1# SPDX-License-Identifier: GPL-2.0-only 2# 3# IP Virtual Server configuration 4# 5menuconfig IP_VS 6 tristate "IP virtual server support" 7 depends on NET && INET && NETFILTER 8 depends on (NF_CONNTRACK || NF_CONNTRACK=n) 9 help 10 IP Virtual Server support will let you build a high-performance 11 virtual server based on cluster of two or more real servers. This 12 option must be enabled for at least one of the clustered computers 13 that will take care of intercepting incoming connections to a 14 single IP address and scheduling them to real servers. 15 16 Three request dispatching techniques are implemented, they are 17 virtual server via NAT, virtual server via tunneling and virtual 18 server via direct routing. The several scheduling algorithms can 19 be used to choose which server the connection is directed to, 20 thus load balancing can be achieved among the servers. For more 21 information and its administration program, please visit the 22 following URL: <http://www.linuxvirtualserver.org/>. 23 24 If you want to compile it in kernel, say Y. To compile it as a 25 module, choose M here. If unsure, say N. 26 27if IP_VS 28 29config IP_VS_IPV6 30 bool "IPv6 support for IPVS" 31 depends on IPV6 = y || IP_VS = IPV6 32 select NF_DEFRAG_IPV6 33 help 34 Add IPv6 support to IPVS. 35 36 Say Y if unsure. 37 38config IP_VS_DEBUG 39 bool "IP virtual server debugging" 40 help 41 Say Y here if you want to get additional messages useful in 42 debugging the IP virtual server code. You can change the debug 43 level in /proc/sys/net/ipv4/vs/debug_level 44 45config IP_VS_TAB_BITS 46 int "IPVS connection table size (the Nth power of 2)" 47 range 8 20 48 default 12 49 help 50 The IPVS connection hash table uses the chaining scheme to handle 51 hash collisions. Using a big IPVS connection hash table will greatly 52 reduce conflicts when there are hundreds of thousands of connections 53 in the hash table. 54 55 Note the table size must be power of 2. The table size will be the 56 value of 2 to the your input number power. The number to choose is 57 from 8 to 20, the default number is 12, which means the table size 58 is 4096. Don't input the number too small, otherwise you will lose 59 performance on it. You can adapt the table size yourself, according 60 to your virtual server application. It is good to set the table size 61 not far less than the number of connections per second multiplying 62 average lasting time of connection in the table. For example, your 63 virtual server gets 200 connections per second, the connection lasts 64 for 200 seconds in average in the connection table, the table size 65 should be not far less than 200x200, it is good to set the table 66 size 32768 (2**15). 67 68 Another note that each connection occupies 128 bytes effectively and 69 each hash entry uses 8 bytes, so you can estimate how much memory is 70 needed for your box. 71 72 You can overwrite this number setting conn_tab_bits module parameter 73 or by appending ip_vs.conn_tab_bits=? to the kernel command line 74 if IP VS was compiled built-in. 75 76comment "IPVS transport protocol load balancing support" 77 78config IP_VS_PROTO_TCP 79 bool "TCP load balancing support" 80 help 81 This option enables support for load balancing TCP transport 82 protocol. Say Y if unsure. 83 84config IP_VS_PROTO_UDP 85 bool "UDP load balancing support" 86 help 87 This option enables support for load balancing UDP transport 88 protocol. Say Y if unsure. 89 90config IP_VS_PROTO_AH_ESP 91 def_bool IP_VS_PROTO_ESP || IP_VS_PROTO_AH 92 93config IP_VS_PROTO_ESP 94 bool "ESP load balancing support" 95 help 96 This option enables support for load balancing ESP (Encapsulation 97 Security Payload) transport protocol. Say Y if unsure. 98 99config IP_VS_PROTO_AH 100 bool "AH load balancing support" 101 help 102 This option enables support for load balancing AH (Authentication 103 Header) transport protocol. Say Y if unsure. 104 105config IP_VS_PROTO_SCTP 106 bool "SCTP load balancing support" 107 select LIBCRC32C 108 help 109 This option enables support for load balancing SCTP transport 110 protocol. Say Y if unsure. 111 112comment "IPVS scheduler" 113 114config IP_VS_RR 115 tristate "round-robin scheduling" 116 help 117 The robin-robin scheduling algorithm simply directs network 118 connections to different real servers in a round-robin manner. 