| /Linux-v6.6/Documentation/devicetree/bindings/eeprom/ |
| D | at24.yaml | 20 pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
39 … - pattern: "^(atmel|catalyst|microchip|nxp|ramtron|renesas|rohm|st),(24(c|cs|lc|mac)[0-9]+|spd)$"
40 - pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
69 pattern: c32$
106 - const: atmel,24c16
111 - const: atmel,24c01
116 - const: atmel,24c02
121 - const: atmel,24c04
124 - const: atmel,24c16
127 - const: atmel,24c32
[all …]
|
| /Linux-v6.6/drivers/misc/eeprom/ |
| D | Kconfig | 16 ones like at24c64, 24lc02 or fm24c04:
18 24c00, 24c01, 24c02, spd (readonly 24c02), 24c04, 24c08,
19 24c16, 24c32, 24c64, 24c128, 24c256, 24c512, 24c1024, 24c2048
22 you configure as a 24c32 (32 kbit) or larger is NOT really a
23 24c16 (16 kbit) or smaller, and vice versa. Marking the chip
30 supported (24c16 and below, max 4 kByte).
|
| /Linux-v6.6/arch/powerpc/boot/dts/ |
| D | pcm030.dts | 70 compatible = "catalyst,24c32", "atmel,24c32";
|
| D | pcm032.dts | 72 compatible = "catalyst,24c32", "atmel,24c32";
|
| D | mpc5121ads.dts | 93 compatible = "atmel,24c32";
|
| /Linux-v6.6/arch/arm/boot/dts/nxp/imx/ |
| D | imx6ul-phytec-phycore-som.dtsi | 80 compatible = "catalyst,24c32", "atmel,24c32";
|
| D | imx6qdl-phytec-phycore-som.dtsi | 90 compatible = "st,24c32", "atmel,24c32";
|
| D | imx27-phytec-phycard-s-som.dtsi | 38 compatible = "atmel,24c32";
|
| D | imx6qdl-phytec-pfla02.dtsi | 70 cs-gpios = <&gpio4 24 GPIO_ACTIVE_LOW>;
115 compatible = "catalyst,24c32", "atmel,24c32";
|
| /Linux-v6.6/Documentation/i2c/ |
| D | slave-eeprom-backend.rst | 12 The following types are available: 24c02, 24c32, 24c64, and 24c512. Read-only
16 24c02, read/write, address 0x64:
17 # echo slave-24c02 0x1064 > /sys/bus/i2c/devices/i2c-1/new_device
19 24c512, read-only, address 0x42:
20 # echo slave-24c512ro 0x1042 > /sys/bus/i2c/devices/i2c-1/new_device
|
| /Linux-v6.6/arch/arm64/boot/dts/mediatek/ |
| D | mt8183-kukui-krane.dtsi | 78 compatible = "atmel,24c32";
93 compatible = "atmel,24c32";
|
| D | mt8183-kukui-kakadu.dtsi | 94 compatible = "atmel,24c32";
109 compatible = "atmel,24c32";
|
| /Linux-v6.6/drivers/net/ethernet/freescale/fs_enet/ |
| D | mac-fcc.c | 55 #define C32(_p, _m, _v) W32(_p, _m, R32(_p, _m) & ~(_v)) macro
214 C32(fccp, fcc_fpsmr, FCC_PSMR_PRO); in set_multicast_finish()
254 C32(fccp, fcc_gfmr, FCC_GFMR_ENR | FCC_GFMR_ENT); in restart()
273 W32(ep, fen_genfcc.fcc_rstate, (CPMFCR_GBL | CPMFCR_EB) << 24); in restart()
274 W32(ep, fen_genfcc.fcc_tstate, (CPMFCR_GBL | CPMFCR_EB) << 24); in restart()
