| /Linux-v6.1/arch/arm/boot/dts/ |
| D | lpc4337-ciaa.dts | 177 compatible = "microchip,24c512", "atmel,24c512";
182 compatible = "microchip,24c02", "atmel,24c02";
187 compatible = "microchip,24c512", "atmel,24c512";
|
| D | aspeed-bmc-inventec-transformers.dts | 132 compatible = "atmel,24c512";
175 compatible = "atmel,24c512";
181 compatible = "atmel,24c512";
227 compatible = "atmel,24c512";
239 compatible = "atmel,24c512";
251 compatible = "atmel,24c512";
|
| D | at91sam9260ek.dts | 168 24c512@50 {
169 compatible = "atmel,24c512";
|
| D | at91sam9263ek.dts | 213 atmel,vbus-gpio = <&pioA 24 GPIO_ACTIVE_HIGH
256 24c512@50 {
257 compatible = "atmel,24c512";
|
| D | at91sam9g20ek_common.dtsi | 223 24c512@50 {
224 compatible = "atmel,24c512";
|
| D | ls1021a-qds.dts | 149 compatible = "atmel,24c512";
154 compatible = "atmel,24c512";
|
| D | lpc4357-myd-lpc4357.dts | 519 compatible = "atmel,24c512";
|
| /Linux-v6.1/Documentation/i2c/ |
| D | slave-eeprom-backend.rst | 12 The following types are available: 24c02, 24c32, 24c64, and 24c512. Read-only
16 24c02, read/write, address 0x64:
17 # echo slave-24c02 0x1064 > /sys/bus/i2c/devices/i2c-1/new_device
19 24c512, read-only, address 0x42:
20 # echo slave-24c512ro 0x1042 > /sys/bus/i2c/devices/i2c-1/new_device
|
| /Linux-v6.1/arch/powerpc/boot/dts/fsl/ |
| D | t1024qds.dts | 166 compatible = "atmel,24c512";
171 compatible = "atmel,24c02";
176 compatible = "atmel,24c02";
211 compatible = "atmel,24c02";
216 compatible = "atmel,24c512";
221 compatible = "atmel,24c512";
|
| D | mvme2500.dts | 44 compatible = "atmel,24c64";
49 compatible = "atmel,24c512";
54 compatible = "atmel,24c512";
59 compatible = "atmel,24c02";
|
| D | t208xqds.dtsi | 150 compatible = "atmel,24c512";
155 compatible = "atmel,24c02";
160 compatible = "atmel,24c02";
177 compatible = "atmel,24c02";
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | fsl-ls1088a-qds.dts | 98 compatible = "atmel,24c512";
103 compatible = "atmel,24c512";
|
| D | fsl-ls1043a-rdb.dts | 50 compatible = "atmel,24c512";
55 compatible = "atmel,24c512";
|
| D | fsl-ls1043a-qds.dts | 135 compatible = "atmel,24c512";
140 compatible = "atmel,24c512";
|
| D | fsl-ls1046a-qds.dts | 128 compatible = "atmel,24c512";
133 compatible = "atmel,24c512";
|
| D | fsl-ls1028a-qds.dts | 314 compatible = "atmel,24c512";
319 compatible = "atmel,24c512";
|
| D | fsl-lx2160a-cex7.dtsi | 43 qca,smarteee-tw-us-1g = <24>;
69 compatible = "atmel,24c512";
84 compatible = "atmel,24c02";
|
| /Linux-v6.1/Documentation/devicetree/bindings/misc/ |
| D | idt_89hpesx.txt | 23 - compatible: There are five EEPROM devices supported: 24c32, 24c64, 24c128,
24 24c256 and 24c512 differed by size.
39 compatible = "onsemi,24c64";
|
| /Linux-v6.1/drivers/misc/eeprom/ |
| D | Kconfig | 15 ones like at24c64, 24lc02 or fm24c04:
17 24c00, 24c01, 24c02, spd (readonly 24c02), 24c04, 24c08,
18 24c16, 24c32, 24c64, 24c128, 24c256, 24c512, 24c1024, 24c2048
21 you configure as a 24c32 (32 kbit) or larger is NOT really a
22 24c16 (16 kbit) or smaller, and vice versa. Marking the chip
29 supported (24c16 and below, max 4 kByte).
|
| D | at24.c | 34 /* Take always 8 addresses (24c00). */
46 * MicroChip 24LC, etc) won't much matter for typical read/write access.
