Lines Matching refs:IDE
2 Amiga Buddha and Catweasel IDE Driver
5 The Amiga Buddha and Catweasel IDE Driver (part of ide.c) was written by
10 Register map of the Buddha IDE controller and the
48 $800-$8ff IDE-Select 0 (Port 0, Register set 0)
50 $900-$9ff IDE-Select 1 (Port 0, Register set 1)
52 $a00-$aff IDE-Select 2 (Port 1, Register set 0)
54 $b00-$bff IDE-Select 3 (Port 1, Register set 1)
56 $c00-$cff IDE-Select 4 (Port 2, Register set 0,
59 $d00-$dff IDE-Select 5 (Port 3, Register set 1,
67 level of the IRQ-line of IDE port 0.
72 level of the IRQ-line of IDE port 1.
77 level of the IRQ-line of IDE port 2.
84 IDE ports to the Zorro bus. This mechanism
103 The IDE ports issue an INT2. You can read the level of the
104 IRQ-lines of the IDE-ports by reading from the three (two
112 The IDE ports are fed by the address lines A2 to A4, just as
113 the Amiga 1200 and Amiga 4000 IDE ports are. This way
115 polls two words out of the same address of IDE port since
121 If you're using the mirrored registers of the IDE-ports with
148 (same timing as the Amiga 1200 does on it's IDE port without
172 When accessing IDE registers with A6=1 (for example $84x),
200 connected to the third IDE-port. The IRQ-register $f80
202 the third IDE port are going into data's Nirwana on the