Home
last modified time | relevance | path

Searched +full:25 +full:mg (Results 1 – 19 of 19) sorted by relevance

/Linux-v6.6/Documentation/devicetree/bindings/iio/accel/
Dadi,adxl367.yaml18 with a resolution of 0.25mg/LSB on the +-2 g range.
63 interrupts = <25 IRQ_TYPE_EDGE_RISING>;
78 interrupts = <25 IRQ_TYPE_EDGE_RISING>;
/Linux-v6.6/drivers/iio/imu/
Dadis16400.c391 [3] = 25,
1008 .temp_offset = 25000000 / 140000, /* 25 C = 0x00 */
1019 .accel_scale_micro = IIO_G_TO_M_S_2(1000), /* 1 mg */
1021 .temp_offset = 25000000 / 67850, /* 25 C = 0x00 */
1032 .temp_offset = 25000000 / 145300, /* 25 C = 0x00 */
1044 .accel_scale_micro = IIO_G_TO_M_S_2(3333), /* 3.333 mg */
1046 .temp_offset = 25000000 / 136000, /* 25 C = 0x00 */
1057 .accel_scale_micro = IIO_G_TO_M_S_2(333), /* 0.333 mg */
1059 .temp_offset = 25000000 / 136000, /* 25 C = 0x00 */
1070 .accel_scale_micro = IIO_G_TO_M_S_2(1000), /* 1 mg */
[all …]
/Linux-v6.6/drivers/iio/accel/
Dadxl345_core.c49 * In full-resolution mode, scale factor is maintained at ~4 mg/LSB
58 * The Datasheet lists a resolution of Resolution is ~49 mg per LSB. That's
194 "0.09765625 0.1953125 0.390625 0.78125 1.5625 3.125 6.25 12.5 25 50 100 200 400 800 1600 3200"
Dadis16201.c133 * 1 LSB represents 0.244 mg. in adis16201_read_raw()
149 * is 25 degrees and the scale factor per milli in adis16201_read_raw()
/Linux-v6.6/drivers/gpu/drm/i915/display/
Dintel_ddi_buf_trans.c594 { .mg = { 0x18, 0x00, 0x00 } }, /* 0 0 */
595 { .mg = { 0x1D, 0x00, 0x05 } }, /* 0 1 */
596 { .mg = { 0x24, 0x00, 0x0C } }, /* 0 2 */
597 { .mg = { 0x2B, 0x00, 0x14 } }, /* 0 3 */
598 { .mg = { 0x21, 0x00, 0x00 } }, /* 1 0 */
599 { .mg = { 0x2B, 0x00, 0x08 } }, /* 1 1 */
600 { .mg = { 0x30, 0x00, 0x0F } }, /* 1 2 */
601 { .mg = { 0x31, 0x00, 0x03 } }, /* 2 0 */
602 { .mg = { 0x34, 0x00, 0x0B } }, /* 2 1 */
603 { .mg = { 0x3F, 0x00, 0x00 } }, /* 3 0 */
[all …]
Dintel_dpll_mgr.c2900 iref_trim = 25; in icl_calc_mg_pll_state()
3997 { "MG PLL 1", &mg_pll_funcs, DPLL_ID_ICL_MGPLL1, 0 },
3998 { "MG PLL 2", &mg_pll_funcs, DPLL_ID_ICL_MGPLL2, 0 },
3999 { "MG PLL 3", &mg_pll_funcs, DPLL_ID_ICL_MGPLL3, 0 },
4000 { "MG PLL 4", &mg_pll_funcs, DPLL_ID_ICL_MGPLL4, 0 },
/Linux-v6.6/drivers/clk/mvebu/
Dcp110-system-controller.c83 #define CP110_GATE_EIP150 25
92 [CP110_GATE_MG] = "mg-domain",
93 [CP110_GATE_MG_CORE] = "mg-core",
/Linux-v6.6/drivers/iio/imu/inv_icm42600/
Dinv_icm42600_accel.c263 /* 25Hz */
264 25, 0,
355 * Value is limited to +/-1g coded on 12 bits signed. Step is 0.5mg.