119 120 If you want to compile it in kernel, say Y. To compile it as a 121 module, choose M here. If unsure, say N. 122 123config IP_VS_WRR 124 tristate "weighted round-robin scheduling" 125 help 126 The weighted robin-robin scheduling algorithm directs network 127 connections to different real servers based on server weights 128 in a round-robin manner. Servers with higher weights receive 129 new connections first than those with less weights, and servers 130 with higher weights get more connections than those with less 131 weights and servers with equal weights get equal connections. 132 133 If you want to compile it in kernel, say Y. To compile it as a 134 module, choose M here. If unsure, say N. 135 136config IP_VS_LC 137 tristate "least-connection scheduling" 138 help 139 The least-connection scheduling algorithm directs network 140 connections to the server with the least number of active 141 connections. 142 143 If you want to compile it in kernel, say Y. To compile it as a 144 module, choose M here. If unsure, say N. 145 146config IP_VS_WLC 147 tristate "weighted least-connection scheduling" 148 help 149 The weighted least-connection scheduling algorithm directs network 150 connections to the server with the least active connections 151 normalized by the server weight. 152 153 If you want to compile it in kernel, say Y. To compile it as a 154 module, choose M here. If unsure, say N. 155 156config IP_VS_FO 157 tristate "weighted failover scheduling" 158 help 159 The weighted failover scheduling algorithm directs network 160 connections to the server with the highest weight that is 161 currently available. 162 163 If you want to compile it in kernel, say Y. To compile it as a 164 module, choose M here. If unsure, say N. 165 166config IP_VS_OVF 167 tristate "weighted overflow scheduling" 168 help 169 The weighted overflow scheduling algorithm directs network 170 connections to the server with the highest weight that is 171 currently available and overflows to the next when active 172 connections exceed the node's weight. 173 174 If you want to compile it in kernel, say Y. To compile it as a 175 module, choose M here. If unsure, say N. 176 177config IP_VS_LBLC 178 tristate "locality-based least-connection scheduling" 179 help 180 The locality-based least-connection scheduling algorithm is for 181 destination IP load balancing. It is usually used in cache cluster. 182 This algorithm usually directs packet destined for an IP address to 183 its server if the server is alive and under load. If the server is 184 overloaded (its active connection numbers is larger than its weight) 185 and there is a server in its half load, then allocate the weighted 186 least-connection server to this IP address. 187 188 If you want to compile it in kernel, say Y. To compile it as a 189 module, choose M here. If unsure, say N. 190 191config IP_VS_LBLCR 192 tristate "locality-based least-connection with replication scheduling" 193 help 194 The locality-based least-connection with replication scheduling 195 algorithm is also for destination IP load balancing. It is 196 usually used in cache cluster. It differs from the LBLC scheduling 197 as follows: the load balancer maintains mappings from a target 198 to a set of server nodes that can serve the target. Requests for 199 a target are assigned to the least-connection node in the target's 200 server set. If all the node in the server set are over loaded, 201 it picks up a least-connection node in the cluster and adds it 202 in the sever set for the target. If the server set has not been 203 modified for the specified time, the most loaded node is removed 204 from the server set, in order to avoid high degree of replication. 205 206 If you want to compile it in kernel, say Y. To compile it as a 207 module, choose M here. If unsure, say N. 208 209config IP_VS_DH 210 tristate "destination hashing scheduling" 211 help 212 The destination hashing scheduling algorithm assigns network 213 connections to the servers through looking up a statically assigned 214 hash table by their destination IP addresses. 215 216 If you want to compile it in kernel, say Y. To compile it as a 217 module, choose M here. If unsure, say N. 218 219config IP_VS_SH 220 tristate "source hashing scheduling" 221 help 222 The source hashing scheduling algorithm assigns network 223 connections to the servers through looking up a statically assigned 224 hash table by their source IP addresses. 