| /Linux-v6.1/Documentation/admin-guide/media/ |
| D | saa7134-cardlist.rst | 95 - 185b:c100
179 - 185b:c100
183 - 185b:c100
215 - 185b:c200
299 - 185b:c900
303 - 185b:c901
575 - 185b:c900
695 - 185b:c900
751 - 185b:c900
757 * - 185
|
| D | dvb-usb-dibusb-mb-cardlist.rst | 26 - 185b:d000, 145f:010c, 185b:d001
|
| D | dvb-usb-rtl28xxu-cardlist.rst | 20 - 185b:0620
22 - 185b:0650
|
| D | dvb-usb-dib0700-cardlist.rst | 28 - 185b:1e78, 185b:1e80
|
| D | em28xx-cardlist.rst | 204 - 185b:2870
252 - 185b:2041
|
| /Linux-v6.1/drivers/hid/ |
| D | hid-ite.c | 27 if (*rsize == 188 && rdesc[185] == 0x81 && rdesc[186] == 0x02) { in ite_report_fixup()
32 if (*rsize == 210 && rdesc[184] == 0x81 && rdesc[185] == 0x02) { in ite_report_fixup()
34 rdesc[185] = HID_MAIN_ITEM_RELATIVE; in ite_report_fixup()
|
| /Linux-v6.1/drivers/media/platform/ti/omap3isp/ |
| D | gamma_table.h | 32 183, 183, 183, 184, 184, 184, 184, 185, 185, 185, 185, 186, 186, 186, 186, 187,
|
| /Linux-v6.1/Documentation/devicetree/bindings/regulator/ |
| D | mt6323-regulator.txt | 60 regulator-enable-ramp-delay = <185>;
67 regulator-enable-ramp-delay = <185>;
74 regulator-enable-ramp-delay = <185>;
|
| /Linux-v6.1/drivers/mmc/host/ |
| D | sdhci-of-aspeed-test.c | 40 aspeed_sdhci_phase_to_tap(NULL, rate, 185)); in aspeed_sdhci_phase_ddr52()
73 aspeed_sdhci_phase_to_tap(NULL, rate, 185)); in aspeed_sdhci_phase_hs200()
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | stm32mp15xx-dhcom-picoitx.dtsi | 82 i2c-scl-rising-time-ns = <185>;
93 i2c-scl-rising-time-ns = <185>;
|
| D | mt6323.dtsi | 64 regulator-enable-ramp-delay = <185>;
71 regulator-enable-ramp-delay = <185>;
78 regulator-enable-ramp-delay = <185>;
|
| D | stm32mp15xx-dhcom-drc02.dtsi | 75 i2c-scl-rising-time-ns = <185>;
99 i2c-scl-rising-time-ns = <185>;
|
| D | stm32mp15xx-dhcom-pdk2.dtsi | 158 i2c-scl-rising-time-ns = <185>;
170 i2c-scl-rising-time-ns = <185>;
|
| /Linux-v6.1/include/dt-bindings/clock/ |
| D | tegra124-car-common.h | 9 * this case, those clocks are assigned IDs above 185 in order to highlight
14 * The balance of the clocks controlled by the CAR are assigned IDs of 185 and
211 #define TEGRA124_CLK_AMX1 185
|
| D | rv1108-cru.h | 81 #define DCLK_VOP_SRC 185
351 #define ARST_DSP_EPP_PERF 185
|
| /Linux-v6.1/drivers/net/appletalk/ |
| D | cops_ltdrv.h | 112 33,171,10,205,93,6,58,185,10,50,186,10,
114 56,16,58,185,10,135,60,230,15,50,185,10,
116 254,3,48,13,58,185,10,203,63,50,185,10,
117 62,255,50,183,10,58,185,10,50,186,10,58,
|
| /Linux-v6.1/Documentation/dev-tools/ |
| D | coccinelle.rst | 428 @@ -185,7 +185,7 @@ static struct crypto_instance *crypto_ct
473 @@ -185,7 +185,6 @@ static struct crypto_instance *crypto_ct
|
| /Linux-v6.1/arch/arm64/boot/dts/ti/ |
| D | k3-am62a-mcu.dtsi | 21 interrupts = <GIC_SPI 185 IRQ_TYPE_LEVEL_HIGH>;
|
| /Linux-v6.1/arch/arm64/boot/dts/mediatek/ |
| D | mt2712-pinfunc.h | 941 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_GPIO185 (MTK_PIN_NO(185) | 0)
942 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_AUD_EXT_CK2 (MTK_PIN_NO(185) | 1)
943 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_AUD_EXT_CK1 (MTK_PIN_NO(185) | 2)
944 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_I2SO1_DO (MTK_PIN_NO(185) | 3)
945 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_I2SI2_DI (MTK_PIN_NO(185) | 4)
946 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_MRG_RX (MTK_PIN_NO(185) | 5)
947 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_PCM1_DI (MTK_PIN_NO(185) | 6)
948 #define MT2712_PIN_185_AUD_EXT_CK2__FUNC_I2S_IQ0_SDQB (MTK_PIN_NO(185) | 7)
|
| /Linux-v6.1/arch/arm/mach-s3c/ |
| D | pll-s3c2440-16934400.c | 25 { .frequency = 102135600, .driver_data = PLLVAL(185, 6, 3), }, /* FVco 817.084800 */
42 { .frequency = 204271200, .driver_data = PLLVAL(185, 6, 2), }, /* FVco 817.084800 */
|
| /Linux-v6.1/drivers/pinctrl/uniphier/ |
| D | pinctrl-uniphier-pxs2.c | 570 UNIPHIER_PINCTRL_PIN(185, "PORT230", UNIPHIER_PIN_IECTRL_NONE,
572 185, UNIPHIER_PIN_PULL_DOWN),
748 static const unsigned aout2_dat4_pins[] = {184, 185};
783 static const unsigned i2c6_pins[] = {185, 186};
806 static const unsigned uart0b_ctsrts_pins[] = {183, 185};
855 185, 187, 188, 189, 190, 191, 192, 193, /* PORT23x */
|
| /Linux-v6.1/drivers/video/logo/ |
| D | logo_spe_clut224.ppm | 215 242 185 13 245 188 14 246 190 14 246 190 14 246 190 14 246 190 14
222 242 185 13 246 190 14 246 190 14 246 190 14 246 190 14 246 190 14
229 242 185 13 246 190 14 246 190 14 246 190 14 246 190 14 246 190 14
233 245 188 14 246 190 14 246 190 14 246 190 14 242 185 13 150 116 44
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | qoriq-bman-portals.dtsi | 57 interrupts = <GIC_SPI 185 IRQ_TYPE_LEVEL_HIGH>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/dma/ |
| D | fsl-qdma.txt | 44 interrupts = <GIC_SPI 185 IRQ_TYPE_LEVEL_HIGH>,
|
| /Linux-v6.1/Documentation/devicetree/bindings/net/ |
| D | samsung-sxgbe.txt | 40 interrupts = <0 209 4>, <0 185 4>, <0 186 4>, <0 187 4>,
|
