| /Linux-v5.15/arch/powerpc/boot/dts/ |
| D | ac14xx.dts | 166 wp-gpios = <&gpio_pic 24 0>; /* write protect */
175 compatible = "atmel,24c01";
180 compatible = "atmel,24c01";
190 compatible = "atmel,24c01";
195 compatible = "atmel,24c01";
200 compatible = "atmel,24c01";
205 compatible = "atmel,24c01";
210 compatible = "atmel,24c01";
215 compatible = "atmel,24c01";
220 compatible = "atmel,24c01";
[all …]
|
| D | pdm360ng.dts | 97 compatible = "atmel,24c01";
|
| /Linux-v5.15/Documentation/devicetree/bindings/eeprom/ |
| D | at24.yaml | 17 pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
36 … - pattern: "^(atmel|catalyst|microchip|nxp|ramtron|renesas|rohm|st),(24(c|cs|lc|mac)[0-9]+|spd)$"
37 - pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
42 pattern: c01$
99 - const: atmel,24c02
102 - const: atmel,24c02
105 - const: atmel,24c16
108 - const: atmel,24c32
111 - const: atmel,24c128
114 - const: atmel,24c01
[all …]
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | socfpga_cyclone5_vining_fpga.dts | 139 compatible = "atmel,24c01";
191 compatible = "atmel,24c01";
202 compatible = "atmel,24c01";
215 compatible = "atmel,24c02";
|
| D | omap3-overo-common-peripherals.dtsi | 49 compatible = "atmel,24c01";
|
| D | omap4-duovero-parlor.dts | 124 compatible = "atmel,24c01";
|
| D | am3874-iceboard.dts | 252 at24c01@57 { compatible = "atmel,24c01"; reg = <0x57>; };
253 at24cs01@5f { compatible = "atmel,24cs01"; reg = <0x5f>; };
273 at24c08@54 { compatible="atmel,24c08"; reg=<0x54>; };
274 at24cs08@5c { compatible="atmel,24cs08"; reg=<0x5c>; };
395 "FPGA_TMS", "FPGA_TCK", "FPGA_TDO", "FPGA_TDI", /* 24-27 */
|
| D | aspeed-bmc-ibm-everest.dts | 271 compatible = "atmel,24c64";
395 compatible = "atmel,24c128";
508 compatible = "atmel,24c64";
522 label = "cablecard-c01-cxp-top";
530 label = "cablecard-c01-cxp-bot";
574 compatible = "atmel,24c64";
640 compatible = "atmel,24c64";
804 compatible = "atmel,24c64";
870 compatible = "atmel,24c64";
936 compatible = "atmel,24c64";
[all …]
|
| /Linux-v5.15/Documentation/misc-devices/ |
| D | eeprom.rst | 28 24C01 1K 0x50 (shadows at 0x51 - 0x57)
29 24C01A 1K 0x50 - 0x57 (Typical device on DIMMs)
30 24C02 2K 0x50 - 0x57
31 24C04 4K 0x50, 0x52, 0x54, 0x56
33 24C08 8K 0x50, 0x54 (additional data at 0x51, 0x52,
35 24C16 16K 0x50 (additional data at 0x51 - 0x57)
