15 - Speed and Duplex Configuration
40 	For more information about the AutoNeg, Duplex, and Speed
41         parameters, see the "Speed and Duplex Configuration" section in
57 This parameter is a bit-mask that specifies the speed and duplex settings
59 Duplex parameters must not be specified.
62        Refer to the Speed and Duplex section of this readme for more
65 Duplex  section in Command Line Parameters
74 either one or two-directional.  If both Duplex and the link partner are
75 set to auto-negotiate, the board auto-detects the correct duplex.  If the
76 link partner is forced (either full or half), Duplex defaults to half-
77 duplex.
254 speed.  Duplex should also be set when Speed is set to either 10 or 100.
335 Speed and Duplex Configuration
338 Three keywords are used to control the speed and duplex configuration.
339 These keywords are Speed, Duplex, and AutoNeg.
342 fiber interface board only links at 1000 Mbps full-duplex.
347   supported speed and duplex combinations, and it links at the highest
348   common speed and duplex mode IF the link partner is set to auto-negotiate.
353 - If Speed = 10 or 100, then both Speed and Duplex should be set.  Auto-
359 speed and duplex combinations are advertised during the auto-negotiation
370 Duplex                       Full            Full   Half   Full    Half
385 Note that when this parameter is used, Speed and Duplex must not be specified.
387 If the link partner is forced to a specific speed and duplex, then this
388 parameter should not be used.  Instead, use the Speed and Duplex parameters
389 previously mentioned to force the adapter to the same speed and duplex.