Lines Matching +full:led +full:- +full:speed +full:- +full:mode

1 # SPDX-License-Identifier: GPL-2.0-only
32 	bool "Support LED triggers for tracking link state"
35 	  Adds support for a set of LED trigger events per-PHY.  Link
37 	  LED class driver.  There are triggers for each link speed currently
39 	  logical-or of all the link speed ones.
41 	      <mii bus id>:<phy>:<speed>
43 	  Where speed is in the form:
44 		<Speed in megabits>Mbps OR <Speed in gigabits>Gbps OR link
45 		for any speed known to the PHY.
51 	  When LED class support is enabled, phylib can automatically
52 	  probe LED setting from device tree.
55 	tristate "MDIO Bus/PHY emulation with fixed speed/link PHYs"
61 	  Currently tested with mpc866ads and mpc8349e-mitx.
88 	  - ADIN1200 - Robust,Industrial, Low Power 10/100 Ethernet PHY
89 	  - ADIN1300 - Robust,Industrial, Low Latency 10/100/1000 Gigabit
97 	  - ADIN1100 - Robust,Industrial, Low Power 10BASE-T1L Ethernet PHY
107 	  Currently supports the Asix Electronics PHY found in the X-Surf 100
223 	  Support for the Marvell 88Q2XXX 100/1000BASE-T1 Automotive Ethernet
229 	  Support for the Marvell 88X2222 Dual-port Multi-speed Ethernet
250 	  Supports MediaTek SoC built-in Gigabit Ethernet PHYs.
252 	  Include support for built-in Ethernet PHYs which are present in
255 	  (common-mode voltage) during startup.
264 	tristate "Microchip 10BASE-T1S Ethernet PHYs"
299 	tristate "NXP 100BASE-TX PHYs"
301 	  Support the 100BASE-TX PHY integrated on the SJA1110 automotive
318 	tristate "Onsemi 10BASE-T1S Ethernet PHY"
320 	  Adds support for the onsemi 10BASE-T1S Ethernet PHY.
321 	  Currently supports the NCN26000 10BASE-T1S Industrial PHY
395 	tristate "Texas Instruments DP83TD510 Ethernet 10Base-T1L PHY"
397 	  Support for the DP83TD510 Ethernet 10Base-T1L PHY. This PHY supports
415 	tristate "Micrel KS8995MA 5-ports 10/100 managed Ethernet switch"