42 Microchip 24AA52 2K 0x50 - 0x57, SW write protect at 0x30-37
60 24Cxx, and are listed above; however the numbering for these
67 DIMMS will typically contain a 24C01A or 24C02, or the 34C02 variants.
71 DDC Monitors may contain any device. Often a 24C01, which responds to all 8
[all …]
|
| /Linux-v5.15/arch/m68k/ifpsp060/ |
| D | fplsp.sa | 2 dc.l $60ff0000,$24b60000,$60ff0000,$11060000
13 dc.l $60ff0000,$24a60000,$60ff0000,$25380000
74 dc.l $660861ff,$00007124,$60220c01,$00026608
83 dc.l $660861ff,$00002d3e,$60300c01,$00016608
85 dc.l $00006c84,$60140c01,$00036608,$61ff0000
93 dc.l $660861ff,$00002c9e,$60300c01,$00016608
95 dc.l $00006be4,$60140c01,$00036608,$61ff0000
104 dc.l $60220c01,$00026608,$61ff0000,$6b4a6014
113 dc.l $60300c01,$00016608,$61ff0000,$6f2a6022
114 dc.l $0c010002,$660861ff,$00006aac,$60140c01
[all …]
|
| /Linux-v5.15/arch/arm64/boot/dts/renesas/ |
| D | r8a779a0-falcon-ethernet.dtsi | 10 compatible = "rohm,br24g01", "atmel,24c01";
|
| D | r8a779a0-falcon-csi-dsi.dtsi | 31 compatible = "rohm,br24g01", "atmel,24c01";
|
| D | r8a779a0-falcon.dts | 40 compatible = "rohm,br24g01", "atmel,24c01";
|
| D | r8a779a0-falcon-cpu.dtsi | 104 compatible = "rohm,br24g01", "atmel,24c01";
|
| /Linux-v5.15/Documentation/devicetree/bindings/i3c/ |
| D | snps,dw-i3c-master.txt | 37 compatible = "atmel,24c01";
|
| D | i3c.yaml | 161 compatible = "atmel,24c01";
|
| /Linux-v5.15/drivers/misc/eeprom/ |
| D | Kconfig | 15 ones like at24c64, 24lc02 or fm24c04:
17 24c00, 24c01, 24c02, spd (readonly 24c02), 24c04, 24c08,
18 24c16, 24c32, 24c64, 24c128, 24c256, 24c512, 24c1024, 24c2048
21 you configure as a 24c32 (32 kbit) or larger is NOT really a
22 24c16 (16 kbit) or smaller, and vice versa. Marking the chip
29 supported (24c16 and below, max 4 kByte).
|
| D | at24.c | 34 /* Take always 8 addresses (24c00). */
46 * MicroChip 24LC, etc) won't much matter for typical read/write access.
48 * would be the PCF8570, which acts like a 24c02 EEPROM (256 bytes).
58 * "SPD" data for DRAM sticks. Those only use 24c02 EEPROMs.)
66 * that this one handles write access and isn't restricted to 24c02 devices.
173 /* spd is a 24c02 in memory DIMMs */
176 /* 24c02_vaio is a 24c02 on some Sony laptops */
183 /* 24rf08 quirk is handled at i2c-core */
201 /* identical to 24c08 ? */
205 { "24c00", (kernel_ulong_t)&at24_data_24c00 },
[all …]
|
| /Linux-v5.15/Documentation/i2c/ |
| D | instantiating-devices.rst | 41 compatible = "atmel,24c256";
82 I2C_BOARD_INFO("24c01", 0x52),
86 I2C_BOARD_INFO("24c01", 0x57),
|
| /Linux-v5.15/arch/arm64/boot/dts/rockchip/ |
| D | rk3368-lion-haikou.dts | 24 compatible = "atmel,24c01";
|
| /Linux-v5.15/arch/powerpc/boot/dts/fsl/ |
| D | p1010rdb.dtsi | 92 compatible = "st,24c256", "atmel,24c256";
104 compatible = "atmel,24c01";
|
| /Linux-v5.15/Documentation/devicetree/bindings/display/panel/ |
| D | panel-simple.yaml | 108 # DataImage, Inc. 7" WVGA (800x480) TFT LCD panel with 24-bit parallel interface.
268 - samsung,lsn122dl01-c01
313 - vxt,vl050-8048nt-c01
|
| /Linux-v5.15/arch/arm64/boot/dts/freescale/ |
| D | imx8mq-sr-som.dtsi | 130 compatible = "atmel,24c01";
|
| /Linux-v5.15/arch/arc/boot/dts/ |
| D | axs10x_mb.dtsi | 221 compatible = "atmel,24c01";
227 compatible = "atmel,24c04";
|
| /Linux-v5.15/drivers/staging/media/ipu3/include/uapi/ |
| D | intel-ipu3.h | 128 * Each histogram contains IPU3_UAPI_AE_BINS bins. Each bin has 24 bit unsigned
148 * @height: Grid vertical dimensions. Value: [16, 24], default 16.
373 #define IPU3_UAPI_AF_MAX_SETS 24
410 #define IPU3_UAPI_AWB_FR_MAX_SETS 24
579 #define IPU3_UAPI_YUVP2_TCC_R_SQR_LUT_ELEMENTS 24
1183 __u8 reserved1[24];
1188 __u8 reserved2[24];
1311 __u32 reserved2:24;
1350 __u32 reserved3:24;
1566 * @c01: Coeff12, s0.8, range [-255, 255], default 5.
[all …]
|
