Searched +full:4 +full:c00000 (Results 1 – 25 of 93) sorted by relevance
1234
/Linux-v5.10/Documentation/devicetree/bindings/mtd/ |
D | ingenic,nand.yaml | 67 <4 0 0x18000000 0x1000000>, 122 partition@c00000 { 127 partition@4c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/dma/ |
D | zxdma.txt | 16 dma: dma-controller@09c00000{ 28 For example, spdif0 tx channel request line is 4 36 dmas = <&dma 4>;
|
/Linux-v5.10/Documentation/devicetree/bindings/display/exynos/ |
D | samsung-fimd.txt | 80 4 - for write-back interface 89 fimd@11c00000 { 103 fimd@11c00000 {
|
/Linux-v5.10/arch/arm/boot/dts/ |
D | qcom-msm8660-surf.dts | 19 gsbi@19c00000 { 64 MATRIX_KEY(4, 0, KEY_CAMERA_FOCUS) 65 MATRIX_KEY(4, 1, KEY_UP) 66 MATRIX_KEY(4, 2, KEY_LEFT) 67 MATRIX_KEY(4, 3, KEY_HOME) 68 MATRIX_KEY(4, 4, KEY_FN_F3) 73 MATRIX_KEY(5, 4, KEY_MENU)
|
D | imx1-apf9328.dts | 57 eth: eth@4,c00000 { 62 4 0x00c00000 0x2 63 4 0x00c00002 0x2
|
D | suniv-f1c100s.dtsi | 41 sram-controller@1c00000 { 116 reg-io-width = <4>; 127 reg-io-width = <4>; 138 reg-io-width = <4>;
|
D | kirkwood-linksys-viper.dts | 121 partition@4a0000 { 126 partition@1c00000 { 194 port@4 { 195 reg = <4>;
|
D | pxa27x.dtsi | 27 reg = <0x40e00054 0x20 0x40e0000c 0xc 0x40e0010c 4 38 usb0: usb@4c000000 { 60 pwm2: pwm@40c00000 { 95 interrupts = <4>;
|
D | armada-385-db-ap.dts | 60 phy1: ethernet-phy@4 { 61 reg = <4>; 212 nand-ecc-strength = <4>; 232 partition@c00000 {
|
D | exynos5.dtsi | 58 <GIC_SPI 4 IRQ_TYPE_LEVEL_HIGH>, 97 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>; 105 serial_0: serial@12c00000 { 194 interrupts = <18 4>, <18 5>, <18 6>;
|
D | armada-370-netgear-rn102.dts | 239 nand-ecc-strength = <4>; 266 reg = <0x0800000 0x400000>; /* 4MB */ 270 partition@c00000 {
|
D | uniphier-pro4.dtsi | 66 interrupts = <0 174 4>, <0 175 4>; 80 interrupts = <0 39 4>; 91 interrupts = <0 33 4>; 102 interrupts = <0 35 4>; 113 interrupts = <0 37 4>; 124 interrupts = <0 177 4>; 151 interrupts = <0 41 4>; 154 clocks = <&peri_clk 4>; 155 resets = <&peri_rst 4>; 165 interrupts = <0 42 4>; [all …]
|
/Linux-v5.10/Documentation/devicetree/bindings/gpio/ |
D | xylon,logicvc-gpio.yaml | 20 - GPIO[4:0] (display control) mapped to index 0-4 56 logicvc: logicvc@43c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/mfd/ |
D | syscon.yaml | 57 maxItems: 4 # Should be enough 67 enum: [1, 2, 4, 8] 82 syscon: syscon@1c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/display/ |
D | arm,komeda.txt | 41 dp0: display@c00000 { 46 interrupts = <0 168 4>; 50 <&smmu 4>, <&smmu 5>, <&smmu 6>, <&smmu 7>,
|
/Linux-v5.10/arch/arm64/boot/dts/nvidia/ |
D | tegra186-p3310.dtsi | 38 phy-reset-gpios = <&gpio TEGRA186_MAIN_GPIO(M, 4) 59 memory-controller@2c00000 { 140 wp-gpios = <&gpio TEGRA186_MAIN_GPIO(P, 4) GPIO_ACTIVE_HIGH>; 160 hsp@3c00000 { 210 cpu@4 {
|
D | tegra234.dtsi | 58 hsp_top0: hsp@3c00000 { 85 * we only have 4 shared interrupts for the CCPLEX. 117 interrupts = <GIC_PPI 9 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>; 132 cpu_bpmp_tx: shmem@4e000 { 138 cpu_bpmp_rx: shmem@4f000 { 182 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 183 <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 184 <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 185 <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>;
|
/Linux-v5.10/arch/mips/boot/dts/ingenic/ |
D | ci20.dts | 99 bus-width = <4>; 111 bus-width = <4>; 119 /* reg = <4>;*/ 154 shutdown-gpios = <&gpf 4 GPIO_ACTIVE_LOW>; 355 partition@c00000 { 360 partition@4c00000 { 388 interrupts = <19 4>; 480 groups = "mmc0-1bit-e", "mmc0-4bit-e"; 486 groups = "mmc1-1bit-d", "mmc1-4bit-d";
|
/Linux-v5.10/arch/microblaze/boot/dts/ |
D | system.dts | 203 Hard_Ethernet_MAC: xps-ll-temac@81c00000 { 208 ethernet@81c00000 { 264 gpios = <&LEDs_8Bit 4 1>; 316 interrupts = < 4 2 >; 352 xps_timer_1: timer@83c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/bus/ |
D | socionext,uniphier-system-bus.yaml | 82 system-bus@58c00000 { 93 interrupts = <0 48 4>; 100 interrupts = <0 49 4>;
|
/Linux-v5.10/Documentation/devicetree/bindings/media/ |
D | qcom,msm8996-venus.yaml | 31 maxItems: 4 129 video-codec@c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/firmware/ |
D | nvidia,tegra186-bpmp.txt | 68 hsp_top0: hsp@3c00000 { 80 cpu_bpmp_tx: shmem@4e000 { 87 cpu_bpmp_rx: shmem@4f000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/iommu/ |
D | qcom,iommu.txt | 115 iommus = <&apps_iommu 4>; 118 gpu@1c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/clock/ |
D | exynos5260-clock.txt | 55 4) "samsung,exynos5260-clock-kfc" 183 serial@12c00000 {
|
/Linux-v5.10/arch/arm64/boot/dts/allwinner/ |
D | sun50i-h5.dtsi | 72 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 74 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 76 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, 78 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>; 82 syscon: system-control@1c00000 {
|
1234