Searched +full:0 +full:xd2000000 (Results 1 – 8 of 8) sorted by relevance
/Linux-v6.1/Documentation/devicetree/bindings/mtd/ |
D | fsmc-nand.txt | 15 byte 0 TCLR : CLE to RE delay in number of AHB clock cycles, only 4 bits 32 - bank: default NAND bank to use (0-3 are valid, 0 is the default). 46 reg = <0xd1800000 0x1000 /* FSMC Register */ 47 0xd2000000 0x0010 /* NAND Base DATA */ 48 0xd2020000 0x0010 /* NAND Base ADDR */ 49 0xd2010000 0x0010>; /* NAND Base CMD */ 54 timings = /bits/ 8 <0 0 0 2 3 0>; 57 partition@0 {
|
/Linux-v6.1/Documentation/devicetree/bindings/crypto/ |
D | hisilicon,hip07-sec.txt | 9 Region 0 has registers to control the backend processing engines. 16 Interrupt 0 is for the SEC unit error queue. 29 reg = <0x400 0xd0000000 0x0 0x10000 30 0x400 0xd2000000 0x0 0x10000 31 0x400 0xd2010000 0x0 0x10000 32 0x400 0xd2020000 0x0 0x10000 33 0x400 0xd2030000 0x0 0x10000 34 0x400 0xd2040000 0x0 0x10000 35 0x400 0xd2050000 0x0 0x10000 36 0x400 0xd2060000 0x0 0x10000 [all …]
|
/Linux-v6.1/Documentation/devicetree/bindings/pci/ |
D | intel-gw-pcie.yaml | 96 reg = <0xd0e00000 0x1000>, 97 <0xd2000000 0x800000>, 98 <0xd0a41000 0x1000>; 100 linux,pci-domain = <0>; 102 bus-range = <0x00 0x08>; 104 interrupt-map-mask = <0 0 0 0x7>; 105 interrupt-map = <0 0 0 1 &ioapic1 27 1>, 106 <0 0 0 2 &ioapic1 28 1>, 107 <0 0 0 3 &ioapic1 29 1>, 108 <0 0 0 4 &ioapic1 30 1>; [all …]
|
/Linux-v6.1/arch/arm/boot/dts/ |
D | spear600.dtsi | 12 #address-cells = <0>; 13 #size-cells = <0>; 23 reg = <0 0x40000000>; 30 ranges = <0xd0000000 0xd0000000 0x30000000>; 35 reg = <0xf1100000 0x1000>; 42 reg = <0xf1000000 0x1000>; 48 reg = <0xfc200000 0x1000>; 56 reg = <0xfc400000 0x1000>; 64 reg = <0xe0800000 0x8000>; 76 reg = <0xd1800000 0x1000 /* FSMC Register */ [all …]
|
D | imx27.dtsi | 47 reg = <0x10040000 0x1000>; 53 #clock-cells = <0>; 59 #size-cells = <0>; 62 cpu: cpu@0 { 64 reg = <0>; 88 reg = <0x10000000 0x20000>; 93 reg = <0x10001000 0x1000>; 104 reg = <0x10002000 0x1000>; 111 reg = <0x10003000 0x1000>; 120 reg = <0x10004000 0x1000>; [all …]
|
/Linux-v6.1/arch/arm64/boot/dts/hisilicon/ |
D | hip07.dtsi | 23 #size-cells = <0>; 270 reg = <0x10000>; 273 numa-node-id = <0>; 279 reg = <0x10001>; 282 numa-node-id = <0>; 288 reg = <0x10002>; 291 numa-node-id = <0>; 297 reg = <0x10003>; 300 numa-node-id = <0>; 306 reg = <0x10100>; [all …]
|
/Linux-v6.1/crypto/ |
D | aes_generic.c | 67 0xa56363c6, 0x847c7cf8, 0x997777ee, 0x8d7b7bf6, 68 0x0df2f2ff, 0xbd6b6bd6, 0xb16f6fde, 0x54c5c591, 69 0x50303060, 0x03010102, 0xa96767ce, 0x7d2b2b56, 70 0x19fefee7, 0x62d7d7b5, 0xe6abab4d, 0x9a7676ec, 71 0x45caca8f, 0x9d82821f, 0x40c9c989, 0x877d7dfa, 72 0x15fafaef, 0xeb5959b2, 0xc947478e, 0x0bf0f0fb, 73 0xecadad41, 0x67d4d4b3, 0xfda2a25f, 0xeaafaf45, 74 0xbf9c9c23, 0xf7a4a453, 0x967272e4, 0x5bc0c09b, 75 0xc2b7b775, 0x1cfdfde1, 0xae93933d, 0x6a26264c, 76 0x5a36366c, 0x413f3f7e, 0x02f7f7f5, 0x4fcccc83, [all …]
|
/Linux-v6.1/drivers/net/ethernet/broadcom/bnx2x/ |
D | bnx2x_hsi.h | 17 #define FW_ENCODE_32BIT_PATTERN 0x1e1e1e1e 23 #define BNX2X_MAX_ISCSI_TRGT_CONN_MASK 0xFFFF 24 #define BNX2X_MAX_ISCSI_TRGT_CONN_SHIFT 0 25 #define BNX2X_MAX_ISCSI_INIT_CONN_MASK 0xFFFF0000 31 #define BNX2X_MAX_FCOE_TRGT_CONN_MASK 0xFFFF 32 #define BNX2X_MAX_FCOE_TRGT_CONN_SHIFT 0 33 #define BNX2X_MAX_FCOE_INIT_CONN_MASK 0xFFFF0000 42 #define PIN_CFG_NA 0x00000000 43 #define PIN_CFG_GPIO0_P0 0x00000001 44 #define PIN_CFG_GPIO1_P0 0x00000002 [all …]
|