421 * 12 bits signed raw step 0.5mg to g: 5 / 10000 in inv_icm42600_accel_read_offset()
479 * g to raw 12 bits signed, step 0.5mg: 10000 / 5 in inv_icm42600_accel_write_offset()
/Linux-v6.6/drivers/staging/iio/accel/
Dadis16240.c267 *val2 = IIO_G_TO_M_S_2(51400); /* 51.4 mg */ in adis16240_read_raw()
275 *val2 = IIO_G_TO_M_S_2(51400); /* 51.4 mg */ in adis16240_read_raw()
278 *val = 25000 / 244 - 0x133; /* 25 C = 0x133 */ in adis16240_read_raw()
/Linux-v6.6/Documentation/devicetree/bindings/arm/marvell/
Dcp110-system-controller.txt47 - 1 5 MG Domain
48 - 1 6 MG Core
64 - 1 25 EIP150
116 mpp25 25 gpio, dev(oen), au(i2sdo_spdifo)
/Linux-v6.6/drivers/misc/lis3lv02d/
Dlis3lv02d.c61 * LIS3LV02D spec says 1024 LSBs corresponds 1 G -> 1LSB is 1000/1024 mG
62 * LIS302D spec says: 18 mG / digit
72 * LIS331DLH spec says 1LSBs corresponds 4G/4096 -> 1LSB is 1000/1024 mG.
207 static int lis3_3dc_rates[16] = {0, 1, 10, 25, 50, 100, 200, 400, 1600, 5000};
/Linux-v6.6/arch/s390/tools/
Dopcodes.txt44 25 ldxr RR_FF
815 e384 mg RXY_RRRD
/Linux-v6.6/arch/mips/include/asm/octeon/
Dcvmx-pci-defs.h354 uint32_t hbase:25;
358 uint32_t hbase:25;
422 uint32_t mg:8; member
428 uint32_t mg:8;
/Linux-v6.6/include/uapi/linux/
Domap3isp.h400 * @b_mg: B/Mg pixels. 2's complement. -128 to +127.
599 * @detect_correct: Thresholds for correction bit 0:10 detect 16:25 correct
/Linux-v6.6/drivers/scsi/
Dfdomain.c16 * Quantum ISA-200S, ISA-250MG
37 * 25-pin external connector, whereas the 1660 and 1680 have a SCSI-2 50-pin
/Linux-v6.6/drivers/net/wireless/realtek/rtl818x/rtl8180/
Ddev.c125 * MG | 1 | 0
140 * MG | 1 | x <- Not used
286 signal = -clamp_t(u8, agc, 25, 90) - 9; in rtl8180_handle_rx()
1861 pci_name(pdev), reg >> 25); in rtl8180_probe()
/Linux-v6.6/Documentation/admin-guide/
Dkernel-parameters.txt483 baycom_par= [HW,AX25] BayCom Parallel Port AX.25 Modem
488 BayCom Serial Port AX.25 Modem (Full Duplex Mode)
493 BayCom Serial Port AX.25 Modem (Half Duplex Mode)
689 cma=nn[MG]@[start[MG][-end[MG]]]
698 cma_pernuma=nn[MG]
709 numa_cma=<node>:nn[MG][,<node>:nn[MG]]
2829 udma[/][16,25,33,44,66,100,133] notation is also
6984 vmcp_cma=nn[MG] [KNL,S390]
/Linux-v6.6/drivers/pinctrl/aspeed/
Dpinmux-aspeed.h62 …* B19 GPIOF1 NDCD4 SCU80[25]=1 SIOPBI# SCUA4[12]=1 |…
620 * multiple groups (MG) of pins.
/Linux-v6.6/fs/proc/
Dtask_mmu.c245 seq_setwidth(m, 25 + sizeof(void *) * 6 - 1); in show_vma_header_prefix()
680 [ilog2(VM_MERGEABLE)] = "mg", in show_smap_vma_flags()