396 C32(fccp, fcc_fpsmr, FCC_PSMR_FDE | FCC_PSMR_LPB); in restart()
410 C32(fccp, fcc_gfmr, FCC_GFMR_ENR | FCC_GFMR_ENT); in stop()
553 C32(fccp, fcc_gfmr, FCC_GFMR_ENT); in tx_restart()
|
| /Linux-v6.6/arch/arm64/boot/dts/freescale/ |
| D | fsl-ls1028a-kontron-sl28.dts | 307 compatible = "atmel,24c32";
321 compatible = "atmel,24c32";
|
| D | fsl-ls1028a-kontron-kbox-a-230-ls.dts | 72 compatible = "atmel,24c32";
|
| /Linux-v6.6/Documentation/devicetree/bindings/i2c/ |
| D | i2c-altera.txt | 34 compatible = "atmel,24c32";
|
| D | amlogic,meson6-i2c.yaml | 52 compatible = "atmel,24c32";
|
| /Linux-v6.6/arch/arm/boot/dts/ti/omap/ |
| D | omap4-var-som-om44.dtsi | 233 compatible = "microchip,24c32", "atmel,24c32";
|
| /Linux-v6.6/Documentation/misc-devices/ |
| D | eeprom.rst | 28 24C01 1K 0x50 (shadows at 0x51 - 0x57)
29 24C01A 1K 0x50 - 0x57 (Typical device on DIMMs)
30 24C02 2K 0x50 - 0x57
31 24C04 4K 0x50, 0x52, 0x54, 0x56
33 24C08 8K 0x50, 0x54 (additional data at 0x51, 0x52,
35 24C16 16K 0x50 (additional data at 0x51 - 0x57)
42 Microchip 24AA52 2K 0x50 - 0x57, SW write protect at 0x30-37
60 24Cxx, and are listed above; however the numbering for these
67 DIMMS will typically contain a 24C01A or 24C02, or the 34C02 variants.
71 DDC Monitors may contain any device. Often a 24C01, which responds to all 8
[all …]
|
| /Linux-v6.6/arch/arm/boot/dts/intel/socfpga/ |
| D | socfpga_cyclone5_sodia.dts | 91 compatible = "atmel,24c32";
|
| D | socfpga_arria5_socdk.dts | 99 compatible = "atmel,24c32";
|
| D | socfpga_cyclone5_socdk.dts | 103 compatible = "atmel,24c32";
|
| D | socfpga_arria10_socdk.dtsi | 151 compatible = "atmel,24c32";
|
| /Linux-v6.6/arch/arm/boot/dts/microchip/ |
| D | at91-dvk_su60_somc.dtsi | 74 compatible = "giantec,gt24c32a", "atmel,24c32";
|
| /Linux-v6.6/drivers/i2c/ |
| D | i2c-slave-eeprom.c | 194 { "slave-24c02", I2C_SLAVE_DEVICE_MAGIC(2048 / 8, 0) },
195 { "slave-24c02ro", I2C_SLAVE_DEVICE_MAGIC(2048 / 8, I2C_SLAVE_FLAG_RO) },
196 { "slave-24c32", I2C_SLAVE_DEVICE_MAGIC(32768 / 8, I2C_SLAVE_FLAG_ADDR16) },
197 { "slave-24c32ro", I2C_SLAVE_DEVICE_MAGIC(32768 / 8, I2C_SLAVE_FLAG_ADDR16 | I2C_SLAVE_FLAG_RO) },
198 { "slave-24c64", I2C_SLAVE_DEVICE_MAGIC(65536 / 8, I2C_SLAVE_FLAG_ADDR16) },
199 { "slave-24c64ro", I2C_SLAVE_DEVICE_MAGIC(65536 / 8, I2C_SLAVE_FLAG_ADDR16 | I2C_SLAVE_FLAG_RO) },
200 { "slave-24c512", I2C_SLAVE_DEVICE_MAGIC(524288 / 8, I2C_SLAVE_FLAG_ADDR16) },
201 …{ "slave-24c512ro", I2C_SLAVE_DEVICE_MAGIC(524288 / 8, I2C_SLAVE_FLAG_ADDR16 | I2C_SLAVE_FLAG_RO) …
|
