Searched +full:3 +full:c00000 (Results 1 – 25 of 89) sorted by relevance
1234
/Linux-v5.10/Documentation/devicetree/bindings/mtd/ |
D | ingenic,nand.yaml | 66 <3 0 0x19000000 0x1000000>, 122 partition@c00000 { 127 partition@4c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/display/exynos/ |
D | samsung-fimd.txt | 79 3 - for parallel output, 89 fimd@11c00000 { 103 fimd@11c00000 {
|
/Linux-v5.10/arch/arm/boot/dts/ |
D | qcom-msm8660-surf.dts | 19 gsbi@19c00000 { 58 MATRIX_KEY(0, 3, KEY_VOLUMEUP) 62 MATRIX_KEY(1, 3, KEY_VOLUMEDOWN) 63 MATRIX_KEY(2, 3, KEY_ENTER) 67 MATRIX_KEY(4, 3, KEY_HOME) 72 MATRIX_KEY(5, 3, KEY_BACK)
|
D | suniv-f1c100s.dtsi | 41 sram-controller@1c00000 { 89 #interrupt-cells = <3>; 90 #gpio-cells = <3>; 136 interrupts = <3>;
|
D | kirkwood-linksys-viper.dts | 126 partition@1c00000 { 189 port@3 { 190 reg = <3>;
|
D | zx296702.dtsi | 45 #interrupt-cells = <3>; 61 l2cc: cache-controller@c00000 {
|
D | armada-385-db-ap.dts | 100 bm,pool-short = <3>; 110 bm,pool-short = <3>; 131 bm,pool-short = <3>; 165 pcie@3,0 { 232 partition@c00000 {
|
D | exynos5.dtsi | 57 <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>, 90 #interrupt-cells = <3>; 105 serial_0: serial@12c00000 { 177 samsung,pwm-outputs = <0>, <1>, <2>, <3>; 178 #pwm-cells = <3>; 202 interrupts = <10 3>;
|
D | pxa27x.dtsi | 41 interrupts = <3>; 60 pwm2: pwm@40c00000 {
|
D | armada-370-netgear-rn104.dts | 77 g762: g762@3e { 141 gpios = <&pca9554 3 GPIO_ACTIVE_LOW>; 296 partition@c00000 {
|
D | uniphier-pro4.dtsi | 127 clocks = <&peri_clk 3>; 128 resets = <&peri_rst 3>; 227 system_bus: system-bus@58c00000 { 294 resets = <&mio_rst 0>, <&mio_rst 3>; 400 usb_phy3: phy@3 { 401 reg = <3>; 464 #interrupt-cells = <3>; 559 usb1: usb@65c00000 { 612 clocks = <&sys_clk 2>, <&sys_clk 3>, <&sys_clk 3>;
|
D | armada-370-netgear-rn102.dts | 75 g762: g762@3e { 270 partition@c00000 {
|
D | armada-xp-netgear-rn2120.dts | 44 /* Controller for rear fan #1 of 3 (Protechnic 46 g762_fan1: g762@3e { 55 /* Controller for rear (center) fan #2 of 3 */ 65 /* Controller for rear fan #3 of 3 */ 351 partition@c00000 {
|
/Linux-v5.10/arch/microblaze/boot/dts/ |
D | system.dts | 131 xlnx,include-datawidth-matching-3 = <0x0>; 161 xlnx,synch-mem-3 = <0x0>; 165 xlnx,synch-pipedelay-3 = <0x2>; 169 xlnx,tavdv-ps-mem-3 = <0x3a98>; 173 xlnx,tcedv-ps-mem-3 = <0x3a98>; 177 xlnx,thzce-ps-mem-3 = <0x1b58>; 181 xlnx,thzoe-ps-mem-3 = <0x1b58>; 185 xlnx,tlzwe-ps-mem-3 = <0x0>; 189 xlnx,twc-ps-mem-3 = <0x3a98>; 193 xlnx,twp-ps-mem-3 = <0x2ee0>; [all …]
|
/Linux-v5.10/arch/arm64/boot/dts/nvidia/ |
D | tegra186-p3310.dtsi | 48 compatible = "ethernet-phy-ieee802.3-c22"; 59 memory-controller@2c00000 { 160 hsp@3c00000 { 206 cpu@3 { 223 pmic: pmic@3c {
|
D | tegra234.dtsi | 58 hsp_top0: hsp@3c00000 { 120 #interrupt-cells = <3>;
|
D | tegra194-p3668-0000.dtsi | 21 rtc0 = "/bpmp/i2c/pmic@3c"; 44 compatible = "ethernet-phy-ieee802.3-c22"; 53 memory-controller@2c00000 { 95 usb2-3 { 103 usb3-3 { 122 pmic: pmic@3c {
|
/Linux-v5.10/Documentation/devicetree/bindings/mailbox/ |
D | nvidia,tegra186-hsp.txt | 61 hsp_top0: hsp@3c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/display/ |
D | arm,komeda.txt | 41 dp0: display@c00000 { 49 iommus = <&smmu 0>, <&smmu 1>, <&smmu 2>, <&smmu 3>,
|
/Linux-v5.10/arch/mips/boot/dts/ingenic/ |
D | ci20.dts | 47 gpios = <&gpc 3 GPIO_ACTIVE_HIGH>; 81 gpios = <&gpe 3 GPIO_ACTIVE_LOW>; 355 partition@c00000 { 360 partition@4c00000 { 492 /* 3 MHz for the system timer and clocksource */
|
/Linux-v5.10/Documentation/devicetree/bindings/net/ |
D | xilinx_axienet.txt | 24 - interrupts : Should be a list of 2 or 3 interrupts: TX DMA, RX DMA, 56 axi_ethernet_eth: ethernet@40c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/clock/ |
D | exynos5260-clock.txt | 33 - "phyclk_dptx_phy_ch3_txd_clk" - dp phy clock for channel 3 54 3) "samsung,exynos5260-clock-egl" 183 serial@12c00000 {
|
/Linux-v5.10/Documentation/devicetree/bindings/firmware/ |
D | nvidia,tegra186-bpmp.txt | 68 hsp_top0: hsp@3c00000 {
|
/Linux-v5.10/arch/powerpc/boot/dts/fsl/ |
D | b4qds.dtsi | 54 3 0 0xf 0xffdf0000 0x00008000>; 91 partition@c00000 { 98 board-control@3,0 { 100 reg = <3 0 0x300>; 203 i2c@3 {
|
/Linux-v5.10/arch/arm64/boot/dts/allwinner/ |
D | sun50i-h5.dtsi | 43 cpu3: cpu@3 { 46 reg = <3>; 82 syscon: system-control@1c00000 {
|
1234