1>; 344 xps_timer_1: timer@83c00000 {
|
/Linux-v6.6/arch/arm/boot/dts/marvell/ |
D | kirkwood-linksys-viper.dts | 121 partition@4a0000 { 126 partition@1c00000 { 194 port@4 { 195 reg = <4>;
|
D | armada-385-db-ap.dts | 60 phy1: ethernet-phy@4 { 61 reg = <4>; 212 nand-ecc-strength = <4>; 232 partition@c00000 {
|
D | armada-370-netgear-rn102.dts | 239 nand-ecc-strength = <4>; 266 reg = <0x0800000 0x400000>; /* 4MB */ 270 partition@c00000 {
|
D | armada-370-netgear-rn104.dts | 265 nand-ecc-strength = <4>; 292 reg = <0x0800000 0x400000>; /* 4MB */ 296 partition@c00000 {
|
D | armada-xp-netgear-rn2120.dts | 76 g751: g751@4c { 320 nand-ecc-strength = <4>; 347 reg = <0x0800000 0x400000>; /* 4MB */ 351 partition@c00000 {
|
/Linux-v6.6/arch/arm/boot/dts/intel/pxa/ |
D | pxa27x.dtsi | 30 reg = <0x40e00054 0x20 0x40e0000c 0xc 0x40e0010c 4 41 usb0: usb@4c000000 { 63 pwm2: pwm@40c00000 { 98 interrupts = <4>;
|
/Linux-v6.6/arch/mips/boot/dts/ingenic/ |
D | ci20.dts | 125 wifi_power: fixedregulator-4 { 196 bus-width = <4>; 210 bus-width = <4>; 269 shutdown-gpios = <&gpf 4 GPIO_ACTIVE_HIGH>; 464 partition@c00000 { 469 partition@4c00000 { 605 groups = "mmc0-1bit-e", "mmc0-4bit-e"; 611 groups = "mmc1-1bit-d", "mmc1-4bit-d";
|
/Linux-v6.6/Documentation/devicetree/bindings/display/samsung/ |
D | samsung,fimd.yaml | 133 "^port@[0-4]+$": 141 4 - for write-back interface 169 fimd@11c00000 {
|
/Linux-v6.6/arch/arm/boot/dts/samsung/ |
D | exynos5.dtsi | 58 <GIC_SPI 4 IRQ_TYPE_LEVEL_HIGH>, 97 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>; 105 serial_0: serial@12c00000 { 194 interrupts = <18 4>, <18 5>, <18 6>;
|
/Linux-v6.6/Documentation/devicetree/bindings/firmware/ |
D | nvidia,tegra186-bpmp.yaml | 145 hsp_top0: hsp@3c00000 { 160 cpu_bpmp_tx: sram@4e000 { 166 cpu_bpmp_rx: sram@4f000 {
|
/Linux-v6.6/drivers/staging/axis-fifo/ |
D | axis-fifo.txt | 58 axi_fifo_mm_s_0: axi_fifo_mm_s@43c00000 { 62 interrupts = <0 29 4>;
|
/Linux-v6.6/arch/arm64/boot/dts/allwinner/ |
D | sun50i-h5.dtsi | 72 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 74 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 76 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 78 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>; 82 syscon: system-control@1c00000 {
|
/Linux-v6.6/arch/arm/boot/dts/ti/omap/ |
D | am33xx.dtsi | 115 /* OPP100-4 */ 157 target-module@4b000000 { 205 l4_wkup: interconnect@44c00000 { 209 l4_fw: interconnect@47c00000 { 211 l4_fast: interconnect@4a000000 { 213 l4_mpuss: interconnect@4b140000 { 393 &cppi41dma 4 0 &cppi41dma 5 0 400 &cppi41dma 3 1 &cppi41dma 4 1 509 target-module@4c000000 { 531 reg = <0x50000000 4>, [all …]
|
123456