Home
last modified time | relevance | path

Searched +full:3 +full:d000 (Results 1 – 25 of 107) sorted by relevance

12345

/Linux-v5.10/Documentation/devicetree/bindings/gpio/
Dnvidia,tegra20-gpio.txt16 bits[3:0] trigger type and level flags:
21 Valid combinations are 1, 2, 3, 4, 8.
26 gpio: gpio@6000d000 {
/Linux-v5.10/arch/arm64/boot/dts/freescale/
Dqoriq-fman3-0-1g-5.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
10 fman0_rx_0x0d: port@8d000 {
/Linux-v5.10/Documentation/translations/zh_CN/
Doops-tracing.txt56 （3）使用Kdump（请参看Documentation/admin-guide/kdump/kdump.rst），
99 7e 04 40 89 42 54 8b 43 04 3b 05 00 f6 52 c0
132 地址解析的完整支持至少应该使用1.3-pl3的sysklogd包。
161 Aug 29 09:51:01 blizard kernel: current->tss.cr3 = 0062d000, %cr3 = 0062d000
197 3：'S'如果oops发生在SMP内核中，运行于没有证明安全运行多处理器的硬件。 当前这种
/Linux-v5.10/arch/arm64/boot/dts/nvidia/
Dtegra210-p2530.dtsi27 i2c@7000d000 {
62 cpu@3 {
Dtegra210-p2180.dtsi11 rtc0 = "/i2c@7000d000/pmic@3c";
34 i2c@7000d000 {
38 pmic: pmic@3c {
323 cpu@3 {
/Linux-v5.10/arch/arm/boot/dts/
Dbcm28155-ap.dts29 uart@3e000000 {
33 i2c@3e016000 {
38 i2c@3e017000 {
43 i2c@3e018000 {
48 i2c@3500d000 {
57 sdio2: sdio@3f190000 {
65 sdio4: sdio@3f1b0000 {
73 pwm: pwm@3e01a000 {
77 usbotg: usb@3f120000 {
83 usbphy: usb-phy@3f130000 {
Drk3xxx.dtsi70 <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>;
123 gic: interrupt-controller@1013d000 {
126 #interrupt-cells = <3>;
153 qos_gpu: qos@1012d000 {
257 dmas = <&dmac2 3>;
298 i2c0: i2c@2002d000 {
Dbcm953012hr.dts2 * SPDX-License-Identifier: BSD-3-Clause
77 m25p,default-addr-width = <3>;
86 partition@d000 {
Dbcm953012k.dts87 m25p,default-addr-width = <3>;
96 partition@d000 {
Dtegra30-cardhu-a04.dts16 power-gpios = <&gpio TEGRA_GPIO(D, 3) GPIO_ACTIVE_HIGH>;
96 i2c@7000d000 {
136 cpu@3 {
Dtegra30-asus-nexus7-grouper-maxim-pmic.dtsi8 i2c@7000d000 {
9 pmic: pmic@3c {
170 gpio = <&pmic 3 GPIO_ACTIVE_HIGH>;
Dbcm53573.dtsi43 #interrupt-cells = <3>;
91 <0x00002000 3 &gic GIC_SPI 2 IRQ_TYPE_LEVEL_HIGH>,
158 ohci: ohci@d000 {
Dtegra20-colibri-iris.dts14 rtc1 = "/i2c@7000d000/pmic@34";
196 gpios = <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>;
213 reg_3v3: regulator-3v3 {
Dtegra30-apalis-eval.dts14 rtc1 = "/i2c@7000d000/pmic@2d";
136 cd-gpios = <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_LOW>;
203 reg_3v3: regulator-3v3 {
231 regulator-name = "VCC_USBH(2A|2C|2D|3|4)";
Dvfxxx.dtsi115 <&edma0 0 3>;
171 dspi1: spi@4002d000 {
252 #pwm-cells = <3>;
265 #pwm-cells = <3>;
288 tcon0: timing-controller@4003d000 {
367 gpio4: gpio@4004d000 {
Dtegra30-asus-nexus7-tilapia.dtsi25 gpio@6000d000 {
