Lines Matching +refs:rate +refs:get +refs:reply

73 	Controls the fwmark of kernel-generated IPv4 reply packets that are not
474 	Limit the maximal rate for sending duplicate acknowledgments
489 	Using 0 disables rate-limiting of dupacks in response to
778 	against legal connection rate. If you see SYN flood warnings
856 	get detected right after Fastopen is re-enabled and will reset to
904 	depending on flow rate, instead of filling 64Kbytes packets.
936 	to current rate. (current_rate = cwnd * mss / srtt)
945 	to current rate. (current_rate = cwnd * mss / srtt)
1070 	Note that this per netns rate limit can allow some side channel
1464 	.. [1] These are rate limited by default (see default mask above)
1530 	- 1 - Enforce to use IGMP version 1. Will also reply IGMPv1 report if
1533 	  IGMPv1 query message. Will reply report if receive IGMPv3 query.
1629 	will be chosen, setting to zero means reply with no delay.
1779 	  with the hope we will receive reply for our request and
1792 	- 0 - (default): reply for any local target IP address, configured
1794 	- 1 - reply only if the target IP address is local address
1796 	- 2 - reply only if the target IP address is local address
1799 	- 3 - do not reply for local addresses configured with scope host,
1802 	- 8 - do not reply for all local addresses
2006 	- 4: enabled for ICMPv6 echo reply messages.
2052 	echo reply
2216 	Controls the fwmark of kernel-generated IPv6 reply packets that are not
2737 	and echo reply is 129.
2739 	Default: 0-1,3-127 (rate limit ICMPv6 errors except Packet Too Big)
2868 	trying to get a SCTP_PF-state transport info via SCTP_GET_PEER_ADDR_INFO
3131 	must be started. On the server, it would get the encap_port from