225 226 If you want to compile it in kernel, say Y. To compile it as a 227 module, choose M here. If unsure, say N. 228 229config IP_VS_MH 230 tristate "maglev hashing scheduling" 231 help 232 The maglev consistent hashing scheduling algorithm provides the 233 Google's Maglev hashing algorithm as a IPVS scheduler. It assigns 234 network connections to the servers through looking up a statically 235 assigned special hash table called the lookup table. Maglev hashing 236 is to assign a preference list of all the lookup table positions 237 to each destination. 238 239 Through this operation, The maglev hashing gives an almost equal 240 share of the lookup table to each of the destinations and provides 241 minimal disruption by using the lookup table. When the set of 242 destinations changes, a connection will likely be sent to the same 243 destination as it was before. 244 245 If you want to compile it in kernel, say Y. To compile it as a 246 module, choose M here. If unsure, say N. 247 248config IP_VS_SED 249 tristate "shortest expected delay scheduling" 250 help 251 The shortest expected delay scheduling algorithm assigns network 252 connections to the server with the shortest expected delay. The 253 expected delay that the job will experience is (Ci + 1) / Ui if 254 sent to the ith server, in which Ci is the number of connections 255 on the ith server and Ui is the fixed service rate (weight) 256 of the ith server. 257 258 If you want to compile it in kernel, say Y. To compile it as a 259 module, choose M here. If unsure, say N. 260 261config IP_VS_NQ 262 tristate "never queue scheduling" 263 help 264 The never queue scheduling algorithm adopts a two-speed model. 265 When there is an idle server available, the job will be sent to 266 the idle server, instead of waiting for a fast one. When there 267 is no idle server available, the job will be sent to the server 268 that minimize its expected delay (The Shortest Expected Delay 269 scheduling algorithm). 270 271 If you want to compile it in kernel, say Y. To compile it as a 272 module, choose M here. If unsure, say N. 273 274comment 'IPVS SH scheduler' 275 276config IP_VS_SH_TAB_BITS 277 int "IPVS source hashing table size (the Nth power of 2)" 278 range 4 20 279 default 8 280 help 281 The source hashing scheduler maps source IPs to destinations 282 stored in a hash table. This table is tiled by each destination 283 until all slots in the table are filled. When using weights to 284 allow destinations to receive more connections, the table is 285 tiled an amount proportional to the weights specified. The table 286 needs to be large enough to effectively fit all the destinations 287 multiplied by their respective weights. 288 289comment 'IPVS MH scheduler' 290 291config IP_VS_MH_TAB_INDEX 292 int "IPVS maglev hashing table index of size (the prime numbers)" 293 range 8 17 294 default 12 295 help 296 The maglev hashing scheduler maps source IPs to destinations 297 stored in a hash table. This table is assigned by a preference 298 list of the positions to each destination until all slots in 299 the table are filled. The index determines the prime for size of 300 the table as 251, 509, 1021, 2039, 4093, 8191, 16381, 32749, 301 65521 or 131071. When using weights to allow destinations to 302 receive more connections, the table is assigned an amount 303 proportional to the weights specified. The table needs to be large 304 enough to effectively fit all the destinations multiplied by their 305 respective weights. 306 307comment 'IPVS application helper' 308 309config IP_VS_FTP 310 tristate "FTP protocol helper" 311 depends on IP_VS_PROTO_TCP && NF_CONNTRACK && NF_NAT && \ 312 NF_CONNTRACK_FTP 313 select IP_VS_NFCT 314 help 315 FTP is a protocol that transfers IP address and/or port number in 316 the payload. In the virtual server via Network Address Translation, 317 the IP address and port number of real servers cannot be sent to 318 clients in ftp connections directly, so FTP protocol helper is 319 required for tracking the connection and mangling it back to that of 320 virtual service. 321 322 If you want to compile it in kernel, say Y. To compile it as a 323 module, choose M here. If unsure, say N. 324 325config IP_VS_NFCT 326 bool "Netfilter connection tracking" 327 depends on NF_CONNTRACK 328 help 329 The Netfilter connection tracking support allows the IPVS 330 connection state to be exported to the Netfilter framework 331 for filtering purposes. 332 333config IP_VS_PE_SIP 334 tristate "SIP persistence engine" 335 depends on IP_VS_PROTO_UDP 336 depends on NF_CONNTRACK_SIP 337 help 338 Allow persistence based on the SIP Call-ID 339 340endif # IP_VS 341
