86 	 * fully operational, but have the danger of duplicate addresses  in btintel_check_bdaddr()
587 			/* If image type is Operational firmware (0x03), then  in btintel_parse_version_tlv()
599 			/* If image type is Operational firmware (0x03), then  in btintel_parse_version_tlv()
1124 	 * mode or is running operational firmware. The value 0x06 identifies  in btintel_download_firmware()
1125 	 * the bootloader and the value 0x23 identifies the operational  in btintel_download_firmware()
1129 	 * to bootloader when operational so the new firmware can be loaded.  in btintel_download_firmware()
1163 	 * mode or is running operational firmware. The value 0x01 identifies  in btintel_download_fw_tlv()
1164 	 * the bootloader and the value 0x03 identifies the operational  in btintel_download_fw_tlv()
1168 	 * to bootloader when operational so the new firmware can be loaded.  in btintel_download_fw_tlv()
1910 	 * is done by the operational firmware sending bootup notification.  in btintel_boot()
1912 	 * Booting into operational firmware should not take longer than  in btintel_boot()
1967 	 * mode or is running operational firmware. The value 0x06 identifies  in btintel_download_fw()
1968 	 * the bootloader and the value 0x23 identifies the operational  in btintel_download_fw()
1971 	 * When the operational firmware is already present, then only  in btintel_download_fw()
2014 	 * also be no valid address for the operational firmware.  in btintel_download_fw()
2098 	/* Before switching the device into operational mode and with that  in btintel_download_fw()
2141 	/* controller is already having an operational firmware */  in btintel_bootloader_setup()
2157 		/* Once the device is running in operational mode, it needs to  in btintel_bootloader_setup()
2216 	 * mode or is running operational firmware. The value 0x03 identifies  in btintel_prepare_fw_download_tlv()
2217 	 * the bootloader and the value 0x23 identifies the operational  in btintel_prepare_fw_download_tlv()
2220 	 * When the operational firmware is already present, then only  in btintel_prepare_fw_download_tlv()
2290 	/* Before switching the device into operational mode and with that  in btintel_prepare_fw_download_tlv()
2597 	/* check if controller is already having an operational firmware */  in btintel_bootloader_setup_tlv()
2608 	/* Once the device is running in operational mode, it needs to  in btintel_bootloader_setup_tlv()
2809 	 * to bootloader mode and are not populated in operational mode  in btintel_setup_combined()
2839 		 * the operational firmware supports both old and TLV based  in btintel_setup_combined()
3007 				/* When switching to the operational firmware  in btintel_recv_event()