26 init-mode-3g {
30 <TEGRA_GPIO(W, 3) GPIO_ACTIVE_HIGH>,
38 <TEGRA_GPIO(Y, 3) GPIO_ACTIVE_HIGH>,
41 <TEGRA_GPIO(U, 3) GPIO_ACTIVE_HIGH>,
45 <TEGRA_GPIO(N, 3) GPIO_ACTIVE_HIGH>;
212 interrupts = <TEGRA_GPIO(R, 3) IRQ_TYPE_LEVEL_HIGH>;
232 firmware-gpios = <&gpio TEGRA_GPIO(P, 3) GPIO_ACTIVE_HIGH>;
Dtegra124-apalis-eval.dts18 rtc1 = "/i2c@7000d000/pmic@40";
137 cd-gpios = <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_LOW>;
188 pwms = <&pwm 3 5000000>; /* BKL1_PWM */
196 gpios = <&gpio TEGRA_GPIO(DD, 3) GPIO_ACTIVE_LOW>;
203 reg_3v3: regulator-3v3 {
238 regulator-name = "VCC_USBH(2A|2C|2D|3|4)";
Dtegra124-apalis-v1.2-eval.dts19 rtc1 = "/i2c@7000d000/pmic@40";
139 cd-gpios = <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_LOW>;
190 pwms = <&pwm 3 5000000>; /* BKL1_PWM */
198 gpios = <&gpio TEGRA_GPIO(DD, 3) GPIO_ACTIVE_LOW>;
205 reg_3v3: regulator-3v3 {
240 regulator-name = "VCC_USBH(2A|2C|2D|3|4)";
Dtegra20-tamonten.dtsi9 rtc0 = "/i2c@7000d000/tps6586x@34";
329 i2c@7000d000 {
500 wp-gpios = <&gpio TEGRA_GPIO(H, 3) GPIO_ACTIVE_HIGH>;
Dtegra20-colibri-eval-v3.dts14 rtc1 = "/i2c@7000d000/pmic@34";
214 gpios = <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>;
231 reg_3v3: regulator-3v3 {
/Linux-v5.10/Documentation/devicetree/bindings/thermal/
Dmax77620_thermal.txt27 i2c@7000d000 {
28 spmic: max77620@3c {
/Linux-v5.10/Documentation/devicetree/bindings/interrupt-controller/
Dst,stm32-exti.yaml82 exti1: interrupt-controller@5000d000 {
95 interrupts = <1>, <2>, <3>, <6>, <7>, <8>, <9>, <10>, <23>, <40>, <41>, <42>, <62>, <76>;
/Linux-v5.10/arch/arm64/boot/dts/marvell/
Darmada-37xx.dtsi90 cpu_misc: system-controller@d000 {
162 <&tbg 3>, <&xtalclk>;
170 <&tbg 3>, <&xtalclk>;
357 interrupts = <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>;
364 usb2_utmi_otg_phy: phy@5d000 {
466 #interrupt-cells = <3>;
482 #address-cells = <3>;
494 <0 0 0 3 &pcie_intc 2>,
495 <0 0 0 4 &pcie_intc 3>;
/Linux-v5.10/drivers/hwmon/
Demc1403.c46 return sprintf(buf, "%d000\n", val); in temp_show()
117 return sprintf(buf, "%d000\n", is_min ? limit + hyst : limit - hyst); in show_hyst_common()
308 &emc1402_alarms[3].dev_attr.attr,
371 case 0x2a: /* externl diode 3 high byte */ in emc1403_regmap_is_volatile()
372 case 0x2b: /* external diode 3 low byte */ in emc1403_regmap_is_volatile()
/Linux-v5.10/Documentation/trace/coresight/
Dcoresight.rst158 20010000.etb 20040000.funnel 2201d000.ptm 2203d000.etm
268 <file details> in:3 -> ../../../23340000.etm/etm5
350 20010000.etb 20040000.funnel 2201d000.ptm 2203d000.etm
574 crw------- 1 root root 10, 61 Jan 3 18:11 /dev/stm0

12345