Lines Matching full:note
28 This driver supports XDP (Express Data Path) and AF_XDP zero-copy. Note that
97 NOTE: The rx_bytes value of ethtool does not match the rx_bytes value of
113 NOTE: This setting is not saved across reboots.
129 NOTE: Your distribution should likely have provided the latest DDP file, but if
186 NOTE: The presence of a device-specific DDP package file overrides the loading
198 NOTE: This driver supports the following flow types:
214 NOTE: This driver allows you to filter traffic based on a user-defined flexible
229 NOTE: When you disable ntuple filters, all the user programmed filters are
248 NOTE: These filters use inverted masks.
251 NOTE: These filters use inverted masks.
345 Note that ICMP headers are parsed as 4 bytes of header and 4 bytes of payload.
347 the offset. Also note that ip4 filters match both ICMP frames as well as raw
445 NOTE: This command will disable ntuple filters and clear any aRFS filters in
481 Note: You cannot use SR-IOV when link aggregation (LAG)/bonding is active, and
491 NOTE: The output of this command can be very large due to the maximum number of
525 Note: If the command does not work, it may not be supported by your system.
540 NOTE: Assigning a MAC address for a VF from the host will disable any
556 NOTE: It's important to set the VF to trusted before setting promiscuous mode.
574 NOTE: By default, the ethtool private flag vf-true-promisc-support is set to
583 get when you enable promiscuous mode using the ip link commands above. Note
593 Note that the order in which you set the VF to promiscuous mode and add the
624 NOTE: This feature can be disabled for a specific VF::
647 NOTE: The maximum MTU setting for jumbo frames is 9702. This corresponds to the
650 NOTE: This driver will attempt to use multiple page sized buffers to receive
654 NOTE: Packet loss may have a greater impact on throughput when you use jumbo
694 NOTE: The kernel assumes that TC0 is available, and will disable Priority Flow
725 NOTE:
757 NOTE: You must enable the UEFI HII "LLDP Agent" attribute for this setting to
770 NOTE: You must have a flow control capable link partner.
780 Note: This command only enables or disables Flow Control if auto-negotiation is
784 Note: Flow Control auto-negotiation is part of link auto-negotiation. Depending
787 NOTE:
814 NOTE:
878 NOTE: