Lines Matching full:resistance

350 	int resistance;	/* internal resistance percent */  member
355 int ri_uohm; /* Internal resistance in microohm */
502 * @factory_internal_resistance_uohm: the internal resistance of the battery
503 * at fabrication time, expressed in microohms. This resistance will vary
505 * nominal ballpark figure. This internal resistance is given for the state
507 * @factory_internal_resistance_charging_uohm: the internal resistance of the
509 * The charging process will affect the internal resistance of the battery
510 * so this value provides a better resistance under these circumstances.
511 * This resistance will vary depending on the lifetime and charge of the
542 * expected internal resistance at this temperature. The resistance is given
544 * resistance of the battery is usually necessary for calculating the open
547 * by temperature: highest temperature with lowest resistance first, lowest
548 * temperature with highest resistance last.
551 * to internal resistance (Ri). The resistance is given in microohm for the
552 * corresponding voltage in microvolts. The internal resistance is used to
554 * of the battery. These voltages to resistance tables apply when the battery
561 * internal resistance characteristics so a separate table is needed.*
565 * @bti_resistance_ohm: The Battery Type Indicator (BIT) nominal resistance
569 * @bti_resistance_tolerance: The tolerance in percent of the BTI resistance,
571 * tolerance is 10% we will detect a proper battery if the BTI resistance
677 * with an ideal voltage source (V) in series with an internal resistance (Ri)
692 * If we disconnect the load (here simplified as a fixed resistance Rload)
713 * resistance change, and it will affect the VBAT under load, so correlating
821 int resistance);