48 * would be the PCF8570, which acts like a 24c02 EEPROM (256 bytes).
58 * "SPD" data for DRAM sticks. Those only use 24c02 EEPROMs.)
66 * that this one handles write access and isn't restricted to 24c02 devices.
176 /* spd is a 24c02 in memory DIMMs */
179 /* 24c02_vaio is a 24c02 on some Sony laptops */
186 /* 24rf08 quirk is handled at i2c-core */
205 /* identical to 24c08 ? */
209 { "24c00", (kernel_ulong_t)&at24_data_24c00 },
[all …]
|
| D | idt_89hpesx.c | 1426 { "24c32", 4096},
1427 { "24c64", 8192},
1428 { "24c128", 16384},
1429 { "24c256", 32768},
1430 { "24c512", 65536},
|
| /Linux-v6.1/Documentation/devicetree/bindings/eeprom/ |
| D | at24.yaml | 17 pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
36 … - pattern: "^(atmel|catalyst|microchip|nxp|ramtron|renesas|rohm|st),(24(c|cs|lc|mac)[0-9]+|spd)$"
37 - pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
82 pattern: c512$
105 - const: atmel,24c01
110 - const: atmel,24c02
115 - const: atmel,24c04
118 - const: atmel,24c16
121 - const: atmel,24c32
126 - const: atmel,24c128
[all …]
|
| /Linux-v6.1/Documentation/misc-devices/ |
| D | eeprom.rst | 28 24C01 1K 0x50 (shadows at 0x51 - 0x57)
29 24C01A 1K 0x50 - 0x57 (Typical device on DIMMs)
30 24C02 2K 0x50 - 0x57
31 24C04 4K 0x50, 0x52, 0x54, 0x56
33 24C08 8K 0x50, 0x54 (additional data at 0x51, 0x52,
35 24C16 16K 0x50 (additional data at 0x51 - 0x57)
42 Microchip 24AA52 2K 0x50 - 0x57, SW write protect at 0x30-37
60 24Cxx, and are listed above; however the numbering for these
67 DIMMS will typically contain a 24C01A or 24C02, or the 34C02 variants.
71 DDC Monitors may contain any device. Often a 24C01, which responds to all 8
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/i2c/ |
| D | atmel,at91sam-i2c.yaml | 113 compatible = "atmel,24c512";
142 compatible = "atmel,24c02";
|
| /Linux-v6.1/drivers/i2c/ |
| D | i2c-slave-eeprom.c | 193 { "slave-24c02", I2C_SLAVE_DEVICE_MAGIC(2048 / 8, 0) },
194 { "slave-24c02ro", I2C_SLAVE_DEVICE_MAGIC(2048 / 8, I2C_SLAVE_FLAG_RO) },
195 { "slave-24c32", I2C_SLAVE_DEVICE_MAGIC(32768 / 8, I2C_SLAVE_FLAG_ADDR16) },
196 { "slave-24c32ro", I2C_SLAVE_DEVICE_MAGIC(32768 / 8, I2C_SLAVE_FLAG_ADDR16 | I2C_SLAVE_FLAG_RO) },
197 { "slave-24c64", I2C_SLAVE_DEVICE_MAGIC(65536 / 8, I2C_SLAVE_FLAG_ADDR16) },
198 { "slave-24c64ro", I2C_SLAVE_DEVICE_MAGIC(65536 / 8, I2C_SLAVE_FLAG_ADDR16 | I2C_SLAVE_FLAG_RO) },
199 { "slave-24c512", I2C_SLAVE_DEVICE_MAGIC(524288 / 8, I2C_SLAVE_FLAG_ADDR16) },
200 …{ "slave-24c512ro", I2C_SLAVE_DEVICE_MAGIC(524288 / 8, I2C_SLAVE_FLAG_ADDR16 | I2C_SLAVE_FLAG_RO) …
|
