Lines Matching +full:settle +full:- +full:time +full:- +full:us

1 /* SPDX-License-Identifier: GPL-2.0-only */
3  * driver.h -- SoC Regulator driver support.
62  * struct regulator_ops - regulator operations.
75  *                   return -ENOTRECOVERABLE if regulator can't be read at
78  *                   regulator; return -ENOTRECOVERABLE if regulator can't
85  * @set_current_limit: Configure a limit for a current-limited regulator.
87  * @get_current_limit: Get the configured limit for a current-limited regulator.
94  *	- REGULATOR_SEVERITY_PROT should automatically shut down the regulator(s).
96  *	- REGULATOR_SEVERITY_ERR should indicate that over-current situation is
100  *	- REGULATOR_SEVERITY_WARN should indicate situation where hardware is
121  * @get_status: Return actual (not as-configured) status of regulator, as a
130  * @enable_time: Time taken for the regulator voltage output voltage to
134  * @set_voltage_time: Time taken for the regulator voltage output voltage
138  * @set_voltage_time_sel: Time taken for the regulator voltage output voltage
200 	/* Time taken to enable or set voltage on the regulator */
255  * struct regulator_desc - Static regulator descriptor
259  * structure contains the non-varying parts of the regulator
292  * @ramp_delay: Time to settle down after voltage change (unit: uV/us)
311  *	       voltage up/down gradually each time increasing/decreasing the
346  * @ramp_reg:		Register for controlling the regulator ramp-rate.
347  * @ramp_mask:		Bitmask for the ramp-rate control register.
348  * @ramp_delay_table:	Table for mapping the regulator ramp-rate values. Values
349  *			should be given in units of V/S (uV/uS). See the
353  * @enable_time: Time taken for initial enable of regulator (in uS).
354  * @off_on_delay: guard time (in uS), before re-enabling a regulator
356  * @poll_enabled_time: The polling interval (in uS) to use while checking that
437  * struct regulator_config - Dynamic regulator descriptor
463  * struct regulator_err_state - regulator error/notification status
478  * struct regulator_irq_data - regulator error/notification status data
502  * struct regulator_irq_desc - notification sender for IRQ based events.
506  *		best to shut-down regulator(s) or reboot the SOC if error
512  * @reread_ms:	The time which is waited before attempting to re-read status
513  *		at the worker if IC reading fails. Immediate re-read is done
514  *		if time is not specified.
515  * @irq_off_ms:	The time which IRQ is kept disabled before re-evaluating the
539  *		fatal_cnt times the core will call die() callback or power-off
542  *		re-enabling IRQ. If implemented this should clear the error
545  *		assumed to be cleared and IRQ is re-enabled.
549  *		callback or if die() is not populated then attempt to power-off
552  *		and IRQ will be re-enabled. Returning REGULATOR_ERROR_ON
558  *		re-evaluated and re-sent.
648 	/* time when this regulator was disabled last time */