Searched +full:0 +full:xe0100000 (Results 1 – 13 of 13) sorted by relevance
/Linux-v6.6/Documentation/devicetree/bindings/crypto/ |
D | amd-ccp.txt | 14 reg = <0 0xe0100000 0 0x10000>; 16 interrupts = <0 3 4>;
|
/Linux-v6.6/Documentation/devicetree/bindings/clock/ |
D | samsung,s5pv210-clock.yaml | 59 xxti: clock-0 { 61 clock-frequency = <0>; 63 #clock-cells = <0>; 68 clock-frequency = <0>; 70 #clock-cells = <0>; 75 reg = <0xe0100000 0x10000>;
|
/Linux-v6.6/arch/arm/mach-spear/ |
D | spear.h | 18 #define SPEAR_ICM1_2_BASE UL(0xD0000000) 19 #define VA_SPEAR_ICM1_2_BASE IOMEM(0xFD000000) 20 #define SPEAR_ICM1_UART_BASE UL(0xD0000000) 22 #define SPEAR3XX_ICM1_SSP_BASE UL(0xD0100000) 25 #define SPEAR_ICM3_ML1_2_BASE UL(0xF0000000) 26 #define VA_SPEAR6XX_ML_CPU_BASE IOMEM(0xF0000000) 29 #define SPEAR_ICM3_SMI_CTRL_BASE UL(0xFC000000) 30 #define VA_SPEAR_ICM3_SMI_CTRL_BASE IOMEM(0xFC000000) 31 #define SPEAR_ICM3_DMA_BASE UL(0xFC400000) 32 #define SPEAR_ICM3_SYS_CTRL_BASE UL(0xFCA00000) [all …]
|
/Linux-v6.6/Documentation/devicetree/bindings/gpio/ |
D | gpio-mmio.yaml | 40 of GPIOs is set by the width, with bit 0 corresponding to GPIO 0. 54 actively writing the line with 0. 95 reg = <0x1f300010 0x4>; 104 reg = <0xe0100000 0x1>; 113 reg = <0xfffe0406 2>, <0xfffe040a 2>;
|
/Linux-v6.6/arch/powerpc/boot/dts/ |
D | mpc832x_rdb.dts | 26 #size-cells = <0>; 28 PowerPC,8323@0 { 30 reg = <0x0>; 31 d-cache-line-size = <0x20>; // 32 bytes 32 i-cache-line-size = <0x20>; // 32 bytes 35 timebase-frequency = <0>; 36 bus-frequency = <0>; 37 clock-frequency = <0>; 43 reg = <0x00000000 0x04000000>; 51 ranges = <0x0 0xe0000000 0x00100000>; [all …]
|
D | ac14xx.dts | 25 PowerPC,5121@0 { 33 reg = <0x00000000 0x10000000>; /* 256MB at 0 */ 41 ranges = <0x0 0x0 0xfc000000 0x04000000 /* CS0: NOR flash */ 42 0x1 0x0 0xe0000000 0x00010000 /* CS1: FRAM */ 43 0x2 0x0 0xe0100000 0x00080000 /* CS2: asi1 */ 44 0x3 0x0 0xe0300000 0x00020000 /* CS3: comm */ 45 0x5 0x0 0xe0400000 0x00010000 /* CS5: safety */ 46 0x6 0x0 0xe0200000 0x00080000>; /* CS6: asi2 */ 48 flash@0,0 { 50 reg = <0 0x00000000 0x04000000>; [all …]
|
D | sequoia.dts | 22 dcr-parent = <&{/cpus/cpu@0}>; 35 #size-cells = <0>; 37 cpu@0 { 40 reg = <0x00000000>; 41 clock-frequency = <0>; /* Filled in by zImage */ 42 timebase-frequency = <0>; /* Filled in by zImage */ 54 reg = <0x00000000 0x00000000 0x00000000>; /* Filled in by zImage */ 60 cell-index = <0>; 61 dcr-reg = <0x0c0 0x009>; 62 #address-cells = <0>; [all …]
|
/Linux-v6.6/Documentation/devicetree/bindings/spi/ |
D | spi-pl022.yaml | 47 runtime power management system suspends the device. A setting of 0 78 "^[a-zA-Z][a-zA-Z0-9,+\\-._]{0,63}@[0-9a-f]+$": 87 - 0 # SPI 95 - 0 # interrupt mode 103 minimum: 0 109 minimum: 0 115 minimum: 0x03 116 maximum: 0x1f 121 enum: [0, 1] 126 enum: [0, 1] [all …]
|
/Linux-v6.6/arch/arm/boot/dts/st/ |
D | spear13xx.dtsi | 15 #size-cells = <0>; 17 cpu@0 { 20 reg = <0>; 36 reg = < 0xec801000 0x1000 >, 37 < 0xec800100 0x0100 >; 42 interrupts = <0 6 0x04>, 43 <0 7 0x04>; 48 reg = <0xed000000 0x1000>; 56 reg = <0 0x40000000>; 79 ranges = <0x50000000 0x50000000 0x10000000 [all …]
|
/Linux-v6.6/Documentation/devicetree/bindings/mmc/ |
D | arasan,sdhci.yaml | 137 enum: [0, 1] 158 enum: [0, 1, 2] 159 default: 0 185 reg = <0xe0100000 0x1000>; 189 interrupts = <0 24 4>; 195 reg = <0xe2800000 0x1000>; 199 interrupts = <0 24 4>; 210 reg = <0xfe330000 0x10000>; 220 #clock-cells = <0>; 227 interrupts = <0 48 4>; [all …]
|
/Linux-v6.6/arch/arm64/boot/dts/amd/ |
D | amd-seattle-soc.dtsi | 20 reg = <0x0 0xe1110000 0 0x1000>, 21 <0x0 0xe112f000 0 0x2000>, 22 <0x0 0xe1140000 0 0x2000>, 23 <0x0 0xe1160000 0 0x2000>; 24 interrupts = <1 9 0xf04>; 25 ranges = <0 0 0 0xe1100000 0 0x100000>; 29 reg = <0x0 0x00080000 0 0x1000>; 35 interrupts = <1 13 0xff04>, 36 <1 14 0xff04>, 37 <1 11 0xff04>, [all …]
|
/Linux-v6.6/arch/arm/boot/dts/xilinx/ |
D | zynq-7000.dtsi | 13 #size-cells = <0>; 15 cpu0: cpu@0 { 18 reg = <0>; 47 interrupts = <0 5 4>, <0 6 4>; 49 reg = <0xf8891000 0x1000>, 50 <0xf8893000 0x1000>; 69 #size-cells = <0>; 72 port@0 { 73 reg = <0>; 104 reg = <0xf8007100 0x20>; [all …]
|
/Linux-v6.6/arch/arm/boot/dts/samsung/ |
D | s5pv210.dtsi | 46 #size-cells = <0>; 48 cpu@0 { 51 reg = <0>; 55 xxti: oscillator-0 { 57 clock-frequency = <0>; 59 #clock-cells = <0>; 64 clock-frequency = <0>; 66 #clock-cells = <0>; 77 reg = <0xb0600000 0x2000>, 78 <0xb0000000 0x20000>, [all …]
|