Searched full:155 (Results 1 – 25 of 525) sorted by relevance
12345678910>>...21
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | omap-zoom-common.dtsi | 33 gpmc,cs-rd-off-ns = <155>;
34 gpmc,cs-wr-off-ns = <155>;
42 gpmc,rd-cycle-ns = <155>;
43 gpmc,wr-cycle-ns = <155>;
|
| D | omap-gpmc-smsc911x.dtsi | 40 gpmc,rd-cycle-ns = <155>;
41 gpmc,wr-cycle-ns = <155>;
|
| D | omap3-sb-t35.dtsi | 123 gpmc,rd-cycle-ns = <155>;
124 gpmc,wr-cycle-ns = <155>;
|
| /Linux-v6.1/arch/arm64/boot/dts/xilinx/ |
| D | zynqmp.dtsi | 715 interrupts = <0 155 4>,
716 <0 155 4>, <0 155 4>, <0 155 4>, <0 155 4>,
717 <0 155 4>, <0 155 4>, <0 155 4>, <0 155 4>,
718 <0 155 4>, <0 155 4>, <0 155 4>, <0 155 4>,
719 <0 155 4>, <0 155 4>, <0 155 4>, <0 155 4>;
|
| /Linux-v6.1/drivers/atm/ |
| D | Kconfig | 45 Power155 155 Mbps ATM adapters. Both, the versions with 512KB and
154 25 and for 155 Mbps, including IDT cards and the Fore ForeRunnerLE
161 bool "Use suni PHY driver (155Mbps)"
165 found in most 155Mbps NICStAR based ATM cards, namely in the
309 cards. It simultaneously supports the 155 and 622 versions.
|
| D | suni.h | 102 #define SUNI_MRI_TYPE_PM5346 0x3 /* S/UNI 155 LITE */
103 #define SUNI_MRI_TYPE_PM5347 0x4 /* S/UNI 155 PLUS */
104 #define SUNI_MRI_TYPE_PM5350 0x7 /* S/UNI 155 ULTRA */
|
| D | suni.c | 7 * PMC PM5350 S/UNI 155 ULTRA
190 * LEN16 (register 0x28): 0 for SONET, 1 for SDH (n/a for S/UNI 155 QUAD)
191 * LEN16 (register 0x50): 0 for SONET, 1 for SDH (n/a for S/UNI 155 QUAD)
|
| /Linux-v6.1/arch/arm/mach-mmp/ |
| D | flint.c | 93 .start = MMP_GPIO_TO_IRQ(155),
94 .end = MMP_GPIO_TO_IRQ(155),
|
| /Linux-v6.1/drivers/usb/chipidea/ |
| D | otg_fsm.h | 56 #define TB_ASE0_BRST (155) /* minimum 155 ms, section:5.3.1 */
|
| /Linux-v6.1/sound/ppc/ |
| D | burgundy.h | 65 /* Remember: lowest volume here is 0x9B (155) */
99 #define BURGUNDY_VOLUME_OFFSET 155
|
| /Linux-v6.1/drivers/pinctrl/uniphier/ |
| D | pinctrl-uniphier-ld4.c | 110 155, UNIPHIER_PIN_PULL_UP),
480 UNIPHIER_PINCTRL_PIN(155, "PORT24", UNIPHIER_PIN_IECTRL_NONE,
576 static const unsigned system_bus_cs0_pins[] = {155};
590 static const unsigned uart1_pins[] = {155, 156};
602 static const unsigned usb2_pins[] = {155, 156};
609 151, 152, 153, 154, 155, 156, 157, 0, /* PORT2x */
|
| D | pinctrl-uniphier-ld11.c | 426 UNIPHIER_PINCTRL_PIN(155, "XIRQ6", UNIPHIER_PIN_IECTRL_EXIST,
427 155, UNIPHIER_PIN_DRV_1BIT,
428 155, UNIPHIER_PIN_PULL_DOWN),
466 static const unsigned ain1_dat2_pins[] = {155};
576 149, 150, 151, 152, 153, 154, 155, 156, /* XIRQ0-7 */
588 155, 156, 157, 143, 144, 145, 146, 158, /* PORT24x */
|
| D | pinctrl-uniphier-pxs2.c | 480 UNIPHIER_PINCTRL_PIN(155, "RGMII_TXD1", 0,
481 155, UNIPHIER_PIN_DRV_1BIT,
482 155, UNIPHIER_PIN_PULL_DOWN),
761 150, 151, 152, 153, 154, 155, 156,
766 150, 151, 152, 153, 154, 155, 156,
771 150, 152, 154, 155, 158};
852 150, 151, 152, 153, 154, 155, 156, 157, /* PORT20x */
|
| /Linux-v6.1/drivers/cpufreq/ |
| D | longhaul.h | 193 155, /* 1101 -> 15.5x */
229 155, /* 1101 -> 15.5x */
267 155, /* 1101 -> 15.5x */
302 155, /* 1101 -> 15.5x */
|
| /Linux-v6.1/arch/arm64/boot/dts/mediatek/ |
| D | mt8183-kukui-jacuzzi-damu.dts | 21 interrupts = <155 IRQ_TYPE_LEVEL_LOW>;
|
| D | mt8183-kukui-jacuzzi-burnet.dts | 25 interrupts-extended = <&pio 155 IRQ_TYPE_LEVEL_LOW>;
|
| D | mt8183-kukui-jacuzzi-fennel-sku6.dts | 21 interrupts = <155 IRQ_TYPE_LEVEL_LOW>;
|
| D | mt8183-kukui-jacuzzi-fennel-sku7.dts | 21 interrupts = <155 IRQ_TYPE_LEVEL_LOW>;
|
| D | mt8183-kukui-jacuzzi-fennel-sku1.dts | 34 interrupts = <155 IRQ_TYPE_LEVEL_LOW>;
|
| /Linux-v6.1/drivers/gpu/drm/i915/display/ |
| D | intel_vbt_defs.h | 284 /* dvo_port pre BDB 155 */
289 /* dvo_port BDB 155+ */
325 /* DDC Bus DDI Type 155+ */
393 * BDB versions 155 and below are considered legacy, and version 155 seems to be
602 u8 custom_vbt_version; /* 155+ */
|
| /Linux-v6.1/include/dt-bindings/clock/ |
| D | rk3328-cru.h | 126 #define ACLK_IEP 155
365 #define SRST_DDRSTDY 155
|
| D | exynos5410.h | 33 #define CLK_SCLK_PWM 155
|
| /Linux-v6.1/Documentation/accounting/ |
| D | cgroupstats.rst | 31 sleeping 155, blocked 0, running 1, stopped 0, uninterruptible 2
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | hisilicon,hi6210-i2s.txt | 30 interrupts = <GIC_SPI 123 IRQ_TYPE_LEVEL_HIGH>; /* 155 "DigACodec_intr"-32 */
|
| /Linux-v6.1/Documentation/devicetree/bindings/misc/ |
| D | olpc,xo1.75-ec.yaml | 52 cmd-gpios = <&gpio 155 GPIO_ACTIVE_HIGH>;
|
12345678910>>...21
