Lines Matching +full:keep +full:- +full:power +full:- +full:in +full:- +full:suspend

1 /* SPDX-License-Identifier: GPL-2.0-only */
3  * machine.h -- SoC Regulator support, machine/board driver API.
16 #include <linux/suspend.h>
43  * operations in suspend mode
44  * DO_NOTHING_IN_SUSPEND - the default value
45  * DISABLE_IN_SUSPEND	- turn off regulator in suspend states
46  * ENABLE_IN_SUSPEND	- keep regulator on in suspend states
60  * struct regulator_state - regulator state during low power system states
62  * This describes a regulators state during a system wide low power
66  * @uV: Default operating voltage during suspend, it can be adjusted
68  * @min_uV: Minimum suspend voltage may be set.
69  * @max_uV: Maximum suspend voltage may be set.
70  * @mode: Operating mode during suspend.
71  * @enabled: operations during suspend.
72  *	     - DO_NOTHING_IN_SUSPEND
73  *	     - DISABLE_IN_SUSPEND
74  *	     - ENABLE_IN_SUSPEND
86 #define REGULATOR_NOTIF_LIMIT_DISABLE -1
87 #define REGULATOR_NOTIF_LIMIT_ENABLE -2
95  * struct regulation_constraints - regulator operating constraints.
117  * @max_uV_step: Max possible step change in voltage
139  * @state_disk: State for regulator when system is suspended in disk mode.
140  * @state_mem: State for regulator when system is suspended in mem mode.
141  * @state_standby: State for regulator when system is suspended in standby
143  * @initial_state: Suspend state to set by default.
147  *		   change is non-linear (unit: microseconds).
149  *		      change is non-linear (unit: microseconds).
151  *			 voltage change is non-linear (unit: microseconds).
155  * @enable_time: Turn-on time of the rails (unit: microseconds)
161 	/* voltage output range (inclusive) - for voltage control */
167 	/* current output range (inclusive) - for current control */
177 	/* used for changing voltage in steps */
186 	/* regulator input voltage - only if supply is another regulator */
189 	/* regulator suspend states for global PMIC STANDBY/HIBERNATE */
197 	suspend_state_t initial_state; /* suspend state to set at init */
225  * struct regulator_consumer_supply - supply -> device mapping
235 	const char *supply;	/* consumer supply - e.g. "vcc" */
246  * struct regulator_init_data - regulator platform initialisation data.
251  *                    as it appears in the name field in sysfs, which can