Home
last modified time | relevance | path

Searched +full:300 +full:a000 (Results 1 – 25 of 39) sorted by relevance

12

/Linux-v6.1/Documentation/devicetree/bindings/pwm/
Dallwinner,sun4i-a10-pwm.yaml104 pwm@300a000 {
/Linux-v6.1/drivers/input/touchscreen/
Diqs5xx.c163 usleep_range(200, 300); in iqs5xx_read_burst()
212 usleep_range(200, 300); in iqs5xx_write_burst()
241 usleep_range(200, 300); in iqs5xx_reset()
565 * A000 and B000 devices use 8-bit and 16-bit addressing, respectively. in iqs5xx_dev_init()
566 * Querying an A000 device's version information with 16-bit addressing in iqs5xx_dev_init()
587 * bootloader and wait for user space to convert the A000 device into a in iqs5xx_dev_init()
591 dev_err(&client->dev, "Opening bootloader for A000 device\n"); in iqs5xx_dev_init()
/Linux-v6.1/arch/arm64/boot/dts/realtek/
Drtd16xx.dtsi64 cpu3: cpu@300 {
158 sb2: syscon@1a000 {
/Linux-v6.1/Documentation/networking/device_drivers/ethernet/cirrus/
Dcs89x0.rst177 Base I/O Address: 300
563 A000-BFFF EGA Graphics Adapter
564 A000-C7FF VGA Graphics Adapter
/Linux-v6.1/arch/arm/boot/dts/
Dbcm-nsp.dtsi187 uart0: serial@300 {
326 ehci0: usb@2a000 {
Dtegra30-asus-transformer-common.dtsi102 vde@6001a000 {
1116 pwm@7000a000 {
1786 post-power-on-delay-ms = <300>;
1787 power-off-delay-us = <300>;
Dste-dbx5x0.dtsi52 CPU0: cpu@300 {
728 i2c4: i2c@8012a000 {
780 spi0: spi@8011a000 {
Dtegra124-nyan.dtsi76 pwm@7000a000 {
387 nvidia,cpu-pwr-off-time = <300>;
Domap4-l4.dtsi75 omap_control_usb2phy: control-phy@300 {
720 target-module@a000 { /* 0x4a10a000, ap 65 50.0 */
801 target-module@a000 { /* 0x4a20a000, ap 33 2c.0 */
897 target-module@2a000 { /* 0x4a22a000, ap 57 48.0 */
1024 target-module@a000 { /* 0x4a30a000, ap 15 34.0 */
1744 target-module@6a000 { /* 0x4806a000, ap 26 18.0 */
2094 target-module@9a000 { /* 0x4809a000, ap 51 2c.0 */
Dtegra30-asus-nexus7-grouper-common.dtsi827 pwm: pwm@7000a000 {
987 post-power-on-delay-ms = <300>;
988 power-off-delay-us = <300>;
Ddm814x.dtsi250 i2c2: i2c@2a000 {
741 cpsw_emac1: slave@300 {
Dtegra20-acer-a500-picasso.dts550 pwm: pwm@7000a000 {
765 post-power-on-delay-ms = <300>;
766 power-off-delay-us = <300>;
Dam33xx-l4.dtsi559 target-module@1a000 { /* 0x47c1a000, ap 9 08.0 */
615 target-module@3a000 { /* 0x47c3a000, ap 19 1c.0 */
764 cpsw_emac1: slave@300 {
1152 target-module@2a000 { /* 0x4802a000, ap 14 2a.0 */
1410 target-module@4a000 { /* 0x4804a000, ap 85 60.0 */
Dda850.dtsi51 * Original silicon was 300MHz max, so higher frequencies
697 pll1: clock-controller@21a000 {
Dtegra114-dalmore.dts761 pwm@7000a000 {
1099 nvidia,cpu-pwr-off-time = <300>;
Dtegra124-venice2.dts614 pwm@7000a000 {
903 nvidia,cpu-pwr-off-time = <300>;
/Linux-v6.1/arch/arm64/boot/dts/allwinner/
Dsun50i-h6.dtsi305 pwm: pwm@300a000 {
315 pio: pinctrl@300b000 {
/Linux-v6.1/arch/arm64/boot/dts/mediatek/
Dmt8186.dtsi99 cpu3: cpu@300 {
540 spi0: spi@1100a000 {
Dmt8192.dtsi83 cpu3: cpu@300 {
606 spi0: spi@1100a000 {
1302 ccorr0: ccorr@1400a000 {
/Linux-v6.1/arch/arm64/boot/dts/qcom/
Dipq8074.dtsi288 crypto: crypto@73a000 {
522 interrupts = <GIC_SPI 300 IRQ_TYPE_LEVEL_HIGH>;
/Linux-v6.1/arch/arm64/boot/dts/apm/
Dapm-shadowcat.dtsi78 cpu@300 {
430 efuse: efuse@1054a000 {
/Linux-v6.1/arch/arm64/boot/dts/nvidia/
Dtegra210-p3450-0000.dts132 pwm@7000a000 {
267 regulator-ramp-delay-scale = <300>;
282 regulator-ramp-delay-scale = <300>;
Dtegra132-norrin.dts537 pwm: pwm@7000a000 {
889 nvidia,cpu-pwr-off-time = <300>;
/Linux-v6.1/Documentation/networking/
Darcnet-hardware.rst258 Trunk" is about 300 meters for RG-62. The maximum distance between the two
659 1 0 0 | 300
911 1 1 0 0 0 0 | 300
1097 001 300-30f
1130 00101 D:8000-D:87ff D:A000-D:bfff
1430 ON ON OFF | 300
1638 OFF OFF ON ON ON ON | 300
2043 ON ON OFF | 300
2189 ON ON OFF | 300
2293 300----- 0 0 0 0 1 1 1 1
[all …]
/Linux-v6.1/drivers/crypto/caam/
Dregs.h865 /* Block hashes @ 200/300/400/500 */
934 * 5 typical, base + 0x8000/9000/a000/b000

12