Lines Matching +full:flash +full:- +full:leds

1 # SPDX-License-Identifier: GPL-2.0-only
6 	  This option enables trigger support for the leds class.
7 	  These triggers allow kernel events to drive the LEDs and can
15 	  This allows LEDs to be controlled by a programmable timer
18 	  For more details read Documentation/leds/leds-class.rst.
23 	tristate "LED One-shot Trigger"
25 	  This allows LEDs to blink in one-shot pulses with parameters
39 	  This allows LEDs to be controlled by disk activity.
46 	  This allows LEDs to be controlled by MTD activity.
52 	  This allows LEDs to be controlled by a CPU load average.
53 	  The flash frequency is a hyperbolic function of the 1-minute
60 	  This allows LEDs to be controlled as a backlight device: they
69 	  This allows LEDs to be controlled by active CPUs. This shows
70 	  the active CPUs across an array of LEDs so you can see which
78 	  This allows LEDs to be controlled by an immediate CPU usage.
79 	  The flash frequency and duty cycle varies from faint flashes to
88 	  This allows LEDs to be controlled by gpio events. It's good
89 	  when using gpios as switches and triggering the needed LEDs
90 	  from there. One use case is n810's keypad LEDs that could
99 	  This allows LEDs to be initialised in the ON state.
113 	tristate "LED Camera Flash/Torch Trigger"
115 	  This allows LEDs to be controlled as a camera flash/torch device.
116 	  This enables direct flash/torch on/off by the driver, kernel space.
122 	  This allows LEDs to be configured to blink on a kernel panic.
123 	  Enabling this option will allow to mark certain LEDs as panic indicators,
132 	  This allows LEDs to be controlled by network device activity.
138 	  This allows LEDs to be controlled by a software or hardware pattern
145 	  This allows LEDs to be controlled by audio drivers for following
146 	  the audio mute and mic-mute changes.
153 	  This allows LEDs to be controlled by activity on ttys which includes
156 	  When build as a module this driver will be called ledtrig-tty.