Home
last modified time | relevance | path

Searched +full:30 +full:a00000 (Results 1 – 25 of 50) sorted by relevance

12

/Linux-v6.6/arch/arm/boot/dts/marvell/
Dkirkwood-c200-v1.dts172 rtc@30 {
237 partition@5a00000 {
242 partition@7a00000 {
Darmada-370-c200-v2.dts219 rtc@30 {
298 partition@5a00000 {
303 partition@7a00000 {
Dkirkwood-l-50.dts88 rtc@30 {
361 partition@7a00000 {
/Linux-v6.6/Documentation/devicetree/bindings/display/bridge/
Dnwl-dsi.yaml147 dsi@30a00000 {
/Linux-v6.6/arch/arm/boot/dts/intel/pxa/
Dpxa3xx.dtsi20 (gpio <= 98) ? (0x0418 + 4 * (gpio - 30)) : \
280 ssp4: ssp@41a00000 {
288 timer@40a00000 {
/Linux-v6.6/arch/arm64/boot/dts/ti/
Dk3-am62a-mcu.dtsi63 mcu_uart0: serial@4a00000 {
125 interrupts = <30>, <31>;
Dk3-am64-mcu.dtsi54 mcu_uart0: serial@4a00000 {
138 interrupts = <30>, <31>;
Dk3-am62-mcu.dtsi68 mcu_uart0: serial@4a00000 {
130 interrupts = <30>, <31>;
Dk3-am65-main.dtsi350 clocks = <&k3_clks 30 0>;
352 assigned-clocks = <&k3_clks 30 0>;
353 assigned-clock-parents = <&k3_clks 30 1>;
354 power-domains = <&k3_pds 30 TI_SCI_PD_EXCLUSIVE>;
590 intr_main_gpio: interrupt-controller@a00000 {
648 hwspinlock: spinlock@30e00000 {
1008 dss: dss@4a00000 {
1143 icssg0_iepclk_mux: iepclk-mux@30 {
1285 icssg1_iepclk_mux: iepclk-mux@30 {
1427 icssg2_iepclk_mux: iepclk-mux@30 {
/Linux-v6.6/arch/arm/boot/dts/nxp/imx/
Dimx53-sk-imx53.dts125 scl-gpios = <&gpio2 30 GPIO_ACTIVE_HIGH>;
316 partition@1a00000 {
Dimx7s.dtsi1017 flexcan1: can@30a00000 {
1028 flexcan2: can@30a10000 {
1039 i2c1: i2c@30a20000 {
1049 i2c2: i2c@30a30000 {
1059 i2c3: i2c@30a40000 {
1069 i2c4: i2c@30a50000 {
1079 uart4: serial@30a60000 {
1090 uart5: serial@30a70000 {
1094 interrupts = <GIC_SPI 30 IRQ_TYPE_LEVEL_HIGH>;
1101 uart6: serial@30a80000 {
[all …]
/Linux-v6.6/arch/arm64/boot/dts/qcom/
Dsdx75.dtsi280 xbl_ramdump_mem: xbl-ramdump@87a00000 {
642 apps_rsc: rsc@17a00000 {
731 interrupts = <GIC_SPI 30 IRQ_TYPE_LEVEL_HIGH>;
Dmsm8994-msft-lumia-octagon.dtsi197 smem_mem: memory@6a00000 {
367 enable-gpios = <&tlmm 30 GPIO_ACTIVE_HIGH>;
/Linux-v6.6/arch/arm/boot/dts/ti/omap/
Ddm816x.dtsi212 target-module@49a00000 {
551 dmas = <&edma 30 0 &edma 31 0>;
655 #dma-channels = <30>;
656 dma-channels = <30>;
Ddm814x.dtsi167 #dma-channels = <30>;
168 dma-channels = <30>;
362 dmas = <&edma 30 0 &edma 31 0>;
628 target-module@49a00000 {
Dam33xx.dtsi296 target-module@49a00000 {
472 #dma-channels = <30>;
473 dma-channels = <30>;
Dam4372.dtsi279 target-module@49a00000 {
466 pruss1_iepclk_mux: iepclk-mux@30 {
552 pruss0_iepclk_mux: iepclk-mux@30 {
/Linux-v6.6/arch/mips/boot/dts/ingenic/
Dci20.dts404 interrupts = <30 IRQ_TYPE_LEVEL_LOW>;
459 partition@a00000 {
/Linux-v6.6/arch/arm/boot/dts/microchip/
Dat91sam9263.dtsi101 atmel,external-irqs = <30 31>;
186 <AT91_PIOC 30 AT91_PERIPH_A AT91_PINCTRL_PULL_UP
269 AT91_PIOE 30 AT91_PERIPH_A AT91_PINCTRL_NONE>; /* PE30 periph A */
771 usb0: ohci@a00000 {
Dsama5d4.dtsi140 L2: cache-controller@a00000 {
359 sda-gpios = <&pioA 30 GPIO_ACTIVE_HIGH>;
382 scl-gpios = <&pioE 30 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
427 scl-gpios = <&pioB 30 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
536 interrupts = <30 IRQ_TYPE_LEVEL_HIGH 5>;
546 clocks = <&pmc PMC_TYPE_PERIPHERAL 30>;
882 <AT91_PIOC 30 AT91_PERIPH_A AT91_PINCTRL_NONE>;
991 <AT91_PIOE 30 AT91_PERIPH_A AT91_PINCTRL_NONE>;
1008 <AT91_PIOA 30 AT91_PERIPH_A AT91_PINCTRL_NONE
1014 <AT91_PIOA 30 AT91_PERIPH_GPIO AT91_PINCTRL_NONE
[all …]
Dsama5d2.dtsi157 L2: cache-controller@a00000 {
326 AT91_XDMAC_DT_PERID(30))>;
1040 interrupts = <30 IRQ_TYPE_LEVEL_HIGH 7>;
1050 clocks = <&pmc PMC_TYPE_PERIPHERAL 30>;
/Linux-v6.6/arch/arm/boot/dts/socionext/
Duniphier-pro4.dtsi563 <&sys_rst 30>,
610 <&sys_rst 30>,
617 usb0: usb@65a00000 {
/Linux-v6.6/arch/arm64/boot/dts/socionext/
Duniphier-pxs3.dtsi643 clocks = <&sys_clk 28>, <&sys_clk 30>;
645 resets = <&sys_rst 28>, <&sys_rst 30>;
684 clocks = <&sys_clk 29>, <&sys_clk 30>;
686 resets = <&sys_rst 29>, <&sys_rst 30>;
691 usb0: usb@65a00000 {
/Linux-v6.6/arch/arm64/boot/dts/allwinner/
Dsun50i-h6.dtsi225 sram_c1: sram@1a00000 {
362 drive-strength = <30>;
371 drive-strength = <30>;
380 drive-strength = <30>;
441 iommu: iommu@30f0000 {
/Linux-v6.6/arch/arm64/boot/dts/freescale/
Dimx8mq.dtsi598 gpio-ranges = <&iomuxc 0 10 30>;
650 gpio-ranges = <&iomuxc 0 119 30>;
1251 mipi_dsi: dsi@30a00000 {
1296 dphy: dphy@30a00300 {
1314 i2c1: i2c@30a20000 {
1324 i2c2: i2c@30a30000 {
1334 i2c3: i2c@30a40000 {
1344 i2c4: i2c@30a50000 {
1354 uart4: serial@30a60000 {
1367 mipi_csi1: csi@30a70000 {
[all …]

12