Lines Matching +full:high +full:- +full:speed +full:- +full:mode

44 -----------
57 The Fintek F71806F/FG Super-I/O chip is essentially the same as the
65 ------------------
67 Voltages are sampled by an 8-bit ADC with a LSB of 8 mV. The supported
84 in1     VIN1    VTT1.2V      10K       -        1.00    1.20 V
89 in6     VIN6    VCC1.5V      10K       -        1.00    1.50 V
90 in7     VIN7    VCORE        10K       -        1.00   ~1.40 V [1]_
106 Each voltage measured has associated low and high limits, each of which
111 --------------
113 Fan rotation speeds are reported as 12-bit values from a gated clock
115 high limit, but values over 6000 RPM seem to cause problem. The effective
119 The chip assumes 2 pulse-per-revolution fans.
121 An alarm is triggered if the rotation speed drops below a programmable
126 ----------------------
129 has a high limit, those crossing triggers an alarm. There is an associated
135 or a thermistor. The driver reports the currently selected mode, but
141 -----------
143 Both PWM (pulse-width modulation) and DC fan speed control methods are
152 control, but may generate annoying high-pitch noise. So a frequency just
162 Three different fan control modes are supported; the mode number is written
165 * 1: Manual mode
169 * 2: Temperature mode
170   You define 3 temperature/fan speed trip points using the
172   relationship between temperature and fan speed with two additional points
176 * 3: Fan speed mode
177   You ask for a specific fan speed by writing to the fan<n>_target file.
180 fan2 and pwm3 to fan3. Temperature mode also requires that temp1 corresponds